Equivalent linear limit states

The replacement of any limit state function by an equivalent linear function is discussed in detail and it is shown that there are several methods by which such an equivalence may be established. In the case of multiple failure mode problems the definition of fully equivalent linear functions requires the additional consideration of mode correlations. The manner in which this may be carried out is discussed and it is shown that, for most practical cases, a relatively simple analysis is likely to be sufficient to define the set of equivalent linear limit states, with the advantage that the established theory of such linear limit states may then be employed in the majority of reliability analyses.     

Lead and cadmium in teeth,bone and kidneys of rats with a standard Pb‐Cd supply

Male Wistar rats received a combination of 25 ppm PbCl₂ and 5 ppm CdCl₂ in drinking water at different developmental stages. Pb and Cd levels of incisors, molars, epiphyses, diaphyses and kidney cortex were recorded by atomic absorption spectrophotometry. The results confirmed that Pb has an affinity for hard tissue and especially to teeth, but it also accumulated in soft tissues under the above conditions. In addition, the results indicated none or only a moderate placental or mammary barrier for Pb, and suggested a high absorption of lead from the intestine of sucklings. The results also confirmed that kidney cortex is a primary target for Cd, and indicated that Cd has crossed the placental and mammary barriers to some degree. The positive significant correlation between Cd levels in molars and kidney cortex suggested that rodent molars indicate a degree of Cd absorption, whereas incisors do not. It is supposed that rodent molars are comparable to human deciduous teeth. It is thus confirmed that human deciduous teeth indicate previous lead exposure. It is further inferred that they also can be used as indicators of previous Cd‐exposures.     

Andalusia,Spain: An Assessment of Coastal Scenery

The 1101 km length of the Andalusian coast (Spain) was assessed for coastal scenery at 45 specific locations. Selected areas covered resort (3), urban (19), village (8), rural (10) and remote (5) bathing areas. Scenery was analyzed for physical and human parameters via 26 selected parameters. These parameters were obtained by interviews of >500 people on European beaches. Each parameter was assessed via a one-to-five-point attribute scale, which essentially ranged from presence/absence or poor quality (1), to excellent/outstanding (5). Results were subsequently weighted by interviewing >600 bathing area users (not all 26 parameters have equal weight) and subjected to fuzzy logic mathematics in order to reduce recorder subjectivity. High weighted averages for attributes 4 and 5 (excellent/outstanding) reflected high scenic quality, vice versa for attributes 1 and 2. Sites were classified into five classes ranging from Class 1 sites having top grade scenery to Class 5, poor scenery. Seven sites each were found in Classes 1 and 2; 10 sites each in Classes 3 and 5; 11 sites in Class 4. The finest coastal scenery was found in remote areas whilst urban areas scored mainly as Class 3 or 4. Three out of the ten rural sites had Class 3 and 4 values assigned them whereas the rest scored as Class 1 and 2; village sites invariably had scores within Class 3 and 4. Of the three resort sites investigated, one scored as a Class 1 site, the others as Class 3.     

Town and Country Planning in England's Northeast Section

Abstract

A SYMPOSIUM OF CURRENT PLANNING THEORY: Planning for America , By GEORGE B. GALLOWAY AND ASSOCIATES. Henry Holt and Co., New York; 713 pages, price $3.

A TEXTBOOK ON SUBDIVISION: Subdivision Regulations: An Analysis of Land Subdivision Control Practices. By HAROLD W. LAUTNER. Public Administration Service; 346 pages, price $3.75.

EMPLOYMENT IN THE REGIONAL DEVELOPMENT OF RESOURCES: Development of Resources and Stabilization of Employment in the United States. By THE NATIONAL RESOURCES PLANNING BOARD; 409 pages, price $1.20.     

Development of a continuous respirometer

A continuous oxygen uptake meter or continuous respirometer was developed which produced a rapid and reliable response to systemic shocks. The respirometer basically is a 101. Plexiglas laboratory activated sludge unit with a variable volume air tight side car. The feed enters the completely mixed aeration basin and is pumped into the side car. The side car is the site of the oxygen uptake measurements as indicated by a continuously monitoring dissolved oxygen probe. The system was most sensitive to changes in influent concentrations when run at an F/M = 0.1. Response time for a change in DO of 0.1 ppm was less than 4 min. The continuous respirometer was tested employing both synthetic and raw industrial wastes.     

Polychlorinated naphthalenes in air and snow in the Norwegian Arctic: a local source or an Eastern Arctic phenomenon?

PCNs were measured in air and snow during separate field campaigns at Ny-Alesund (April 2001) and Troms? (February/March 2003) in the Norwegian Arctic. Air concentrations ranged from 27 to 48 and 9 to 47 pg sigmaPCN m(-3) for Ny-Alesund (n=6) and Troms? (n=10), respectively. These concentrations (including the tri-chlorinated naphthalenes) greatly exceeded concentrations previously measured in the Canadian Arctic, but did fall within the upper range of concentrations observed over the eastern Arctic Ocean and regional seas. Local sources appear to be affecting concentrations observed at both sites, with the presence of several hexa-chlorinated naphthalenes at Troms? probably attributed to local/regional sources. Use of air mass back trajectories at Troms? revealed that background air concentrations in the Norwegian Arctic are likely to range between <9 and 20 pg sigmaPCN m(-3) and that contemporary concentrations derived close to potential sources (i.e. arctic towns) may equal or exceed those of PCBs. The mean concentration in surface snow was 350 and 240 pg sigmaPCN L(-1) (meltwater) (or 0.014 and 0.01 pg g(-1) (snow)) at Ny-Alesund and Troms?, respectively. The wide variation in concentrations observed between fresh snowfalls could be explained by different snow densities (as a surrogate of snow surface area), rather than attributed to varying air concentrations. A statistically significant inverse relationship was found between snow density and concentrations of tri- to penta-chlorinated homologues and compliments similar findings for the polychlorinated biphenyls (PCBs). This suggests that the vapour-sorbed quantity changes rapidly with snow ageing/compaction; with implications for the fate of these chemicals in the Arctic.     

