Effect of nordihydroguaiaretic acid on luteal phase length and oxytocin-induced release of prostaglandin F2 alpha in heifers

Two experiments were conducted to determine if intrauterine infusion of nordihydroguaiaretic acid, a lipoxygenase pathway inhibitor, would delay luteolysis (Experiment 1) and inhibit oxytocin-induced release of prostaglandin F2 alpha (as measured by the stable prostaglandin F2 alpha metabolite, 15-keto-13,14-dihydroprostaglandin F2 alpha) in plasma on d 16 (d 0 = estrus) of the estrous cycle (Experiment 2). Nordihydroguaiaretic acid (20 mg) or saline was infused twice daily into the uterus on d 14 to 23 (Experiment 1) or d 14 to 20 (Experiment 2) postestrus, respectively. In Experiment 1 and 2, mean concentration of progesterone was higher and luteolysis was delayed in nordihydroguaiaretic acid-infused heifers compared with saline-infused heifers. In Experiment 2, saline or oxytocin (100 IU, i.v.) was injected into each heifer on d 16 postestrus to stimulate the release of prostaglandin F2 alpha from the uterus. Mean concentration of 15-keto-13,14-dihydroprostaglandin F2 alpha increased within 1.5 h postinjection in heifers infused with saline, whereas concentration of 15-keto-13,14-dihydroprostaglandin F2 alpha in nordihydroguaiaretic acid-infused heifers did not increase within the same time period. Thus, nordihydroguaiaretic acid may inhibit both the lipoxygenase and cyclooxygenase pathways of arachidonic acid metabolism and therefore delay luteolysis.     

An ecological analysis of risk factors for postpartum disorders of Holstein-Friesian cows from thirty-two New York farms

Path analysis and multiple logistic-normal regression were used to model the interrelationships between stated herd management practices and herd 30-d postpartum incidence rates of dystocia, retained placenta, and clinical postpartum metritis, cystic ovary, milk fever, ketosis, left displaced abomasum, and mastitis. Management risk factors were obtained from a personal interview questionnaire. Data were from 2141 multiparous Holstein calvings from May 1981 through April 1982 in 32 commercial herds in the vicinity of Cornell University. Farms where the stated policy was to administer low calcium diets to the dry cows experienced more dystocia and retained placenta. More dystocia was experienced on farms where the stated policy was to administer extra vitamin D to dry cows, where dry cows were housed with the milking cows, or where calving occurred in maternity pens rather than stanchions. There was an increased likelihood of milk fever and left displaced abomasum on farms on which the stated policy was to lead feed. Farms where dairy farmers treated cases of retained placenta had more retained placenta than farms on which the treatment was done by the veterinarian. Farms reporting the practice of feeding the cows to increase their weight during the dry period had increased odds of ketosis.     

Digital video libraries and the Internet

Digital video libraries are positioned to be a major driving application for the Next Generation Internet Initiative. Likewise, the advancements in the communications infrastructure will be of great benefit to digital video libraries. This report investigates some of the recent technologies for handling video in digital video libraries and reviews the NGII's planned advancements in network communications technologies in order to examine their impact on deploying digital video libraries on the Internet     

一种适合VoIP电话应用的低成本PoE接口

本文介绍了Power Integrations(PI)开发的一种适用于电话上的以太网供电(PoE)分立接口电路,可帮助OEM厂商满足其设计和成本目标.     

1/f noise in large-area Hg<Subscript>1−x</Subscript>Cd<Subscript>x</Subscript>Te photodiodes

The 1/f noise in photovoltaic (PV) molecular-beam epitaxy (MBE)-grown Hg_1−xCd_xTe double-layer planar heterostructure (DLPH) large-area detectors is a critical noise component with the potential to limit sensitivity of the cross-track infrared sounder (CrIS) instrument. Therefore, an understanding of the origins and mechanisms of noise currents in these PV detectors is of great importance. Excess low-frequency noise has been measured on a number of 1000-μm-diameter active-area detectors of varying “quality” (i.e., having a wide range of I-V characteristics at 78 K). The 1/f noise was measured as a function of cut-off wavelength under illuminated conditions. For short-wave infrared (SWIR) detectors at 98 K, minimal 1/f noise was measured when the total current was dominated by diffusion with white noise spectral density in the mid-10⁻¹⁵A/Hz^1/2 range. For SWIR detectors dominated by other than diffusion current, the ratio, α, of the noise current in unit bandwidth i_n(f = 1 Hz, V_d = −60 mV, and Δf = 1 Hz) to dark current I_d(V_d = −60 mV) was α_SW-d = i_n/I_d ∼ 1 × 10⁻³. The SWIR detectors measured at 0 mV under illuminated conditions had median α_SW-P = i_n/I_ph ∼ 7 × 10⁻⁶. For mid-wave infrared (MWIR) detectors, α_MW-d = i_n/I_d ∼ 2 × 10⁻⁴, due to tunneling current contributions to the 1/f noise. Measurements on forty-nine 1000-μm-diameter MWIR detectors under illuminated conditions at 98 K and −60 mV bias resulted in α_MW-P = i_n/I_ph = 4.16 ± 1.69 × 10⁻⁶. A significant point to note is that the photo-induced noise spectra are nearly identical at 0 mV and 100 mV reverse bias, with a noise-current-to-photocurrent ratio, α_MW-P, in the mid 10⁻⁶ range. For long-wave infrared (LWIR) detectors measured at 78 K, the ratio, α_LW-d = i_n/I_d ∼ 6 × 10⁻⁶, for the best performers. The majority of the LWIR detectors exhibited α_LW-d on the order of 2 × 10⁻⁵. The photo-induced 1/f noise had α_LW-P = i_n/I_ph ∼ 5 × 10⁻⁶. The value of the noise-current-to-dark-current ratio, α appears to increase with increasing bandgap. It is not clear if this is due to different current mechanisms impacting 1/f noise performance. Measurements on detectors of different bandgaps are needed at temperatures where diffusion current is the dominant current. Excess low-frequency noise measurements made as a function of detector reverse bias indicate 1/f noise may result primarily from the dominant current mechanism at each particular bias. The 1/f noise was not a direct function of the applied bias.     

