Removal of methyl tert-butyl ether from water by pervaporation: bench- and pilot-scale evaluations

The ability of pervaporation to remove methyl tert-butyl ether (MTBE) from water was evaluated at bench and pilot scales. Process parameters studied included flow rate, temperature, MTBE concentration, membrane module type, and permeate pressure. Pervaporation performance was assessed based on the calculated mass transport coefficient of MTBE, the single-pass removal of MTBE (only at the pilot scale), and the fluxes of water and MTBE. The observations for MTBE are compared to results for toluene and 1,1,1-trichloroethane, compounds for which removal by pervaporation has been demonstrated. MTBE removal and mass transfer coefficients were lower than for toluene and trichloroethane. However, MTBE removal efficiency improved significantly with increasing process temperatures from 40 to 80 degrees C. With one of the pilot-scale systems, MTBE removal efficiency approached that of the other VOCs. The observed response of pervaporation performance to temperature was attributed to the strong effect of temperature on the Henry's law constant of MTBE.     

Optical and structural properties of ZnO + Zn<Subscript>2</Subscript>TiO<Subscript>4</Subscript> thin films prepared by the sol–gel method

ZnO + Zn₂TiO₄ thin films were obtained by the sol–gel method using precursor solutions with different Ti/Zn ratios in the 0.18–2.13 range. The films were deposited on glass substrates and annealed in an open atmosphere at 550 °C. The oxide was characterized by X-ray diffraction and photoacoustic (PA) spectroscopy. The films were constituted of polycrystalline ZnO for the lowest Ti/Zn ratio (0.18), polycrystalline Zn₂TiO₄ for the 0.70 and 1.0 ratios, and mixes of both oxides for the intermediate ratios (0.32 and 0.50). For the highest ratios studied (1.44 and 2.13), the films were amorphous. The energy band gap (E_g) values were determined from optical absorption spectra, measured by means of the PA technique spectra. E_g varied in the 3.15 eV (ZnO) to 3.70 eV (Zn₂TiO₄) range.     

Characterization of patinas by means of microscopic techniques

Many stone-made historic buildings have a yellowish layer called 'patina' on their external surface. In some cases, it is due to the natural ageing of the stone caused by chemical–physical reactions between the surface of the stone and the environment, and in other cases it is the result of biological activity. The origin of these patinas can be also be due to ancient protective treatments. The use of organic additives, such as protein-based compounds, in lime or gypsum-based patinas is a traditional technique, which has been used in past centuries for the conservation and protection of stone materials. The thinness of the patinas ensures that microscopic techniques are irreplaceable for their analysis. Optical Microscopy, Fluorescence Microscopy, Scanning Electron Microscopy together with an Energy Dispersive X-ray Spectrometer, and Electron Microprobe are the microscopic techniques used for the characterization of these coverings, providing very useful information on their composition, texture and structure.     

Understanding barriers to home‐based and self‐care in‐center hemodialysis

Despite superior outcomes and lower associated costs, relatively few patients with end‐stage renal disease undergo self‐care or home hemodialysis. Few studies have examined patient‐ and physician‐specific barriers to self‐care and home hemodialysis in the modern era. The degree to which innovative technology might facilitate the adoption of these modalities is unknown. We surveyed 250 patients receiving in‐center hemodialysis and 51 board‐certified nephrologists to identify key barriers to adoption of self‐care and home hemodialysis. Overall, 172 (69%) patients reported that they were “likely” or “very likely” to consider self‐care hemodialysis if they were properly trained on a new hemodialysis system designed for self‐care or home use. Nephrologists believed that patients were capable of performing many dialysis‐relevant tasks, including: weighing themselves (98%), wiping down the chair and machine (84%), clearing alarms during treatment (53%), taking vital signs (46%), and cannulating vascular access (41%), but thought that patients would be willing to do the same in only 69%, 34%, 31%, 29%, and 16%, respectively. Reasons that nephrologists believe patients are hesitant to pursue self‐care or home hemodialysis do not correspond in parallel or by priority to reasons reported by patients. Self‐care and home hemodialysis offer several advantages to patients and dialysis providers. Overcoming real and perceived barriers with new technology, education and coordinated care will be required for these modalities to gain traction in the coming years.     

