Mangrove Oyster (Crassostrea belcheri) as a Biomonitor Species for Bioavailability of Polycyclic Aromatic Hydrocarbons (PAHs) from Sediment of the West Coast of Peninsular Malaysia

ABSTRACT

Rapid industrialization and urbanization in the west coast of Peninsular Malaysia has caused increasing pollution particularly of petroleum and petroleum by-products. Surface sediment and mangrove oyster (Crassostrea belcheri) were collected from five mangrove ecosystems in the west coast of Peninsular Malaysia and investigated for bioavailability of polycyclic aromatic hydrocarbons (PAHs). Sampling locations were selected from both remote areas with few or no previous records of petroleum pollution such as Pulau Merambong and polluted areas that are under international attention such as Klang mangrove ecosystem. PAH fractions were obtained through soxhlet extraction and two-step column chromatography and the fractions were injected to gas chromatography-mass spectrometry (GC-MS) for analysis. The concentrations of PAHs ranged from 151 to 4973 ng g^?1 dw in the sediments, while from 309 to 2225 ng g^?1 dw in the oysters. When tested for diagnostic ratios, a predominance of pyrogenic source PAHs was detected in the sediments, whereas PAHs in the oysters had mixed petrogenic and pyrogenic sources. A significant correlation (p < 0.05) was found between high molecular weight (HMW) PAHs in the sediments and oysters and biota accumulation factors (BAFs) of PAHs were approaching or exceeding unity indicating the ability of mangrove oyster in bioaccumulation of PAHs. Overall, this study indicates that mangrove oyster (C. belcheri) can be used as a biomonitor species for PAHs in an aquatic environment.     

NMR of insensitive nuclei enhanced by dynamic nuclear polarization

Despite the powerful spectroscopic information it provides, Nuclear Magnetic Resonance (NMR) spectroscopy suffers from a lack of sensitivity, especially when dealing with nuclei other than protons. Even though NMR can be applied in a straightforward manner when dealing with abundant protons of organic molecules, it is very challenging to address biomolecules in low concentration and/or many other nuclei of the periodic table that do not provide as intense signals as protons. Dynamic Nuclear Polarization (DNP) is an important technique that provides a way to dramatically increase signal intensities in NMR. It consists in transferring the very high electron spin polarization of paramagnetic centers (usually at low temperature) to the surrounding nuclear spins with appropriate microwave irradiation. DNP can lead to an enhancement of the nuclear spin polarization by up to four orders of magnitude. We present in this article some basic concepts of DNP, describe the DNP apparatus at EPFL, and illustrate the interest of the technique for chemical applications by reporting recent measurements of the kinetics of complexation of 89Y by the DOTAM ligand.     

Preparation of nanocomposite dispersions based on cellulose whiskers and acrylic copolymer by miniemulsion polymerization: Effect of the silane content

A one‐step method was used to prepare stable aqueous nanocomposite dispersions based on cellulose whiskers extracted from the rachis of the date palm tree and a poly(styrene‐co‐2‐ethyl hexylacrylate) copolymer via miniemulsion polymerization. A reactive silane, i.e., methacryloxypropyl triethoxysilane was added to stabilize the dispersion and favor the anchoring of the whiskers on polymer particles. Dynamic light scattering was used to study the effect of the silane and whiskers contents on the average particle size of the polymer. Nanocomposites materials were prepared from these dispersions using a casting/evaporation method. The effect of the silane and whiskers contents on the thermal and mechanical properties were studied using differential scanning calorimetry and dynamic mechanical analysis. POLYM. ENG. SCI., 2011. © 2010 Society of Plastics Engineers     

Electrical capacitance tomography as a monitoring tool for high-shear mixing and granulation

Electrical capacitance tomography (ECT) was utilized for monitoring of high-shear mixing and high-shear granulation processes. A finite element method (FEM)-based reconstruction algorithm was utilized to take into account the specific geometrical characteristics of the experimental set-up. Two-dimensional ECT tomograms, mixing index curves and permittivity fractions were computed based on the measurements, and their suitability in the analysis of the processes was assessed. It was found that the different mixing processes and the different granulation processes could be analyzed based on these quantities.     

