Nonwoven Ni–NiO/carbon fibers for electrochemical water oxidation

The development of technologically efficient anodes for water oxidation is crucial to improve hydrogen production via water splitting. Electrodes based on metallic active sites dispersed in carbon matrices have been shown to be an attractive way to attain this goal. However, challenges remain to prevent catalyst agglomeration that otherwise can result in a decrease of performance over time.In this work, we report an alternative and efficient method to produce nickel-nickel oxide nanoparticles-embedded in carbon nanofibers (Ni–NiO/C), by the solution blow spinning (SBS) process. Scanning electron microscopy (SEM) and transmission electron microscopy (TEM) analyses show the carbon nanofibrillar matrix as a robust support, with well-dispersed nickel nanoparticles on the surface. The responses of the linear scanning voltammetry, cyclic voltammetry and electrochemical impedance spectroscopy demonstrate how a small fraction of nickel on the fiber surface (≈1.2–5.3%) is enough to promote substantial improvement in performance (η = 278 and 309 mV vs RHE for 10 mA cm^?2) and a significant turnover frequency (TOF) values of 1.38 (η = 278) and 1.30 s^?1 (η = 309). These promising results are correlated with a large amount of Ni³⁺ present on the fiber surfaces, as identified by X-ray Photoelectron Spectroscopy (XPS). This work provides a low-cost and rapid preparation technique that can be extended for the manufacture of a wide variety of electrodes based on metals supported on carbon nanofibers.     

Influence of Copper Layer Content in the Elastic and Damping Behavior of Glass-Fiber/Epoxy-Resin Composites

The impact in the elastic behavior and internal friction, caused by the introduction of Copper layers in Glass-Fiber/Epoxy Resin composites and temperature effects, were studied and evaluated recurring to Dynamic Mechanical Analysis. It is shown that the introduction of Copper layers increases the storage modulus of the composites and delays their glass transition temperature, however, it allows a faster transformation. Additionally, it is concluded that the introduction of Copper layers elevates the internal friction during the glass transition phase by the inversion of the deformation mechanism due to thermal expansion and increase in the Poisson’s ratio of the epoxy resin to a value near 0.5 where its deformation is approximately isochoric. This increase in damping capacity is relevant in application with cyclic fatigue and mechanical vibration.     

Analysis on the feasibility of biomass power plants adding to the electric power system – Economic,regulatory and market aspects – State of Pará, Brazil

This paper presents an analysis of the feasibility of implementing biomass power plants, through thermoelectric power generation, and adding such plants to the electric system of the local electric utility by means of independent power production. Economic, regulatory, and market issues are also addressed.The biomass being considered is produced by the lumber sector, since that is one of the industrial sectors generating the largest amount of residues in a concentrated manner in the region under study, and also considering the fact that the disposal of such residues is currently difficult for the lumber companies.The locations with the largest production of residues, as well as the size of potential plants, are identified, the generation costs of the plants calculated, and the feasibility for implementing the plants is evaluated considering the market and the regulation of the Brazilian electric power sector.     

Biochemical Characterization of Purified Esterase from Soybean (Glycine max) Seed

Alkaline esterase (carboxylic‐ester hydrolases; EC 3.1.1.1) extracted from germinated soybean seeds (Glycine max) was purified approximately 3.6 times by chromatography in a DEAE‐cellulose anion exchange column and filtration in Sephadex G100 gel. The molecular mass of the enzyme was estimated at 45 kDa by gel electrophoresis (SDS‐PAGE). The purified enzyme showed a specific activity of 5.6 U mg^?1 using p‐nitrophenyl butyrate as substrate. The esterase showed optimal activity at 47 °C in moderately alkaline pH, low stability in temperatures higher than 50 °C, and high stability at pH values between 6 and 9.5. The Ca²⁺ and Co²⁺ ions proved to have a positive effect on enzyme activity; however, Hg²⁺ completely inhibited esterase activity. Using p‐nitrophenyl butyrate as substrate, the enzyme showed a K_m of 0.39 mM, V_max of 31.5 mM mg^?1 min^?1 and k_cat 7.60 × 10⁶ s^?1. Regarding substrate affinity, the enzyme showed greater activity for substrates containing short‐chain fatty acids, especially p‐nitrophenyl acetate. Such characteristics give the enzyme great potential for application in the production of low molecular weight esters, in the food industry, and in chemical products. This enzyme is another new member of the family of lipases and esterases from vegetable seeds with high activity and stability in alkaline pH.     

