Electrochemical Faceting of polycrystalline platinum in HF solutions

The electrochemical faceting of polycrystalline (pc) platinum yielding a (100)-preferred oriented electrode surface was accomplished in HF solutions by applying to the pc platinum electrode a square wave potential perturbation at 1 kHz in the 0.2 to 1.3 V range (vs rhe). SEM patterns of the resulting surfaces were also obtained. For HF concentrations up to 2 M no appreciable influence of the electrolyte concentration on the electrochemical faceting was noticed. Otherwise, the voltammetric response of the (100)-type preferred oriented platinum surface in the H-adatom potential range when compared to previously reported data resulted remarkably sensitive to the electrolyte composition. The discussion of results was based on the non-equilibrium adsorption conditions for anions under the periodic perturbation.     

子午线轮胎动力站技术管理

介绍了子午轮胎硫化的各种介质性能要求及介质供应工艺流程,分析了各种介质的质量要求.介绍了系统各参数的控制调节项目及运行技术管理的一些措施.     

春光油田现代油藏经营管理模式的

介绍并分析了春光油田现代油藏经营管理模式的构建与运作及实施效果.     

Peracetic acid pretreatment of sugarcane bagasse for enzymatic hydrolysis: a continued work

Previous work has shown that the enzymatic hydrolysis of sugarcane bagasse could be greatly enhanced by peracetic acid (PAA) pretreatment. There are several factors affecting the enzymatic digestibility of the biomass, including lignin and hemicelluloses content, cellulose crystallinity, acetyl group content, accessible surface area and so on. The objective of this work is to analyze the mechanism of the enhancement of enzymatic digestibility caused by PAA pretreatment. Delignification resulted in an increase of the surface area and reduction of the irreversible absorption of cellulase, which helped to increase the enzymatic digestibility. The Fourier transform infrared (FTIR) spectrum showed that the absorption peaks of aromatic skeletal vibrations were weakened or disappeared after PAA pretreatment. However, the infrared crystallization index (N.O'KI) was increased. X‐ray diffraction (XRD) analysis indicated that the crystallinity of PAA‐treated samples was increased owing to the partial removal of amorphous lignin and hemicelluloses and probable physical change of cellulose. The effect of acetyl group content on enzymatic digestibility is negligible compared with the degree of delignification and crystallinity. The results indicate that enhancement of enzymatic digestibility of sugarcane bagasse by PAA pretreatment is achieved mainly by delignification and an increase in the surface area and exposure of cellulose fibers. Copyright © 2008 Society of Chemical Industry     

Effects of compressive and tensile stress on the growth mode of epitaxial oxide films

Oxide films were deposited on different substrates by laser molecular beam epitaxy. Reflection high-energy electron diffraction was performed to in situ investigate the change of growth mode and the lattice relaxation during the growth. An asymmetrical phenomenon was found in the two kinds of strain states, compressive stress and tensile stress of heterostructures with different lattice mismatch. In the case of BaTiO₃/SrTiO₃ (2.2%), 2D layer-by-layer growth mode without lattice relaxation can be maintained for a longer period for BTO films on STO with compressive stress, comparing to STO films on BTO with tensile stress. When MgO films were deposited on SrTiO₃ with a large mismatch of 7.8%, compressive stress leads to rapid lattice relaxation with a very thin wet layer, and 3D strained island were observed. As a comparison, SrTiO₃ films on MgO with tensile stress were configured. No RHEED patterns can be observed duo to a large tensile stress.     

Epoxy paint failure in B-52 fuel tanks: Part II. Influence of DIEGME concentration in the fuel on the failure process

A model has been proposed to explain the failure of the original BMS10-39 epoxy paint on upper vertical surfaces in B-52 fuel tanks. The model involves interaction of the paint with DIEGME, a fuel system ice inhibitor (FSII) in jet fuel, that is distilled from the liquid fuel. In this communication, distillation experiments used to support the model are refined to better match the mass transfer of vapor from fuel in a B-52 fuel tank at close to room temperature. The interaction of these lower temperature distillates with the paint affirms the earlier model. On the basis of these experiments it is proposed that paint failure may be controlled or eliminated by reducing the level of DIEGME in the fuel. Proposed changes in military jet fuel composition are detailed.     

Integration of prior knowledge of measurement noise in kernel density classification

Samples can be measured with different precisions and reliabilities in different experiments, or even within the same experiment. These varying levels of measurement noise may deteriorate the performance of a pattern recognition system, if not treated with care. Here we seek to investigate the benefit of incorporating prior knowledge about measurement noise into system construction. We propose a kernel density classifier which integrates such prior knowledge. Instead of using an identical kernel for each sample, we transform the prior knowledge into a distinct kernel for each sample. The integration procedure is straightforward and easy to interpret. In addition, we show how to estimate the diverse measurement noise levels in a real world dataset. Compared to the basic methods, the new kernel density classifier can give a significantly better classification performance. As expected, this improvement is more obvious for small sample size datasets and large number of features.     

Secondary Aluminum Production Waste — A Raw Material for the Refractory Industry

Secondary aluminum waste products, and processes that occur during heating and mineral formation on introducing fine periclase powder into the composition of waste products are studied. It is demonstrated that secondary aluminum production waste may be used as a raw material for synthesizing aluminomagnesia spinels. Translated from Novye Ogneupory, No. 6, pp. 15–18, June 2008.     

Testing a new composition of periclase spinel objects

On the basis of periclase powder (70%) and aluminomagnesia spinel (30%), synthesized from secondary aluminum production waste and caustic magnesite, test objects are produced of periclase spinel composition satisfying the requirements of GOST 1579-006-00190495-98. The articles are successfully tested in the working layer for lining tunnel furnace cars of OAO Kombinat Magnezit. __________ Translated from Novye Ogneupory, No. 8, pp. 16–17, August 2008.     

Synthesis of nanocrystalline solid solutions based on zirconia and hafnia

Nanosized (2–8 nm) amorphous powders of the solid solution based on zirconia and hafnia are synthesized through back coprecipitation upon treatment of gels at temperatures from +20 to −77°C. Heat treatment of these powders at temperatures up to 1000 and above 1100°C leads to the formation of cubic (fluorite type, O _h ⁵ = Fm3m) and tetragonal phases of the Zr₈₂Hf₁₀Y₃Ce₅O _x composition, respectively. It is revealed that a decrease in the synthesis temperature (from +20°C to −6°C) results in a decrease in the size of gel agglomerates from 30 to 1 μm. Recrystallization processes in the gels prepared using cryochemical treatment are developed very slowly in the temperature range 500–1200°C (the crystallite size does not exceed 25 nm). Original Russian Text ? T.I. Panova, V.B. Glushkova, A.E. Lapshin, 2008, published in Fizika i Khimiya Stekla.