Injuries to the phrenic nerve resulting in diaphragmatic paralysis with special reference to stretch trauma

The effectiveness of purines and purine analogues as inducers of erythroid differentiation in cultured murine erythroleukemia cells has been investigated. These cell lines have previously been shown to differentiate in vitro in response to dimethylsulfoxide (DMSO) and a number of other polar solvents. Two purine analogues, 6-thioguanine and 6-mercaptopurine, as well as the naturally occuring purine, purine, hypoxanthine, are shown to be extremely potent inducers. 6-Thioguanine is effective at a concentration of 0.06 mM, 750 fold lower than the DMSO concentration required for equivalent induction. 6-Mercaptopurine and hypoxanthine are effective inducers at a concentration of approximately 2 mM. Accumulation of globin mRNA was monitored during induction with purine inducers and shown to be similar in amount to globin mRNA levels reached in DMSO-induced cultures. Induction of differentiation by all three compounds follows a similar time course to induction with DMSO. All three compounds are potent inducers of HGPRT (hypoxanthine-guanine phosphoribosyltransferase)-negative cell lines; hence incorporation of purines into DNA is not required for induction of differentiation. Comparison of these compounds with other purines and purine analogues suggests a high degree of specificity in their interaction with a cellular target.     

Combining liquid chromatography with MALDI mass spectrometry using a heated droplet interface

A novel interfacing technology is described to combine solution-based separation techniques such as liquid chromatography (LC) with matrix-assisted laser desorption ionization (MALDI) mass spectrometry. The interface includes a transfer tube having an inlet and an outlet, the inlet being adapted to accept the LC effluents and the outlet being adapted to form continuously replaced, hanging droplets of the liquid stream, and a MALDI sample plate mounted below the outlet of the transfer tube for collecting the droplets. The liquid stream in the transfer tube is heated to a temperature sufficient to cause partial evaporation of the carrier solvent from the hanging droplets. The droplets are dislodged to the MALDI plate, which is heated to above the boiling point of the carrier solvent to cause further evaporation of the carrier solvent from the collected droplets. It is found that analytes can be fractionated and deposited to a sample spot of 0.8 mm in diameter when a liquid flow rate of up to 50 microL/min and a fractionation interval of 1 min/spot are used. Flow rate of up to 200 microL/min can be used with a deposition sample spot of 2.4 mm in diameter on a commercial MALDI target. This heated droplet interface does not introduce sample loss, and the detection sensitivity of LC/MALDI is similar to that of standard MALDI, i.e., low femtomoles for peptide analysis with a microliter sample deposition. It is compatible with microbore and narrow-bore column separation, thus allowing the injection of a larger amount of sample for separation and analysis, compared to a capillary column LC/MALDI system. The detection dynamic range is shown to be in the order of 10(6) for peptide mixture analysis, which is 4 orders of magnitude greater than standard MALDI. The application of this interface for combining LC with MALDI MS/MS is demonstrated in the proteome analysis of water-soluable protein components of E. coli K12 extracts.     

Calibration measurements and standards for radiation protection dosimetry

The safe use of ionising radiation for applications in medicine, electric power production and industrial processes requires accurate measurements that are traceable to national standards. Radiological calibration laboratories provide measurements that may be used to determine the calibration coefficients for personal dosemeters and survey meters. The wide range of ionising radiation applications results in the need for a wide range of reference radiation types and intensities to be available in the calibration laboratory. The methods used and the problems encountered while developing reference radiations are discussed.     

A specific sugar transport mechanism in smooth muscle and its regulation

The membrane transport of 3-O-methyl-D-glucose was studied in vitro in a smooth muscle, the detrusor of rat urinary bladder. Transport occurred by facilitated diffusion and showed the same chemical specificity and sensitivity to specific inhibitors as skeletal and cardiac muscle but its insulin sensitivity was smaller. Transport was increased by agents inhibiting the Na+pump and was decreased by agents which increased Na+ and K+ gradients by apparently stimulating the Na+pump. In accord with a rate limiting role of transport in glucose utilization, similar stimulating and inhibitory effects were seen when CO2 production from (14C) glucose was measured.     

Cyclophosphamide induced nail pigmentation

Cyclophosphamide therapy may occasionally cuase black pigmentation of the nails. We report five cases with this side effect and review the data on eleven cases in the literature. These changes start in the proximal nail beds and progress distally; on withdrawal of cyclophosphamide, clearing of the nail pigmentation proceeds in a similar fashion. The development of the nail pigmentation does not bear any relation to the primary condition for which cyclophosphamide was prescribed. The dose of the drug before the onset of pigmentation ranged from 1.2 to 12.3 g; the duration of treatment ranged from 10 days to 26 weeks. The mechanism of the nail pigmentation is unknown.     

Isolation and amino acid composition of sauvagine. An active polypeptide from methanol extracts of the skin of the South American frog Phyllomedusa sauvagei

The skin of the South American frog Phyllomedusa sauvagei contains a new active polypeptide, sauvagine, which does not belong to any of the peptide families hitherto described in the amphibian skin. The purification procedure involved several successive steps: dialysis, precipitation with ethanol and acetone, gel filtration and ion exchange chromatography. Two forms of sauvagine were separated. The major component (sauvagine I) was submitted to acid hydrolysis. The sauvagine molecule appeared to possess clear hydrophobic characteristics and to consist of a straight chain of 40 amino acid residues, among which the glutamyl-, aspartyl- leucyl- and isoleucyl-residues were particularly well represented. The elucidation of the amino acid sequence in the sauvagine molecule is in progress.     

FTMS structure elucidation of natural products: application to muraymycin antibiotics using ESI multi-CHEF SORI-CID FTMS(n), the top-down/bottom-up approach,and HPLC ESI capillary-skimmer CID FTMS

The molecular formulas for the structures and substructures of muraymycin antibiotics A1 (C52H90N14O19, MW 1214) and B1 (C49H83N11O18, MW 1113) were determined using electrospray ionization (ESI) Fourier transform mass spectrometry (FTMS). The muraymycin A1 and B1 structures were elucidated by utilizing capillary-skimmer fragmentation with up to five stages of mass spectrometry (MS5). Multi-CHEF, a multiple ion isolation method, was used at each stage of MS(n) to isolate a parent ion and up to four reference ions, for exact-mass calibration. The parent ions were fragmented by SORI-CID and the product ions internally calibrated with average absolute mass errors less than 1 ppm at each stage in the fragmentation processes. Using the top-down/bottom-up approach, the molecular formulas for the antibiotics were determined by summing the elemental formulas of the neutral losses, obtained by measuring the mass differences (<500 Da) between the genetically related sequential parent ion masses in the MS(n) spectra, with the unique elemental formula of the lowest parent ion mass (<500 Da). The structures of 12 additional compounds in the muraymycin complex were elucidated using HPLC ESI capillary-skimmer CID FTMS by correlating their fragmentation patterns with those of muraymycins A1 and B1. Sequential neutral losses of an aminosugar, a valine, a uridine, and an ester fatty acid from the muraymycin parent ions provided diagnostic fragments for characterization.