Synthesis and structure-activity relationship of the isoindolinyl benzisoxazolpiperidines as potent,selective, and orally active human dopamine D4 receptor antagonists

A new class of potent dopamine D(4) antagonists was discovered with selectivity over dopamine D(2) and the alpha-1 adrenoceptor. The lead compound was discovered by screening our compound collection. The structure-activity relationships of substituted isoindoline rings and the chirality about the hydroxymethyl side chain were explored. The isoindoline analogues showed modest differences in potency and selectivity. The S enantiomer proved to be the more potent enantiomer at the D(4) receptor. Several analogues with greater than 100-fold selectivity for D(4) over D(2) and the alpha-1 adrenoreceptor were discovered. Several selective analogues were active in vivo upon oral or intraperitoneal administration. A chiral synthesis starting from either D- or L-O-benzylserine is also described.     

Stabilization of refined olive oil by enrichment with chlorophyll pigments extracted from Chemlali olive leaves

This paper presents the first investigation on the effect of enrichment refined olive oil by chlorophyll pigment extracted from Chemlali olive leaves during storage (6 months). The changes that occurred in the quality indices, fatty acids, sterol, and phenolic content were investigated during the storage of refined olive oil under RT (20°C) and accelerated conditions (50°C) in the dark. Additionally, the pigments (chlorophyll and carotene) changes during 6 months of oil storage were evaluated. At the end of the storage, more than 90% of chlorophyll pigments decomposed in all samples, while, carotene pigment loss was lower showing up to 60 and 85% loss for oil stored at 20 and 50°C, respectively, at the end of storage. The reduction of total phenolic compounds exhibited similar degradation profiles, being reduced by 5% and up to 60% for the enriched refined olive oil stored at 20 and 50°C in 6 months, respectively. In the fatty acid composition, an increase in oleic acid and a decrease in linoleic and linolenic acids were less significant in enriched than non‐enriched refined olive oil. On the other hand, sterol composition was less affected by storage in enriched oil samples. However, the sterol concentration of the oil samples showed an increase in β‐sitosterol, 24‐methylene cholesterol, stigmasterol, and a decrease in cholesterol, Δ5, 24‐stigmastadienol percentage at the end of storage. Based on the Rancimat method, the oils with added leaf pigment extract had the lowest peroxide value and the highest stability. After 6 months of storage, the oxidative resistance of refined olive oil fell to 0.2 and to zero for enriched refined olive oil stored at 20 and 50°C, respectively.     

[Carboxyl‐11C]Labelling of Four High‐Affinity cPLA2α Inhibitors and Their Evaluation as Radioligands in Mice by Positron Emission Tomography

