Optical demultiplexing at 6 Gb/s using a semiconductor laser amplifier as an optical gate

A semiconductor laser amplifier (SLA) has been employed successfully for optical demultiplexing in two-channel optical time division multiplexed system experiments at 6 and 2 Gb/s. Demultiplexing of 6-Gb/s (2-Gb/s) signals was demonstrated with a power penalty of 1.6 dB (3.0 dB) at bit error rates of 10/sup -9/. It is also shown that a reduction of the generated amplified spontaneous emission can be obtained by optical gating/demultiplexing for systems incorporating inline amplifiers. A 0.5-dB improvement in sensitivity was achieved as a result of using an SLA for demultiplexing from 2.0 to 1.0 Gb/s in a system with one inline Er/sup 3+/-doped fiber amplifier.<>     

Ammoxidation of toluene over Y-Ba-Cu-Co-O perovskites

Ammoxidation of toluene over the perovskites YBa₂Cu₃O_6.1, YBa₂Cu₂CoO_6.7 and YBaCuCoO_4.9 was investigated at 400 °C. At low partial pressures of O₂ benzonitrile was selectively formed, while CO₂ was the main product at high pressures of O₂. Systematic differences in activity were observed for the three phases and are related to the crystal contents of Cu and Co. At low O₂ pressures, Cu-sites are active for nitrile formation, while Co-sites give CO₂. At high O₂ pressures, the activity for CO₂ of Cu-sites increases more than that of Co-sites due to filling of near-surface oxygen vacancies.     

Highly birefringent index-guiding photonic crystal fibers

Photonic crystal fibers (PCFs) offer new possibilities of realizing highly birefringent fibers due to a higher intrinsic index contrast compared to conventional fibers. In this letter, we analyze theoretically the levels of birefringence that can be expected using relatively simple PCF designs. While extremely high degrees of birefringence may be obtained for the fibers, we demonstrate that careful design with respect to multimode behavior must be performed. We further discuss the cutoff properties of birefringent PCFs and present experimental results in agreement with theoretical predictions on both single- and multimode behavior and on levels of birefringence     

多正极混合型超级电容器的研制

通过结构优化组合,采用铝化成箔(Al/Al2O3)极片为正极,活性炭极片(AC/Al)为负极,研制了电压为16V的多正极混合超级电容器。通过增加正极数量,进一步提高能量密度。多项电化学性能测试显示:多正极混合超级电容器具有快速充放电能力,与1000μF铝电解电容器相比,能量密度提高了约9倍,阻抗曲线接近理想电容器,内阻约为0.05?。     

Design optimization on the drive train of a light-weight robotic arm

A drive train optimization method for design of light-weight robots is proposed. Optimal selections of motors and gearboxes from a limited catalog of commercially available components are done simultaneously for all joints of a robotic arm. Characteristics of the motor and gearbox, including gear ratio, gear inertia, motor inertia, and gear efficiency, are considered in the drive train modeling. A co-simulation method is developed for dynamic simulation of the arm. A design example is included to demonstrate the proposed design optimization method.     

A hybrid method combining the multitemporal resolution time-domain method of moments with the time-domain geometrical theory of diffraction for thin-wire antenna problems

In this paper, a hybrid method combining a multitemporal resolution (MTR) enhanced time-domain method of moments (TD-MoM) with the TD geometrical theory of diffraction (GTD) is presented, which allows to efficiently calculate the transient fields radiated by antennas in presence of large objects. The MTR scheme tailors the time step size-and thus implicitly the duration of the temporal basis function-on the basis of the distance between source and test element. Additionally, the voltage induced by source elements far away from the test element is interpolated in time. The hybrid method is applied to calculate the radiation properties of thin-wire antennas in presence of perfectly conducting flat scatterers to demonstrate its basic features and advantages.     

Enhancing the multivariate signal of [15O] water PETstudies with a new nonlinear neuroanatomical registration algorithm [MRIapplication]

This paper addresses the problem of neuro-anatomical registration across individuals for functional [15O] water PET activation studies. A new algorithm for three-dimensional (3-D) nonlinear structural registration (warping) of MR scans is presented. The method performs a hierarchically scaled search for a displacement field, maximizing one of several voxel similarity measures derived from the two-dimensional (2-D) histogram of matched image intensities, subject to a regularizer that ensures smoothness of the displacement field. The effect of the nonlinear structural registration is studied when it is computed on anatomical MR scans and applied to coregistered [15O] water PET scans from the same subjects: in this experiment, a study of visually guided saccadic eye movements. The performance of the nonlinear warp is evaluated using multivariate functional signal and noise measures. These measures prove to be useful for comparing different intersubject registration approaches, e.g., affine versus nonlinear. A comparison of 12-parameter affine registration versus non-linear registration demonstrates that the proposed nonlinear method increases the number of voxels retained in the cross-subject mask. We demonstrate that improved structural registration may result in an improved multivariate functional signal-to-noise ratio (SNR). Furthermore, registration of PET scans using the 12-parameter affine transformations that align the coregistered MR images does not improve registration, compared to 12-parameter affine alignment of the PET images directly.     

A new high performance phase shifter using BaxSr1-xTiO3 thin films

In this paper, a new device topology has been proposed to implement parallel plate capacitors using Ba_xSr_1-xTiO₃ (BST) thin films. The device layout utilizes a single parallel capacitor and minimizes conductor losses in the base electrode. The new design simplifies the monolithic process and overcomes the problems associated with electrode patterning. An X-band 180° phase shifter has been implemented using the new device design. The circuit provided 240° phase shift with an insertion loss of only 3 dB at 10 GHz at room temperature. We have shown a figure of merit 93°/dB at 6.3 GHz and 87°/dB at 8.5 GHz. To our knowledge, these are the best figure of merit results reported in the literature for distributed phase shifters implemented using BST films at room temperature     

The Multi-angle Imaging SpectroRadiometer science data system, its products, tools, and performance

Ground processing of data from the Multi-angle Imaging SpectroRadiometer (MISR) instrument, part of NASA's Earth Observing System (EOS), exploits new and unique science algorithms not previously used operationally. A range of data products from Level 1 through Level 3 is being produced. Because of MISR's unprecedented design, extensive prototyping was required from a relatively early stage. The data throughput is large, necessitating an innovative software design approach that maximizes performance. The systematic science processing software was developed at the Jet Propulsion Laboratory, with data processing occurring at the NASA Langley Research Center using the EOS Core System, a collaborative arrangement that works well. With the availability of actual mission data following launch on the Terra spacecraft in December 1999, MISR's computational needs have become better known, and many improvements have been made to both the science software and the production system to achieve a successful overall data processing capability. This paper provides information about MISR data for the science user, and describes the nature and scope of implementation and operations activities.     

Electric Properties of Semiconductor Nanopillars

We studied the electrical transport through epitaxial, 8 nm long and about 100 nm diameter, GaAs pillars. They are fabricated with molecular beam epitaxy using a self-assembling method called local droplet etching. The nanopillars are embedded in an AlGaAs tunneling barrier between two epitaxial GaAs layers. Because of the epitaxial growth, the pillars are connected to these GaAs layers without additional interfaces. They thus can be considered as electronic point contacts between three-dimensional electron reservoirs. Voltage-current characteristics of the structures feature a characteristic asymmetry that is not observed in reference samples. Furthermore, the behavior of the resistance in magnetic fields applied parallel and perpendicular to the current direction is compared for samples with and without pillars. Clear differences are found that are associated with current-carrying states in the pillars.