CAD on geocomposite vertical strip drains

In recent years, an increasing need has arisen for various types of construction on sites underlain by soft cohesive soils. In such cases, some methods of soil improvement are usually required to provide adequate bearing capacity and tolerable postconstruction total and differential settlements. These goals often may be achieved by precompression or preloading the site prior to construction. Precompression and preloading are frequently used in combination with vertical drains, especially in very thick soft deposits, otherwise the time required for consolidation may be unacceptably long or the instability of the foundation may be a serious concern. Therefore, the vertical geocomposite (jute and coir) drain may be used to accelerate the settlement of soil thereby making the site available for use in the shortest time. The computer program and the design chart for determining the spacing between geocomposite drains are presented. This technique is generally useful for embankment construction, tank foundation, underwater construction and landfill areas. Two projects (Haldia in West Bengal and Vashi Station Complex in Bombay) have utilized the application of geocomposite drains reported in this paper.     

Experimental densities for compressed R134a

This paper reports densities of compressed R134a (1,1,1,2-tetrafluoroethane) determined by using a contiuously weighed pycnometer at 20 K intervals between 180 and 380 K at pressures from slightly greater than the vapour pressure to 70 MPa. The results are accurate to within ±0.1%. Saturated liquid densities derived by extrapolation from the experimental values agree with other reported values to within ±0.3%.     

Measurements of thick target fission yields as a probe of fission excitation functions for deep sub-barrier energies

A close-geometry experimental technique has been developed and used to measure thick target fission yields for protons on ²³⁸U from 4.2 to 12 MeV. Fission fragments were detected at back angles by an annular photo-voltaic detector in coincidence with γ-ray registered in large NaI(Tl) detector. The neutron induced fission background was monitored by a detector on the downstream side of the thick target. Measured yields compare well with those calculated from published thin target cross sections. This method has the required sensitivity to carry out measurements at still lower energies where recent measurements give conflicting findings.     

Relative permeability measurements for two phase flow in unconsolidated sands

This paper presents the results of laboratory measurements of relative permeability for two phase flow in partially saturated samples of unconsolidated sands. Relative permeabilities for tap water and air, de-aired water and nitrogen were measured using a steady—state technique. Three different sand samples (fine sand, heterogeneous sand and coarse sand) were tested.     

Characteristics of a far-infrared molecular laser optically pumped by a high-power CO2 laser

A molecular far-infrared (FIR) laser optically pumped by a high-power CO₂ laser, which is a powerful source for testing detectors and mixers and for FIR spectroscopy, is constructed and the performance is examined through experiments. At frequencies between 580GHz and 4.25THz, FIR output power is more than 20～30m W by pumping power of 35～81W. Amplitude stability of ±3% is obtained at 100m W output at 2.52THz for over 30 minutes when the FIR tube is cooled at 5°C by a chiller. As an application to testing mixers, FIR laser lines up to 4.25 THz are detected by Schottky barrier diodes (SBD). Further, using a SBD, performance of absolute frequency stability at 693GHz of HCOOH oscillation is measured by harmonic mixing with a 115.5GHz millimeter wave from a phase-locked Gunn oscillator. The resultant center-frequency stability is 100kHz per 10 minutes.     

Ball cocks for liquid abrasive media

Translated from Khimicheskoe i Neftyanoe Mashinostroenie, No. 6, pp. 8–9, June, 1991.