Noise characteristics of 3-D and 2-D PET images

The authors analyzed the noise characteristics of two-dimensional (2-D) and three-dimensional (3-D) images obtained from the GE Advance positron emission tomography (PET) scanner. Three phantoms were used: a uniform 20-cm phantom, a 3-D Hoffman brain phantom, and a chest phantom with heart and lung inserts. Using gated acquisition, the authors acquired 20 statistically equivalent scans of each phantom in 2-D and 3-D modes at several activity levels. From these data, they calculated pixel normalized standard deviations (NSD's), scaled to phantom mean, across the replicate scans, which allowed them to characterize the radial and axial distributions of pixel noise. The authors also performed sequential measurements of the phantoms in 2-D and 3-D modes to measure noise (from interpixel standard deviations) as a function of activity. To compensate for the difference in axial slice width between 2-D and 3-D images (due to the septa and reconstruction effects), they developed a smoothing kernel to apply to the 2-D data. After matching the resolution, the ratio of image-derived NSD values (NSD_2D/NSD_3D)² averaged throughout the uniform phantom was in good agreement with the noise equivalent count (NEC) ratio (NEC_3D/NEC_2D). By comparing different phantoms, the authors showed that the attenuation and emission distributions influence the spatial noise distribution. The estimates of pixel noise for 2-D and 3-D images produced here can be applied in the weighting of PET kinetic data and may be useful in the design of optimal dose and scanning requirements for PET studies. The accuracy of these phantom-based noise formulas should be validated for any given imaging situation, particularly in 3-D, if there is significant activity outside the scanner field of view     

A family of bicistronic vectors to enhance both local and systemic antitumor effects of HSVtk or cytokine expression in a murine melanoma model

The herpes simplex virus-thymidine kinase/ganciclovir (HSVtk/GCV) system produces both direct and immune-mediated tumor cell killing. Here, we compare the efficacy of HSVtk/GCV with cytokines, alone and in combination, on the tumorigenicity and immunogenicity of B16 cells. With respect to single gene modifications, only HSVtk/GCV, or high-level interleukin-2 (IL-2) secretion, completely prevented tumor growth, whereas granulocyte-macrophage colony-stimulating factor (GM-CSF) generated the best levels of long-term systemic protection. To augment both local killing and immune activation, we constructed bicistronic constructs that express HSVtk and a cytokine within the same cell. Co-expression of HSVtk with IL-2 or GM-CSF enhanced the local antitumor activity of any gene alone. In a tumor-prevention model, HSVtk killing, in an environment preprimed with GM-CSF, generated the best long-term immune protection. However, in a short-term therapy model, continued IL-2 expression was most effective against 3-day established tumors. This probably reflects differences in the activities of IL-2 and GM-CSF in generating short-term, nonspecific immune stimulation compared to long-term immunological memory, respectively. As a prelude to in vivo delivery experiments, we also demonstrated that these bicistronic cassettes can be packaged normally into retroviral (5 x 10(5) virus/ml from pooled populations) and adenoviral vectors (5 x 10(9) virus/ml) and function as predicted within virally infected cells. This family of bicistronic vectors can be used to stimulate synergy between suicide and cytokine genes, overcomes the problems of delivering two genes on separate vectors, and should allow easier preparation of vectors for the delivery of multiple genes to patients' tumor cells.     

AlGaAs vertical-cavity surface-emitting laser responses to 4.5-MeV proton irradiation

We have irradiated single- and multimode AlGaAs vertical-cavity surface-emitting laser (VCSEL) arrays operating at a nominal wavelength of 780 nm with 4.5-MeV protons and doses ranging from 10 to 30 Mrad in the active region. We observed a peak power reduction of about 2% per Mrad in the 14-/spl mu/m aperture, multimode VCSELs. Single-mode VCSELs having an aperture of 6 /spl mu/m exhibited a smaller peak power reduction of 0.4%-1% per Mrad. A slight shift in the current threshold was observed only for the multimode VCSELs at dose levels above 10 Mrad. First results indicate a reduced VCSEL peak laser power output that is dominated by a temperature shift caused by the radiation induced increase in resistive heating. In contrast, the power reduction in edge-emitting lasers is dominated by the enhanced radiation induced nonradiative recombination rate. The VCSEL irradiation was performed with a focused ion micro beam that was rastered over the device surface, ensuring a very uniform exposure of a single device in the array.     

Risk characterization of methyl tertiary butyl ether (MTBE) in tap water

Methyl tertiary butyl ether (MTBE) can enter surface water and groundwater through wet atmospheric deposition or as a result of fuel leaks and spills. About 30% of the U.S. population lives in areas where MTBE is in regular use. Ninety-five percent of this population is unlikely to be exposed to MTBE in tap water at concentrations exceeding 2 ppb, and most will be exposed to concentrations that are much lower and may be zero. About 5% of this population may be exposed to higher levels of MTBE in tap water, resulting from fuel tank leaks and spills into surface or groundwater used for potable water supplies. This paper describes the concentration ranges found and anticipated in surface and groundwater, and estimates the distribution of doses experienced by humans using water containing MTBE to drink, prepare food, and shower/bathe. The toxic properties (including potency) of MTBE when ingested, inhaled, and in contact with the skin are summarized. Using a range of human toxic potency values derived from animal studies, margins of exposure (MOE) associated with alternative chronic exposure scenarios are estimated to range from 1700 to 140,000. Maximum concentrations of MTBE in tap water anticipated not to cause adverse health effects are determined to range from 700 to 14,000 ppb. The results of this analysis demonstrate that no health risks are likely to be associated with chronic and subchronic human exposures to MTBE in tap water. Although some individuals may be exposed to very high concentrations of MTBE in tap water immediately following a localized spill, these exposures are likely to be brief in duration due to large-scale dilution and rapid volatilization of MTBE, the institution of emergency response and remediation measures to minimize human exposures, and the low taste and odor thresholds of MTBE which ensure that its presence in tap water is readily detected at concentrations well below the threshold for human injury.     

Relative occurrence of flow limitation and snoring during continuous positive airway pressure titration

OBJECTIVE: To distinguish between the existence of detached ciliary tufts (DCTs) and the possibility of protozoa in the sputum of asthma patients. STUDY DESIGN: One hundred six samples of sputum obtained from 97 patients hospitalized with either asthma or other respiratory diseases were examined blindly. The combination of such criteria as movement, absence of basal plate, existence of red granules, positivity for ultraviolet light and Heidenhain's iron hematoxylin stain (for protozoa) was employed to distinguish between DCTs and true protozoa. RESULTS: The presence of ameboflagellates in sputum has a diagnostic accuracy of 86% in predicting or ruling. out the possibility of acute asthma. CONCLUSION: The presence of ameboflagellate forms is closely related to the existence of bronchial asthma, and these result reflect some etiopathogenic significance in asthma.     

Evaluation of a sexual abuse prevention program for adults with mental retardation

We have measured the Fourier transform spectrum of natural OCS from 3700 to 4800 cm-1 with a near Doppler resolution and a line-position accuracy between 4 and 8 x 10(-5) cm-1. For the normal isotopic species, 37 vibrational transitions have been analyzed for both frequencies and intensities. We also report 15 bands of OC34S, eight bands of O13CS, nine bands of OC33S, and two bands of 18OCS. Important effective Herman-Wallis terms are explained on the basis of eigenvectors. A comparison of different line-pointing programs is also presented. Copyright 1998 Academic Press.