Continuous-flow metal biosorption in a regenerable Sargassum column

Metal biosorption behavior of raw seaweed S. filipendula in ten consecutive sorption-desorption cycles has been investigated in a packed-bed flow-through column during a continuous removal of copper from a 35mg/L aqueous solution at pH 5. The elutant used was a 1% (w/v) CaCl2/HCl-solution at pH 3. The sorption and desorption was carried out for an average of 85 and 15h, respectively, representing more than 41 days of continuous use of the biosorbent. The weight loss of biomass after this time was 21.6%. The Cu-biosorption capacity of the biomass, based on the initial dry weight, remained relatively constant at approximately 38 mg Cu/g. Loss of sorption performance was indicated by a shortening breakthrough time and a broadening mass-transfer zone. The column service time, considered up to 1 mg Cu/L in the effluent, decreased continuously from 25.4 h for the first to 12.7 h for the last cycle. The critical bed length, representing the mass-transfer zone, increased almost linearly from 28 to 34cm. "Life-factors" for S. filipendula were found to be 0.0008h(-1) for the breakthrough time and 0.008cm/h for the critical bed length, using an exponential decay and linear fitting functions, respectively. Regeneration with CaCl2/HCl at pH 3 provided elution efficiencies up to 100%. Maximum concentration factors were determined to be in the range 16-44, a decreasing tendency was observed with an increasing exposure time.     

Use of slow filtration columns to assess oxygen respiration, consumption of dissolved organic carbon, nitrogen transformations, and microbial parameters in hyporheic sediments

Biogeochemical processes mediated by microorganisms in river sediments (hyporheic sediments) play a key role in river metabolism. Because biogeochemical reactions in the hyporheic zone are often limited to the top few decimetres of sediments below the water-sediment interface, slow filtration columns were used in the present study to quantify biogeochemical processes (uptakes of O2, DOC, and nitrate) and the associated microbial compartment (biomass, respiratory activity, and hydrolytic activity) at a centimetre scale in heterogeneous (gravel and sand) sediments. The results indicated that slow filtration columns recreated properly the aerobic-anaerobic gradient classically observed in the hyporheic zone. O2 and NO3- consumptions (256 +/- 13 microg of O2 per hour and 14.6 +/- 6.1 microg of N-NO3- per hour) measured in columns were in the range of values measured in different river sediments. Slow filtration columns also reproduced the high heterogeneity of the hyporheic zone with the presence of anaerobic pockets in sediments where denitrification and fermentation processes occurred. The respiratory and hydrolytic activities of bacteria were strongly linked with the O2 consumption in the experimental system, highlighting the dominance of aerobic processes in our river sediments. In comparison with these activities, the bacterial biomass (protein content) integrated both aerobic and anaerobic processes and could be used as a global microbial indicator in our system. Finally, slow filtration columns are an appropriate tool to quantify in situ rates of biogeochemical processes and to determine the relationship between the microbial compartment and the physico-chemical environment in coarse river sediments.     

Earthquake-induced net section fracture in brace connections — experiments and simulations

Results from six tests, finite element simulations and a synthesis of previous test programs on slotted end bracing connections are presented. The main objective of the research is to examine the deformation capacity of these connections, with the ultimate objective of minimizing the requirement for net section reinforcement that is often inconvenient from the perspective of fabrication. The experiments and simulations feature commonly used pipe specimens and end details. The main parameters investigated include the gusset plate thickness, the slot length and introduction of a wrap-around weld that eliminates the reduced section at the edge of the gusset plate. The results indicate that even without reinforcement, the connections offer adequate to excellent deformation capacity if they are provided with the wrap-around weld or if the net section strength is larger than the gross yield strength. This may be achieved in situations where shear lag in the connection is minimal, and where the area reduction due to the slot is small relative to the gross area. Design considerations are presented along with limitations of the study.     

Human response to blast-induced vibration and air-overpressure: an Indian scenario

Ground vibration (V_max) and air-overpressure/noise (p) are some of the negative effects of blasting. The associated human annoyance and complaints are expected to show an increasing trend in the future as there is no economically viable alternative to blasting in mines in India.A study of the human response to blasting in four mining localities across India has shown that the response is not simply political, as frequently assumed. It has been found that irrespective of those questioned, a basic concern for the safety of property was the main response. There was a greater response from the middle-aged and middle-educated while fewer women than men responded. Assuming that a 100% negative response from the inhabitants will translate into complaints, a methodology is suggested to take account of the human response criteria when considering blasting within 400 m of habitations.