Air flow through a non-airconditioned bus with open windows

Open window buses without air-conditioning are a major mode of urban and inter-city transport in most countries. High occupancy combined with hot and humid conditions makes travel in these buses quite uncomfortable. In this study air flow through a bus has been studied that could be the basis for low cost and eco-friendly methods of increasing passenger comfort and possibly reduce drag. The aerodynamics of such a road vehicle has not been studied as previous investigations have been confined to vehicles with closed windows that present a smooth exterior to air flow. Using a 1:25 scaled Perspex model of an urban bus in Delhi, flow visualization was performed in a water channel. The Reynolds numbers were one-tenth of a real bus moving at 10 m/s. Smoke and tuft visualizations were also performed on an urban bus at 40 km/h. Numerical simulations were performed at the actual Reynolds number. Even though there were Reynolds number differences, the broad features were similar. Air enters the bus from the rear windows, moves to the front (relative to the bus) and exits from the front windows. Inside air velocity relative to the bus is about one-tenth of the free-stream velocity. The flow is highly three-dimensional and unsteady.     

Local Structure and Valence State of Mn in Ga1−x Mn x N Epilayers

Mn has been incorporated in epilayers of the large-gap semiconductor GaN grown by molecular beam epitaxy using a nitrogen plasma cell. Detailed extended X-ray absorption fine structure (EXAFS) studies of a Ga_0.98Mn_0.02N epilayer confirm that the Mn atoms substitute the Ga atoms, with an increase by 2.7% of the distance to the nearest nitrogen atoms. Near-edge spectroscopy results tend to indicate that the valence state of Mn is slightly higher than 3+, while EXAFS analysis suggests an electron transfer to the N neighbors.     

Mechanical improvement of hydroxyapatite by TiO<Subscript><Emphasis Type="Italic">x</Emphasis></Subscript> nanoparticles deposition

Deposition of Ti was carried out by laser ablation onto hydroxyapatite porous discs in an Ar atmosphere. Ti nanoparticles were deposited onto HAp surface in order to modify its roughness and morphology as it is observed by scanning electron microscopy (SEM) and scanning probe microscopy (SPM). A homogeneous distribution of Ti over the disc surface was corroborated by elemental mapping. A comparison of the hydroxyapatite hardness before and after deposition was performed using SPM nanoindentation. Transmission Electron Microscopy (TEM) showed that the Ti nanoparticles obtained were covered by an oxygen shell. It is shown that surface modifications of the covered HAp by Ti result in better mechanical properties, reducing the possible damage to the HAp ceramic by friction or impacts as it often happens in meniscus, bone junctions and the inclusion of prosthesis for human treatments.     

Exploiting ILP, TLP, and DLP with the polymorphous trips architecture

The Tera-op reliable intelligently adaptive processing system (TRIPS) architecture seeks to deliver system-level configurability to applications and runtime systems. It does so by employing the concept of polymorphism, which permits the runtime system to configure the hardware execution resources to match the mode of execution and demands of the compiler and application.     

A microbubble-powered bioparticle actuator

We present the results of a device that uses controllable microbubble actuation to manipulate bioparticles. In order to create a useful device for controlling the position of bioparticles, predictable microfluidic actuation is crucial. The goal of this project was to develop fundamental technology that can be used to manipulate single bioparticles (e.g., cells). We use a thermal bubble actuation method to accomplish this goal. Microbubbles have the advantages of relatively simple electronics and fabrication but can be difficult to control. In this paper, we describe two specific accomplishments: the use of micromachined nucleation cavities to precisely localize thermal bubbles and to achieve controllable bubble formation temperatures and bubble dissipation and the demonstration of controllable microbubbles in a new device for particle sorting.