A 1 Gbit synchronous dynamic random access memory with anindependent subarray-controlled scheme and a hierarchical decodingscheme

A prototype 1 Gbit synchronous DRAM with independent subarray-controlled isolation and hierarchical decoding schemes is demonstrated to alleviate the difficulties encountered in high-density devices with regard to failure analysis and performance optimization. The scheme to isolate memory arrays from “hard” defects and to overcome the dc leakages of “soft” defects with external sources allows monitoring of the leakage current for the defect analysis and testing of the device without being limited by the capabilities of on-chip voltage sources. A hierarchical decoding scheme with a dynamic CMOS series logic predecoder achieves improvements in circuit speed, power, and complexity. As a result, evaluation of the prototype devices can be facilitated, and the optimized circuit schemes achieve enhanced circuit performance. A fully working 1 Gbit synchronous DRAM with a chip size of 570 mm² was fabricated using a 0.16 μm CMOS process and tested for excellent functionality up to 143 MHz     

Vertex-based inter-frame boundary encoding scheme

The boundary is approximated by a polygon which can be encoded with the smallest number of bits for maximum distortion. The temporal redundancy between two successive frames is efficiently removed with the proposed scheme, resulting in a lower bit rate than the conventional algorithms     

Polymer thermosetting organic light-emitting devices

We report a systematic study of novel single- and double-layer thermosetting light-emitting devices (LED's) based on triarytamines for hole transport layer and fluorenes for the emitting and electron transport layer. These devices possess high-thermal stability, high-quantum efficiency, and high-bandgap emission (blue and green). We have fabricated dot matrix displays based on analogs of these materials     

Electrophysicochemical characteristics of a waterpen point coronadischarge

Some interesting electrophysicochemical characteristics of waterpen point-to-plate discharges with DC and AC power have been investigated in a room atmosphere. The metal point electrode of a conventional point-to-plate air gap is severely bombarded by energetic ions from the discharge region near the point. Concurrently, the temperature of the point is greatly increased. There are different characteristics for the waterpen point discharge, because the surface temperature of the waterpen point stays low due to the evaporation of the moisture from the waterpen point. In this paper, the discharges and electrophysicochemical characteristics of a waterpen point and a Pt metal point have been studied to evaluate the differences. It was found that mists and sprays are dispersed from the waterpen point due to the bombardment of ions. Also, a positive corona is effective for mist dispersion, a negative corona disperses sprays, and AC corona disperses both mists and sprays. The AC discharge of the waterpen point generated more ozone of 56 ppm, while it was the negative DC discharge of the Pt point that produced more ozone of 30 ppm. The AC discharge of the waterpen point produced 0.11 ppm at 10 kV, and the Pt point produced 0.10 ppm at 15 kV. The DC discharge of the both points showed no NO formation     

Push-pull quantum series resonant rectifier without start-up inrushcurrent

A new combined buck and boost push-pull quantum series resonant rectifier (PPQSRR) is proposed to achieve a power factor correction without start-up inrush current. With the proposed control method and circuitry, a high power factor and wide range of output voltage without an inrush current can be obtained     

Covalently cross-linked sulfonated poly(ether ether ketone)/tungstophosphoric acid composite membranes for water electrolysis application

Composite polymer electrolyte membranes consisting of covalently cross-linked sulfonated polyether ether ketone (SPEEK) with tungstophosphoric acid (TPA) are prepared and their electrochemical and mechanical properties are investigated with regards to application in water electrolysis. Covalently cross-linked membranes (CL-SPEEK) comprised of sulfochlorinated SPEEK membranes and SPEEK partially lithiated by LiCl, are prepared by reaction with 1,4-diiodobutane, and blended with TPA to avoid excessive water swelling and to reinforce their mechanical properties. These ion-exchange membranes show good electrochemical properties, including proton conductivity, ion exchange capacity (IEC), thermal stability, anti-oxidative stability, and satisfactory mechanical characteristics, such as tensile strength and elongation. In particular, among the TPA-composite membranes, the CL-SPEEK/TPA30 (30 wt.% TPA) membrane displays higher proton conductivity (0.128 S cm⁻¹) and tensile strength (75.01 MPa) than Nafion^® 117 at 80 °C. The ion-exchange membranes are used to construct membrane electrode assemblies (MEAs) of use in polymer electrolyte membrane electrolysis (PEME). The MEA are prepared using a non-equilibrium impregnation–reduction (I–R) method. The electrochemical surface area (ESA) and roughness factor of the MEA prepared with CL-SPEEK/TPA30 electrolyte measured by cyclic voltammetry are 25.11 m² g⁻¹ and 321.4 cm² Pt cm⁻², respectively. The prepared MEAs are used in the water-electrolysis unit cells. The cell voltage is 1.78 V at 1 A cm⁻² and 80 °C, with a platinum loading of 1.28 mg cm⁻². The results of the present study suggest that the good conductivity and mechanical properties of covalently CL-SPEEK/TPA composite membranes make them well suited for use in PEME.     

Spatially adaptive high-resolution image reconstruction of DCT-based compressed images

The problem of recovering a high-resolution image from a sequence of low-resolution DCT-based compressed observations is considered in this paper. The introduction of compression complicates the recovery problem. We analyze the DCT quantization noise and propose to model it in the spatial domain as a colored Gaussian process. This allows us to estimate the quantization noise at low bit-rates without explicit knowledge of the original image frame, and we propose a method that simultaneously estimates the quantization noise along with the high-resolution data. We also incorporate a nonstationary image prior model to address blocking and ringing artifacts while still preserving edges. To facilitate the simultaneous estimate, we employ a regularization functional to determine the regularization parameter without any prior knowledge of the reconstruction procedure. The smoothing functional to be minimized is then formulated to have a global minimizer in spite of its nonlinearity by enforcing convergence and convexity requirements. Experiments illustrate the benefit of the proposed method when compared to traditional high-resolution image reconstruction methods. Quantitative and qualitative comparisons are provided.     

New Syndrome Check Error Estimation and Its Concatenated Coding

A low-complexity and high performance SCEE (Syndrome Check Error Estimation) decoding method for convolutional codes and its concatenated SCEE/RS (Reed–Solomon) coding scheme are proposed. First, we describe the operation of the decoding steps in the proposed algorithm. Then deterministic values on the decoding operation are derived when some combination of predecoder-reencoder is used. Computer simulation results show that the computational complexity of the proposed SCEE decoder is significantly reduced compared to that of conventional Viterbi decoder without degradation of the P_e performance. Also, simulation results of BER performance of the concatenated SCEE/Hard Decision Viterbi (HD-Viterbi) and SCEE/RS (Reed–Solomon) codes are presented.     

Wide‐Band Fine‐Resolution DCO with an Active Inductor and Three‐Step Coarse Tuning Loop

This paper presents a wide‐band fine‐resolution digitally controlled oscillator (DCO) with an active inductor using an automatic three‐step coarse and gain tuning loop. To control the frequency of the DCO, the transconductance of the active inductor is tuned digitally. To cover the wide tuning range, a three‐step coarse tuning scheme is used. In addition, the DCO gain needs to be calibrated digitally to compensate for gain variations. The DCO tuning range is 58% at 2.4 GHz, and the power consumption is 6.6 mW from a 1.2 V supply voltage. An effective frequency resolution is 0.14 kHz. The phase noise of the DCO output at 2.4 GHz is –120.67 dBc/Hz at 1 MHz offset.