Cytosolic phospholipase A2α (cPLA2α) may play a critical role in neuropsychiatric and neurodegenerative disorders associated with oxidative stress and neuroinflammation. An effective PET radioligand for imaging cPLA2α in living brain might prove useful for biomedical research, especially on neuroinflammation. We selected four high‐affinity (IC₅₀ 2.1–12 nm ) indole‐5‐carboxylic acid‐based inhibitors of cPLA2α, namely 3‐isobutyryl‐1‐(2‐oxo‐3‐(4‐phenoxyphenoxy)propyl)‐1H‐indole‐5‐carboxylic acid ( 1 ); 3‐acetyl‐1‐(2‐oxo‐3‐(4‐(4‐(trifluoromethyl)phenoxy)phenoxy)propyl)‐1H‐indole‐5‐carboxylic acid ( 2 ); 3‐(3‐methyl‐1,2,4‐oxadiazol‐5‐yl)‐1‐(2‐oxo‐3‐(4‐phenoxyphenoxy)propyl)‐1H‐indole‐5‐carboxylic acid ( 3 ); and 3‐(3‐methyl‐1,2,4‐oxadiazol‐5‐yl)‐1‐(3‐(4‐octylphenoxy)‐2‐oxopropyl)‐1H‐indole‐5‐carboxylic acid ( 4 ), for labelling in carboxyl position with carbon‐11 (t_1/2=20.4 min) to provide candidate PET radioligands for imaging brain cPLA2α. Compounds [¹¹C] 1 – 4 were obtained for intravenous injection in adequate overall yields (1.1–5.5 %) from cyclotron‐produced [¹¹C]carbon dioxide and with moderate molar activities (70–141 GBq μmol^?1) through the use of Pd⁰‐mediated [¹¹C]carbon monoxide insertion on iodo precursors. Measured logD_7.4 values were within a narrow moderate range (1.9–2.4). After intravenous injection of [¹¹C] 1 – 4 in mice, radioactivity uptakes in brain peaked at low values (≤0.8 SUV) and decreased by about 90 % over 15 min. Pretreatments of the mice with high doses of the corresponding non‐radioactive ligands did not alter brain time–activity curves. Brain uptakes of radioactivity after administration of [¹¹C] 1 to wild‐type and P‐gp/BCRP dual knock‐out mice were similar (peak 0.4 vs. 0.5 SUV), indicating that [¹¹C] 1 and others in this structural class, are not substrates for efflux transporters.     

Laser Treatment of Sintered Silicon Carbide Surface for Enhanced Hydrophobicity

In this study, laser treatment of sintered SiC surfaces is carried out to enhance the surface hydrophobicity. Morphological and metallurgical changes of the treated surfaces are evaluated using optical and scanning electron microscopy, energy dispersive spectroscopy, and x-ray diffraction (XRD). Microhardness and fracture toughness are measured using indentation tests. The residual stresses present are determined using the XRD technique. The wetting characteristics of the treated surfaces are assessed through contact angle measurements. It is found that the laser-treated surfaces consist of fine grooves and pillars and that the resulting surface roughness enhances the surface hydrophobicity. The fracture toughness of the treated surface is reduced possibly because of the microhardness increase at the surface. The residual stress formed in the surface region is on the order of 1.8 GPa, and it is compressive.     

Predicting the total environmental impact of product technologies

Many eco design tools and product assessment methods have been developed to improve the environmental performance of products during design stage. Despite the efforts made at the product level, environmental impact in our society is increasing due to environmental impact associated with increased product volume. This article presents a new methodology for product life cycle design assessment to predict the total impact caused in the society by forecasting the market growth of emerging product technologies. A number of products were used to prove the validity of the proposed model and demonstrate the usefulness of the methodology.     

Effect of expandable graphite and ammonium polyphosphate on the thermal degradation and weathering of intumescent fire-retardant coating

This research aims to study the effect of ammonium polyphosphate and expandable graphite on the intumescent coating formulations (ICF). The coating presented in this research article is based on carbon source expandable graphite (EG), blowing agent melamine, acid source ammonium polyphosphate (APP), epoxy resin as a binder with polyamide amine. The stability of the developed coating was verified at 950°C for 1-hour fire test. The results showed that the coating is stable and well bond with the steel substrate. The char was characterized by using FESEM, XRD, FTIR, DTA, TGA, XPS, Py-GCMS and Weathering Test. The morphology of the char was studied by SEM of the coating after furnace fire test. XRD and FTIR show the presence of graphite, borophosphate; boron oxide and sassolite in the residual char. TGA and DTG disclosed that EG improved the residual mass of coating. XPS analysis showed the char residue of IF5-APP-EG contains carbon and oxygen contents 47.50 and 40.70, respectively. Py-GCMS analysis described that the IF5-APP-EG released less gaseous compounds. The weathering test illustrated that's the char expansion of coatings samples was decreased due to the presence of a humid environment and UV light. The IF5-APP-EG showed the maximum char expansion, lower substrate temperature and high residual weight among the studied formulations.