Renal transport of urate during diuretic-induced hypouricemia

The effect of two weeks administration of a uricosuric diuretic (SKF-62698) on renal urate handling has been examined in 11 normal men. Plasma urate concentrations had declined by more than 60 per cent after two weeks. Urate excretion per unit of glomerular filtration rate and urate clearance (Curate) per unit of glomerular filtration rate were increased after the administration of SKF-62698. The importance of intact tubular secretion of urate in producing these changes was assessed by administering pyrazinamide, an agent that curtails urate secretion, to each participant. The decrements in urate excretion and clearance produced by pyrazinamide both increased significantly, whereas the residual urate excretion rates and clearances not suppressible by pyrazinamide were only minimally altered by SKF-62698 treatment. These results suggest that the excretion of secreted urate was enhanced by prolonged administration of SKF-62698, probably secondary to the inhibition of postsecretory urate reabsorption. In addition, because the nonsuppressible urate excretion did not decline despite a 63 per cent reduction in the plasma urate, it is likely that the reabsorption of filtered urate also was impaired by SKF-62698.     

Comparative investigation of the biocompatibility of various silicon nitride ceramic qualities in vitro

There is a controversy about the biocompatibility of silicon nitride ceramics contained in the literature, which appears to be related to a factor of the individual chemical composition of different qualities of silicon nitride ceramics and of the different surface properties. This study attempts to investigate the cytotoxicity of different qualities of industrial silicon nitride ceramics applying an L929-cell culture model in a direct contact assay combined with a cell viability assessment. Five different qualities of industrial standard silicon nitride ceramics were chosen for in vitro testing. The chemical composition was determined by EDS analysis. Different biomedically approved aluminium oxide qualities, a titanium alloy, glass and polyvinylchloride (PVC) served as control materials. L929 mice fibroblasts were incubated directly on the materials for 24 h, stained with bisbenzimide and propidium iodine for double fluorochromasia viability testing, and evaluated by inversion-fluorescence microscopy to control cell morphology, viability and cell counts compared to empty well values. Scanning electron microscopy was applied to additionally investigate cell morphology. There was no observation of cytotoxic effects on the silicon nitride ceramic samples; moreover cell morphology remained the same as on aluminium oxide and titanium. Viability testing revealed the presence of avital cells exclusively on PVC, which served as a negative control. Cell counts on all polished surfaces showed significantly higher numbers, whereas some rough surface samples showed significantly lower numbers. We conclude that silicon nitride ceramics show no cytotoxic effects and should be considered for biomedical application owing to its favourable physiochemical properties, especially its superior resistance to mechanical stress, which would be useful for compression loaded conditions. Polished surfaces would appear to promote advanced biocompatibility.     

High-power deuterium Raman laser at 632 nm

We demonstrate a continuous-wave deuterium Raman laser that generates more than 160 mW of Stokes output power despite severe thermal effects. This output power represents nearly an order-of-magnitude increase over any previously reported continuous-wave Raman laser and is the first such system to our knowledge that uses deuterium gas as the Raman medium. The high output power is achieved through careful consideration of the electronic feedback design, frequency actuators, and pump-laser intensity noise.     

Objective evaluation of the relative modulation transfer function of densitometers for digitisation of electron micrographs

Digitisation of images recorded on film is a crucial part of data acquisition in electron microscopy, particularly for electron cryo-microscopy of biological specimens where the contrast and signal-to-noise ratio are low. A quantitative method to evaluate and compare the quality of densitometers, as measured by the modulation transfer function (MTF), is described here. The densitometer is modelled as a linear system, the output being the convolution of the input image and a point spread function. The MTF is the magnitude of the Fourier transform of the point spread function. The relative MTF describes the quality of signal transfer with spatial frequency. It is important that fine structural details in the micrograph are digitised with a high value for the MTF which does not vary with direction. A test pattern has been generated by projecting an electron image of a grid pattern onto film. The film is scanned and a computer program measures the intensities of the diffraction orders of the repeating pattern. Three different scanners are compared, one is a point scanner and the other two are line scanners. The test can be used to check if a scanner is set up optimally, and how it compares with another scanner.     

Disambiguating Visual Motion by Form-Motion Interaction—a Computational Model

The neural mechanisms underlying motion segregation and integration still remain unclear to a large extent. Local motion estimates often are ambiguous in the lack of form features, such as corners or junctions. Furthermore, even in the presence of such features, local motion estimates may be wrong if they were generated near occlusions or from transparent objects. Here, a neural model of visual motion processing is presented that involves early stages of the cortical dorsal and ventral pathways. We investigate the computational mechanisms of V1-MT feedforward and feedback processing in the perception of coherent shape motion. In particular, we demonstrate how modulatory MT-V1 feedback helps to stabilize localized feature signals at, e.g. corners, and to disambiguate initial flow estimates that signal ambiguous movement due to the aperture problem for single shapes. In cluttered environments with multiple moving objects partial occlusions may occur which, in turn, generate erroneous motion signals at points of overlapping form. Intrinsic-extrinsic region boundaries are indicated by local T-junctions of possibly any orientation and spatial configuration. Such junctions generate strong localized feature tracking signals that inject erroneous motion directions into the integration process. We describe a simple local mechanism of excitatory form-motion interaction that modifies spurious motion cues at T-junctions. In concert with local competitive-cooperative mechanisms of the motion pathway the motion signals are subsequently segregated into coherent representations of moving shapes. Computer simulations demonstrate the competency of the proposed neural model.