Electrochemical injection of organic corrosion inhibitors into carbonated cementitious materials: Part 1. Effects on pore solution chemistry

This series of investigations was intended to clarify phenomena associated with electrochemical injection of the organic base corrosion inhibitors, ethanolamine and guanidine, into carbonated concrete. In Part 1, experiments were conducted with laminated specimens of carbonated cement paste, that were specially designed to facilitate analysis with adequate spatial resolution to assess changes in their pore solution phase chemistry after they had been subjected to constant current electrolysis between embedded cathodes and external anodes. The anolyte solutions provided sources of ethanolamine or guanidine in contact with the exterior specimen surfaces. Effects of variations in the applied current density and duration of electrolysis on the concentration profiles of the two inhibitors and the other main constituents of the pore solution phase were determined. The results have been used to underpin the development of a mathematical model, which is described in Part 2.     

Effects of experimental endogenous hyperlipemia on circulating leukocytes and erythrocytes

Effects of hyperlipemia on circulating leukocytes and erythrocytes were studied in dogs which were given repeated, intravenous injections of a nonionic detergent, Triton WR-1339. Erythrocyte lipid concentrations increased from 3.6±0.9 mg/10¹⁰ cells in control animals to 9.3±1.5 mg in the hyperlipemic group. This increase was accompanied by a shift in the distribution of total fatty acids toward a higher percentage of saturated and monounsaturated acids. In contrast to the changes observed in erythrocytes, the leukocyte lipid content remained unaltered in dogs with serum cholesterol levels ranging from 500 to more than 2,000 mg/100 ml. Leukocyte counts rose whereas hematocrit values, hemoglobin concentrations, and erythrocyte counts decreased. Oxygen utilization studies showed no significant metabolic differences between leukocytes which were isolated from hyperlipemic or control animals. Circulating leukocytes in dogs with an endogenously induced hyperlipemia were shown therefore to maintain normal lipid concentrations and did not participate in lipophage formation, as reported for certain diet-induced lipemias.     

Honeybee (Apis mellifera L.) queen feces: Source of a pheromone that repels worker bees

When placed in a small observation arena with workers, most young virgin honeybee queens released fecal (hindgut) material during agonistic interactions with workers and with each other. On release of this material, workers moved to the sides of the arena and groomed themselves. Bioassays of virgin queen fecal material demonstrated that it contains pheromone that repels workers and stimulates grooming behavior. Pheromone was present only in the feces of virgin queens that were more than 24 hr old and less than 2 weeks old. Feces of 2- to 4-day-old workers and virgin queens more than 2 weeks old did not elicit an avoidance response by workers. Moreover, the feces of young virgin queens had a strong fragrance, while that of older queens had a rancid odor and that of young workers had no detectable odor.     

Estimation of lamb carcass composition from measurements of the speed of ultrasound in the soft tissues of live animals and carcasses

The application of the velocity of sound (VOS) technique to lamb carcasses in a previous study (Fisher & Page, 1986) measured composition at a hind limb and neck site but was not as precise as fat scores in predicting lean proportion. This study examines VOS measurements made at sites in the hind limbs and along the vertebral column in live sheep and carcasses. A group (A) comprising five breeds of males and females (n = 61) and a sub-group (B) of Scottish Blackface castrated males (n = 34) were studied, and the reciprocal velocity of ultrasound (RV) was measured on the live sheep immediately behind the shoulder and over the last rib using a fixed-distance transducer assembly operating at 5 MHz, and in the hind limbs at 2·25 MHz using the apparatus described by Miles et al. (1984). Corresponding measurements were made on the carcasses which were classified by a Meat and Livestock Commission fatstock officer and then dissected. Standard deviations of lean proportion were 4·48% (A) and 3·39% (B). The residual standard deviations (rsds) for groups A and B respectively were obtained using the following predictors: live mass (LM) 4·27% and 2·96%; LM + breed (B) 3·08% (group A only); LM + mean RV 2·36% and 2·07%; LM + B + mean RV 1·99% (group A only). Using carcass measurements: carcass mass (CM) 4·25% and 2·90%; CM + MLC fat score 2·99% and 2·12%; CM + RV last rib 2·89% and 2·02%. These data show that VOS measurements through dorsal sites of live sheep provide encouragingly precise estimates of carcass lean proportion. For carcasses, dorsal sites provide a less precise estimate of carcass lean but when carcass mass is included in multiple regression the precision of the correlation is comparable with that of multiple regression of fat score with carcass mass.     

Grain-boundary sliding measurements in Al2O3 by machine vision photogrammetry

The nucleation, growth and coalescence of grain-boundary cavities is the primary damage mechanism observed during creep of structural ceramics. Furthermore, grain-boundary sliding (GBS) has been identified as the driving force process. Although the creep characteristics of structural ceramics have been extensively studied, very little is known about the details of GBS during creep and how GBS relates to cavitation kinetics. This paper presents the results of a study using a machine vision system to measure Mode II GBS displacements in a Lucalox Al₂O₃. Specifically, sliding displacements as large as 0.4 m were measured. The measured displacements indicate that some grain boundaries experienced shear strains and strain rates of 4200% and 2.3×10^–2 s^–1, respectively. The techniques utilized for these measurements are described in detail, and data gathered during a 2 1/2 h compressive creep test under a stress of 138 MPa at 1600 °C are presented and discussed.     