Phase‐shifting differential interference contrast microscope with Savart shear prism and rotatable analyser

A novel differential interference contrast microscope (DICM) is proposed in this research. It is constituted by inserting a Savart shear prism between the objective and sample of a polarising microscope having a rotatable analyser as the phase‐shifter, and it is with the ability to enhance image contrast using the principle of shearing interferometry. This letter is to introduce the configuration, interpret the interference patterns and present the experimental setup of the DICM. In addition, this letter is to display the experimental results from the uses of the setup; the results demonstrate the validity and ability of the DICM.     

Effects of Sedentarism and Treadmill Training in Mechanical Properties of Muscles of Ovariectomized Rats with High-Fat Diet

The aim of this study is to evaluate the ability of physical training in the maintenance of muscle strength in rats with HFD （high-fat diet） after OVX （ovariectomy）. Eighty Wistar rats are at eight weeks of age and weight 200 g which divided into 8 groups （n = 10） and treated for 12 weeks： GA： OVX ＋ ND （normal diet）, GB： OVX ＋ ND ＋ training, GC： sham ＋ ND, GD： sham ＋ ND ＋ training, GE： OVX ＋ HFD, GF： OVX ＋ HFD ＋ training, GG： sham ＋ HFD and GH： sham ＋ HFD ＋ training. HFD consists of standard ration for rats with addition of 30% lipids. In training groups, physical training five training/week was conducted on a treadmill with adaptation period of three weeks up to 18 m/s for one hour, training were performed for 12 weeks. The sedentary animals remained in individual box. To analyze the effects of training and diet, tensile strength tests of the gastrocnemius muscles were conducted： the speed of 0.1 mm/min. Analysis of variance was performed to compare groups. The mean （SD） obtained for the maximum load （N） were： GA 57.77 （6.89）, GB 62.74 （5.07）, GC 49.45 （6.06）, GD 59.42 （5.26） and GE 55.58 （4.72）, GF 62.50 （4.56）, GG 58.35 （4.54） and GH 56.67 （5.87）, respectively. There were no differences for maximum load between surgeries （p = 0.004） and between treatments （p = 0.000）. Differences were found also for the relationship surgery diet treatment （p = 0.007）. For the variable stiffness （N/mm）, there were not statistically significant differences： GA 5.03 （0.72）, GB 5.08 （1.09）, GC 5.17 （0.53）, GD 5.35 （0.80）, GE 5.52 （1.20）, GF 5.36 （1.07）, GG 4.83 （1.03） and GH 5.40 （0.73）. For the toughness （N/mm）, there were differences between treatments （p = 0.010） and the ratio diet treatment （p = 0.024）： GA 455.00 （107.21）, GB 541.96 （126.80）, GC 394.97 （84.67）, GD 566.90 （157.07）; GE 424.63 （113.03）, GF 478.07 （106.03）; GG 517.44 （98.65?     

Technological and organizational change in the Brazilian computer industry: A case study

Abstract

This article gives an account of the results of a case study undertaken at a pioneer and particularly prominent firm in the Brazilian computer industry: COBRA — Computadores e Sistemas Brasileiros SA.

The study is part of a research project¹ whose main goal is the identification of viable organizational and technological options that could enhance the performance of firms in the Brazilian electro‐electronics industry. Among the more important findings, it was observed that the firm has the potential to evolve to a more flexible structure, in keeping with the new requirements of the probable future market scenarios within its sector.

Everything indicated, however, that the main constraining factors for bringing about such a structure were connected with the firm's culture and beliefs and with the indirect influence of the National Policy of Information Technology upon these. An hypothesis was put forward for an organizational model, and the necessary supportive computerized technology, which could be particularly appropriate in view of the impending deregulation, of the Brazilian computer industry. Also, in the scope of the current discussion on the restructuring of this industry in terms of a greater concentration, an alternative to the prevailing school of thought was proposed, and for whose success the organizational model at issue purports to be particularly relevant.     