Impact of Ethanol on Benzene Plume Lengths: Microbial and Modeling Studies

Recent legislation in several states has called for the removal of methyl tert-butyl ether (MTBE) from gasoline. In order to comply with Federal Clean Air Act requirements for carbon monoxide and ozone attainment, ethanol is being considered as a replacement for MTBE. The objective of this study is to evaluate the potential impact of ethanol on benzene plume lengths in subsurface environments following accidental spills of ethanol-blended gasoline. Two types of studies were conducted here. First, laboratory studies were performed using a pure culture indigenous to a gasoline-contaminated aquifer to evaluate the effect of ethanol on the rate of benzene biodegradation under aerobic conditions. Results from microbial studies showed that the biodegradation of 25 mg/L benzene was severely inhibited in the presence of 25 mg/L ethanol. While the enzymes responsible for benzene biodegradation by the culture were inducible, ethanol degradation appeared to be constitutive. Second, a two-dimensional model was developed to quantify the impact of ethanol on benzene plume lengths using weighted-average aerobic and anaerobic biodegradation rates for benzene in the presence and absence of ethanol. Model simulations indicated that benzene plume lengths are likely to increase by 16–34% in the presence of ethanol.     

PI regulation for a class of bioreactors: stability and performance

Stability and performance features of linear PI compensation for continuous bioreactors are studied in this paper. First, it is established that conventional PI control can be represented as the combination of an I/O inverse dynamics feedback with a modeling error dynamic estimator. Then, the analysis of the closed‐loop dynamics carried out with singular perturbation tools shows that PI control can recover the stability and performance induced by exact I/O inverse dynamics feedback controller. The theoretical results are illustrated via a typical numerical example. Copyright © 2012 John Wiley & Sons, Ltd.     

Dynamics of [Ca2+] in the endoplasmic reticulum and cytoplasm of intact HeLa cells. A comparative study

We have measured the [Ca2+] in the endoplasmic reticulum ([Ca2+]er) of intact HeLa cells at both 22 degrees C and 37 degrees C using endoplamsic reticulum-targeted, low Ca2+ affinity aequorin reconstituted with coelenterazine n. Aequorin consumption was much slower at 22 degrees C, and this allowed performing a much longer study of the dynamics of [Ca2+]er. The steady-state [Ca2+]er (500-600 microM) was not modified by the temperature, although both the rates of pumping and leak were decreased at 22 degrees C. The behavior of both [Ca2+]er and cytoplasmic [Ca2+] ([Ca2+]c) after the addition of increasing concentrations of agonists and/or Ca2+-ATPase inhibitors, or following incubation in Ca2+-free medium were compared. We show that agonists induce a fast but relatively small decrease in [Ca2+]er, which is enough to produce a sharp increase in [Ca2+]c. Termination of Ca2+ release is controlled by feedback inhibition of the inositol 1,4,5-trisphosphate receptors by [Ca2+]c, a mechanism that appears to be designed to release the minimum amount of Ca2+ necessary to produced the required [Ca2+]c signal. We also show that Ca2+ release is inhibited progressively when [Ca2+]er decreases below a threshold of about 150 microM, even in the absence of Ca2+ pumping or -Ca2+-c increase. This effect is consistent with a regulation of the inositol 1,4,5-trisphosphate-gated channels by [Ca2+]er.     

Mining statistically significant associations for exploratory analysis of human sleep data.

We introduce a specialized association rule mining technique that can extract patterns from complex sleep data comprising polysomnographic recordings, clinical summaries, and sleep questionnaire responses. The rules mined can describe associations among temporally annotated events and questionnaire or summary data; e.g., the likelihood that an occurrence of a rapid eye movement (REM) sleep stage during the second 100 sleep epochs of the night is associated with moderate caffeine intake. We use chi2 analysis to ensure statistical significance of the mined rules at the level P < 0.05. Our results, obtained by mining sleep-related data from 242 human subjects, reveal clinically interesting associations among the polysomnographic and summary variables. Our experience suggests that association mining may also be useful for selection of variables prior to using logistic regression.