Factors affecting the corrosion rate of steel in carbonated mortars

The corrosion of steel in carbonated mortar has been investigated by monitoring polarization resistance, corrosion potential and mortar resistivity. The results suggest that factors such as relative humidity and chloride contamination affect the corrosion rate via their influence on mortar resistivity. To account for the observed electrochemical relationships, most notably the linear correlation between corrosion rate and conductivity, and the exponential increase in corrosion rate with fall in corrosion potential, it is proposed that the corrosion kinetics of steel in carbonated mortar are subject to anodic control with the anodic reaction rate being limited by the resistance of the mortar. In this model, termed anodic resistance control, resistivity is viewed as a factor which may limit a half reaction rate in a similar way to diffusion and activation polarization. It is also shown that, when such a model is operating, the use of polarization resistance to monitor corrosion rate changes may still be justified provided the cathodic reaction rate is an exponential function of potential.     

Plasmon resonant amplification of a hot electron-driven photodiode

Nano Research - We report plasmon resonant excitation of hot electrons in a photodetector based on a metal/oxide/metal (Au/Al2O3/graphene) heterostructure. In this device, hot electrons, excited...     

Detection and preliminary characterization of matrix metalloproteinase activity in temporomandibular joint lavage fluid

MATERIALS AND METHODS: In the period 1986-1994, 2950 patients with cardiovascular diseases were surgically treated. In 2104 cases we placed biological or synthetic grafts to maintain vascular continuity. The most common has turned out to be abdominal aortic aneurysm. We treated 783 cases in emergency conditions. Staging and localization of infection has been the first aim in patients with synthetic vascular grafts. We studied signs and symptoms related to infections. In all cases we discovered the microorganism responsible of infection we started antibiotic therapy. RESULTS: Surgical infection incidence is 4.9% (154 cases). Series analysis has evidenced a decrease in infection incidence in the period 1986-1994. The most frequent infections are: the urinary tract infection (59 cases, 38.5%) followed by surgical wound infection (37 cases, 24.1%), respiratory tract infection (27 cases, 17.5%), vascular graft infection (23 cases, 14.4%). All patients underwent a preoperative antibiotic prophylaxis with 2 degrees-3 degrees generation cephalosporines. We noted a higher graft infection incidence in patients treated with aortobifemoral reconstruction. We handled surgical infection following two main directions: 1-antibiotic therapy, 2-surgical treatment and antibiotic therapy. CONCLUSIONS: We noted surgical technique improvement and correct application of an antibiotic prophylaxis form has turned out to be the "gold standard" in order to reduce cardiovascular surgical infections. To reduce sepsis or graft infection we can work on either of the following: 1) antibiotic therapy; 2) operative time reduction; 3) try to limit vascular surgery in case of concomitant gastrointestinal surgical disease; 4) using alloplastic vascular grafts with high biological compliance; 5) patency time reduction of invasive diagnostic technique.     

Voltammetric reduction of nickel and cobalt dimethylglyoximate

The determination of cobalt and nickel in aqueous solutions by stripping voltammetry after adsorptive preconcentration is an established procedure. The method is highly sensitive, but there is some controversy concerning the reasons for the excellent sensitivity. Using a variety of voltammetric techniques, we have determined that the reduction of nickel dimethylglyoximate in an ammonia buffer is consistent with an overall process involving 16 or possibly 18 electrons. This hypothesis is confirmed by independently measuring the total quantity of metal adsorptively deposited on the mercury electrode and comparing the amount with the quantity of electricity required for its reduction.     

Retardation of human drug-resistant HL-60 cell in G1 phase and induction of sensitive cell to apoptosis by cyclosporine A

To further study the relationship between resistance to apoptosis and drug resistance in harringtonine-resistant HL-60 cells (HR20), cyclosporine A (CsA) 20, 10 micrograms.ml-1 was shown to induce the sensitive HL-60 cells to apoptosis, showing a typical DNA "ladder" band. But the same concentrations of CsA retarded the HR20 cells in G1 phase and could not induce the cells to apoptosis. The cellular daunorubicin accumulation increased when HR20 cells were treated with low concentration of CsA and the reversal of drug resistance by CsA was unrelated to the retardation of cell cycle progression. High phosphorylation of about 50 kDa protein occured when HR20 cells were treated with CsA 10 micrograms.ml-1. The results domonstrate that cyclosporine A retarded the harringtonine-resistant HL-60 cells in G1 phase but induced HL-60 cells to apoptosis, and the retardation was unrelated to drug resistance.