Are there so many sons per node in a wireless sensor network data aggregation tree?

Some authors seem to believe that the average number of sons in a Wireless Sensor Network (WSN) data aggregation tree can be kept constant, even when the distances from the sink increase. But this assumption is impossible to stand in a dense and uniformly deployed network, as the number of nodes in a given level would grow exponentially, while the perimeter just grows linearly. In this letter, it is shown that the average number of sons of a given tree node is in average a quite low number, slightly higher than one, and that it tends to 1, as the distance to sink, or node depth, increases, both for 2-D, and for 3-D WSNs.     

Conditioned and unconditioned fear organized in the inferior colliculus are differentially sensitive to injections of muscimol into the basolateral nucleus of the amygdala.

Chemical stimulation of the inferior colliculus (IC) with semicarbazide--an inhibitor of the gamma aminobutyric acid synthesizing enzyme--functions as an unconditioned stimulus in the conditioned place aversion test (CPA), and electrolytic lesions of the basolateral amygdala (BLA) enhance the aversiveness of the IC stimulation. This study examined the effects of inactivation of the BLA with muscimol on the conditioned and unconditioned fear using semicarbazide injections into the IC of rats subjected to conditioned (CPA) or unconditioned (open field) fear tests. In both tests, the rats were injected with semicarbazide or saline into the IC and muscimol or saline into the BLA. Muscimol decreased the CPA and increased the unconditioned fear elicited by IC injections of semicarbazide. These findings indicate that distinct modulatory mechanisms in the BLA are recruited during the conditioned and unconditioned fear triggered by IC activation. (PsycINFO Database Record (c) 2010 APA, all rights reserved)     

Characterization of the radical trapping activity of a novel series of cyclic nitrone spin traps

alpha-Phenyl-tert-butyl nitrone (PBN) is a nitrone spin trap, which has shown efficacy in animal models of oxidative stress, including stroke, aging, sepsis, and myocardial ischemia/reperfusion injury. We have prepared a series of novel cyclic variants of PBN and evaluated them for radical trapping activity in vitro. Specifically, their ability to inhibit iron-induced lipid peroxidation in liposomes was assessed, as well as superoxide anion (O2(-.)) and hydroxyl radical ((.)OH) trapping activity as determined biochemically and using electron spin resonance (ESR) spectroscopy. All cyclic nitrones tested were much more potent as inhibitors of lipid peroxidation than was PBN. The unsubstituted cyclic variant MDL 101,002 was approximately 8-fold more potent than PBN. An analysis of the analogs of MDL 101,002 revealed a direct correlation of activity with lipophilicity. However, lipophilicity does not solely account for the difference between MDL 101,002 and PBN, inasmuch as the calculated octanol/water partition coefficient for MDL 101,002 is 1.01 as compared to 1.23 for PBN. This indicated the cyclic nitrones are inherently more effective radical traps than PBN in a membrane system. The most active compound was a dichloro analog in the seven-membered ring series (MDL 104,342), which had an IC50 of 26 mum, which was 550-fold better than that of PBN. The cyclic nitrones were shown to trap (.)OH with MDL 101,002 being 20 25 times more active than PBN as assessed using 2-deoxyribose and p-nitrosodimethylaniline as substrates, respectively. Trapping of (.)OH by MDL 101,002 was also examined by using ESR spectroscopy. When Fenton's reagent was used, the (.)OH adduct of MDL 101,002 yielded a six-line spectrum with hyperfine coupling constants distinct from that of PBN. Importantly, the half-life of the adduct was nearly 5 min, while that of PBN is less than 1 min at physiologic pH. MDL 101,002 also trapped the O2(-.) radical to yield a six-line spectrum with coupling constants very distinct from that of the (.)OH adduct. In mice, the cyclic nitrones ameliorated the damaging effects of oxidative stress induced by ferrous iron injection into brain tissue. Similar protection was not afforded by the lipid peroxidation inhibitor U74006F, thus implicating radical trapping as a unique feature in the prevention of cell injury. Together, the in vivo activity, the stability of the nitroxide adducts, and the ability to distinguish between trapping of (.)OH and O2(-.) suggest the cyclic nitrones to be ideal reagents for the study of oxidative cell injury.