Far-infrared detector based on HgTe/HgCdTe superlattices

HgTe/Hg_0.05Cd_0.95Te superlattices (SLs) were grown on (112)B oriented Cd_0.96Zn_0.04 Te substrates using molecular beam epitaxy (MBE). The SLs, consisting of 100 periods of 80-Å-thick HgTe wells alternating with 77-Å-thick Hg_0.05Cd_0.95Te barriers, were designed to operate as detectors in the far-infrared (FIR) region. Infrared absorption spectroscopy, high-resolution transmission electron microscopy (TEM), Hall effect measurements, and x-ray diffraction were used to characterize the superlattice layers. A series of annealing experiments were initiated to quantify the temperature-dependent interdiffusion of the HgTe wells and Hg_0.05Cd_0.95Te barriers and consequently their degradation, which shifts the absorption edges of the SLs to higher energies, since a high-temperature ex situ anneal is normally required in order to produce the p-type material required for a photovoltaic detector. Results from infrared absorption spectroscopy, TEM, and Hall effect measurements for the annealed samples are presented. A FIR SLs single-element photoconductive (PC) device was designed and fabricated. Both material characterization and device testing have established the applicability of the HgTe/Hg_0.05Cd_0.95Te SLs for the FIR region.     

Securing Mobile Ad hoc Networks — A Motivational Approach

Mobile ad hoc networks rely on the co-operation of devices that route for each other. This immediately presents security problems. Each device's data passes through the not so friendly hands of other devices. Forwarding devices must use their processing power and battery power to route packets for others. When bandwidth is limited they must also use bandwidth that they might want to use for themselves. These are not great issues with the first incarnations of ad hoc networks — military systems or others where all the devices are owned by a single organisation. However, if ad hoc networks are to be generally deployed and become an alternative or adjunct to future cellular systems, then ways to encourage co-operation are required. This revised version was published online in July 2006 with corrections to the Cover Date.     

A dynamical model for generating synthetic electrocardiogram signals

A dynamical model based on three coupled ordinary differential equations is introduced which is capable of generating realistic synthetic electrocardiogram (ECG) signals. The operator can specify the mean and standard deviation of the heart rate, the morphology of the PQRST cycle, and the power spectrum of the RR tachogram. In particular, both respiratory sinus arrhythmia at the high frequencies (HFs) and Mayer waves at the low frequencies (LFs) together with the LF/HF ratio are incorporated in the model. Much of the beat-to-beat variation in morphology and timing of the human ECG, including QT dispersion and R-peak amplitude modulation are shown to result. This model may be employed to assess biomedical signal processing techniques which are used to compute clinical statistics from the ECG.     

From theory to practice: an overview of MIMO space-time coded wireless systems

This paper presents an overview of progress in the area of multiple input multiple output (MIMO) space-time coded wireless systems. After some background on the research leading to the discovery of the enormous potential of MIMO wireless links, we highlight the different classes of techniques and algorithms proposed which attempt to realize the various benefits of MIMO including spatial multiplexing and space-time coding schemes. These algorithms are often derived and analyzed under ideal independent fading conditions. We present the state of the art in channel modeling and measurements, leading to a better understanding of actual MIMO gains. Finally, the paper addresses current questions regarding the integration of MIMO links in practical wireless systems and standards.     

A 1-Mbit MRAM based on 1T1MTJ bit cell integrated with copper interconnects

A low-power 1-Mb magnetoresistive random access memory (MRAM) based on a one-transistor and one-magnetic tunnel junction (1T1MTJ) bit cell is demonstrated. This is the largest MRAM memory demonstration to date. In this circuit, the magnetic tunnel junction (MTJ) elements are integrated with CMOS using copper interconnect technology. The copper interconnects are cladded with a high-permeability layer which is used to focus magnetic flux generated by current flowing through the lines toward the MTJ devices and reduce the power needed for programming. The 25-mm/sup 2/ 1-Mb MRAM circuit operates with address access times of less than 50 ns, consuming 24 mW at 3.0 V and 20 MHz. The 1-Mb MRAM circuit is fabricated in a 0.6-/spl mu/m CMOS process utilizing five layers of metal and two layers of poly.