Influence of dietary iron deficiency on acute metal intoxication

The frequent difficulties encountered in the diagnosis of pediatric sarcomas, caused by the lack of observable differentiation at the light microscopic level, has led to the routine use of immunohistochemistry in pediatric surgical pathology. To a large degree the advent of this staining technique has led to the correct assessment of many perplexing lesions that previously would have been given inconclusive diagnoses. However, with increased usage and testing, it has become apparent that there are few, if any, "magic bullets" in immunohistochemistry for pediatric pathologists. Thus, it behooves diagnosticians to be careful in the usage of this technique, to be aware of possible discrepancies in its results, and to remember the ancillary nature of its application. The following article will review selected markers commonly used in pediatric surgical pathology, from both previous reports and the author's perspective, and will briefly consider several new phenotypic markers which have potential utility with childhood sarcomas.     

Creatine kinase isoenzymes in serum from cord blood and the blood of healthy full-term infants during the first three postnatal days

Isoenzymes of creatine kinase (ATP:creatine phosphotransferase; EC 2.7.3.2; CK) were measured by electrophoresis in serum from cord blood and skin-puncture blood taken from 45 healthy full-term infants during the first three postnatal days. Mean total CK activities (in U/L at 30 degrees C) were 185 in cord samples, 536 in samples taken between 5--8 h postnatally, 494 between 24--33 h, and 288 in the 72-100 h samples. Values for all three isoenzymes increased to a peak over this period, with the highest values generally being found in the samples taken 5--33 h after birth; the subsequent decline was most rapid for CK-BB. Serum CK isoenzymes in cord samples and those taken at 72--100 h in the 11 babies delivered by cesarian section did not differ significantly from those of babies delivered vaginally. However the postnatal increases in total CK, CK-MM, and CK-MB (but not in CK-BB) were significantly greater in those patients born by vaginal delivery. The reasons for the increases in CK isoenzymes after birth are not clear, but our results and reported studies on the ontogeny of CK suggest that CK-MB cannot be regarded as a "cardiac-specific" isoenzyme in the neonatal period.     

Polyaniline as a Gas-Sensor Material

Polyaniline (PANI) was synthesized by oxidative polymerization of aniline using ammonium persulfate in an acid medium. The polyaniline salt was converted to base form by treatment with ammonium hydroxide. The polyaniline base was dissolved in N-methyl pyrrolidone (NMP) for film casting. The cast film was doped with HCl for obtaining higher conductivity. Both doped and undoped PANI films were characterized by UV-visible, FTIR, and XRD analyses. The electrical conductivity of the PANI film was studied by a four-point probe method at room temperature. Finally, ammonia gas-sensing characteristics of the prepared polyaniline film were studied by measuring the change in electrical conductivity on exposure to ammonia gas at different concentrations. The influence of concentration of acid during polymerization of aniline and dopant concentration on the gas sensing characteristics of PANI film are reported in this paper.     

Common entanglement witnesses and their characteristics

We investigate the issue of finding common entanglement witness for certain class of states and extend this study to the case of Schmidt number witnesses. We also introduce the notion of common decomposable and non-decomposable witness operators which is specially useful for constructing a common witness where one of the entangled states is with a positive partial transpose. Our approach is illustrated with the help of suitable examples of qutrit systems.     

Effect of the surface roughness of conducting polypyrrole thin-film electrodes on the electrocatalytic reduction of nitrobenzene

Conducting polypyrrole (PPy) thin-film electrodes were prepared by the electropolymerization of pyrrole on gold-coated glass plates. Films of various roughnesses were obtained by the variation of the scan rates during electropolymerization. These thin films were modified by doping with 6mM of the dopant NiCl₂. The surface morphology of the films was studied by scanning electron microscopy and atomic force microscopy (AFM), which suggested films prepared with a high scan rate were rougher in nature than the films produced with a low scan rate. The electrocatalytic reduction of nitrobenzene was carried out with these electrodes with the cyclic voltammetry technique in acetonitrile containing 0.1M HClO₄ as a supporting electrolyte. The various results obtained show that the conducting PPy thin-film electrodes were catalytically active toward the electroreduction process. The modified PPy film electrodes doped with NiCl₂ were more active toward nitrobenzene electroreduction than the PPy film alone. The results indicate that the roughness of the films played a very important role in determining their catalytic activity. The PPy films that were more rough in nature were catalytically more active than the smooth films; this may have been due to the availability of more reactive sites in the case of rough films. The apparent diffusion coefficients of the PPy film electrodes were also calculated. © 2012 Wiley Periodicals, Inc. J Appl Polym Sci, 2012     

Vibration frequency of graphene based composites: A multiscale approach

This paper presents a multiscale approach for vibration frequency analysis of graphene/polymer composites. The graphene is modelled at the atomistic scale, and the matrix deformation is analysed by the continuum finite element method. Inter-connectivity between graphene and polymer matrix are assumed to be bonded by van der Waals interactions at the interface. The impact of geometrical configuration (armchair and zigzag), boundary conditions and length on the overall stiffness of the graphene reinforced plastics (GRP) is studied. The natural frequency and vibrational mode shapes of GRP studied have displayed dependence on the length and also the boundary conditions. The exceptional vibrational behaviour and large stiffness displayed by GRP makes them a potential replacement for conventional composite fibres such as carbon and glass fibres.     

Roles of soluble and insoluble aggregates induced by soy protein processing in the gelation of myofibrillar protein

The role of soluble and insoluble aggregates induced by soy protein isolate (SPI) processing in the gelling properties of myofibrillar protein (MP) was studied. Incorporating soluble SPI aggregate could greatly improve (P < 0.05) the elastic modulus (G’) and water‐holding capacity (WHC) of MP gel, but had no notable effect on MP gel strength. In contrast, incorporating the insoluble SPI aggregate significantly enhanced the G’, strength and WHC of MP gel, although the improvement in WHC was smaller than that produced by the soluble aggregate. The results of environmental scanning electron microscopy showed that the soluble SPI aggregate induced a less randomly composite gel structure, which may explain its notable enhancement of WHC. However, the insoluble SPI aggregate appeared to be granules embedded in the continuous MP gel matrix, which may be related to the reinforcement of gel strength. Hence, the results of this study suggest further means of processing commercial SPI for use in meat products.     

Thermal behavior of poly(ethylene‐co‐propylene) containing carbon nanofibers

The effect of carbon nanofiber on the thermal behavior of poly(ethylene‐co‐propylene) (PEP) as revealed by differential scanning calorimetry and thermogravimetric analysis is reported. Analysis showed faster crystallization of PEP at higher temperature upon cooling with the increase of carbon nanofiber (CNF) content. The crystallization behavior changed to a single narrow crystallization peak as compared with the broad double crystallization peak of the neat polymer. This demonstrates the nucleation ability of CNF to induce crystals with more uniform distribution. The modified‐Avrami approach was used to study the crystallization behavior. We found that the crystallization rate constant increased with addition of CNFs. The dimensionality of crystal growth was found not to depend significantly on the content of CNF. Thermal degradation in air was monitored using thermogravimetric analysis and observed that the incorporation of nanofiber greater than 2.4 vol% improves thermal stability of PEP. All these results indicate that CNFs can significantly help polymer processing and increase thermal stability of polymers. POLYM. ENG. SCI., 2012. © 2011 Society of Plastics Engineers