High repetition rate, wide-aperture KrF lasers for subpicosecondamplification

A high repetition rate, wide-aperture KrF laser with a magnetic switch has been developed. A dynamic response and a core loss of several magnetic materials were measured, resulting in a loss as low as 0.45 J/pulse for a voltage risetime of ~100 ns. A maximum output energy of 2.5 J in 20 ns (FWHM) was obtained with a total efficiency of 2.5% at 20 Hz. The cross section of the output beam was 65×50 mm². Spectral, spatial, and temporal profiles of gain and absorption coefficients were also measured, resulting in a peak gain of 8.5%/cm. An output energy of 410 mJ was extracted in 280 fs with two beams by using this laser as an amplifier     

Development of cable fault location method using fiber optic distributed temperature sensor

When ground-fault problems occur on a cable line, immediate fault location and restoration are required. Therefore, various new methods to locate the fault point instantaneously have been investigated to replace such conventional methods as the Murray loop method and the pulse radar method [1]. These methods require a long time to locate the fault point. One possible fault location method is to sense the temperature rise following a ground fault using a fiber optic distributed temperature sensor. Application of this method was found feasible through sensing the temperature rise at a ground-fault test using a thermocouple as a temperature sensor with test cables [4]. A power/optical composite cable was prepared experimentally and after verifying its thermal mechanical performance, the temperature rise at an incidence of a fault was determined and the anticipated performance was demonstrated in a ground-fault test. This article describes the outline of the test.     

Coherence-Based 3-D and Spectral Imaging and Laser-Scanning Microscopy

The basics of three-dimensional (3-D) and spectral imaging techniques that are based on the detection of coherence functions and other related techniques are reviewed. The principle of the 3-D source retrieval is based on understanding the propagation law of optical random field through the free space. The 3-D and spectral information are retrieved from the cross-spectral density function of optical random field or numerical calculation of the inverse propagation of the cross-spectral density. We will first introduce the coherence-based spectral tomography techniques with low-coherence light sources. These techniques limit their scheme of coherence detection only along the optical axis and some of them achieve simultaneously the high resolution and high speed of detection taking advantage of an imaging lens. We then provided explanations of the principle of 3-D source retrieval that is based on the propagation law of optical random field through the free space along with the introduction of the numerical holography and computed tomography techniques. We will lastly show 3-D spectral imaging schemes with the concurrent laser-scanning cross-sectioning techniques: one is the confocal laser scanning microscopy and the other is the two-photon laser-scanning fluorescence microscopy.     

REM sleep deprivation potentiates the effects of imipramine and desipramine but not that of clomipramine in the forced swimming test

The human amnestic syndrome associated with lesions of the hippocampus and amygdala is characterized by a selective impairment of recent (explicit, episodic) memory. Benzodiazepine (BZ) treated normal subjects demonstrate similar, marked impairments in episodic memory, but in addition, BZ also induces sedation and inattention. Thus, the amnestic effects of BZ may be secondary to drug-induced sedation. However, when subjects were pretreated with the specific BZ receptor antagonist, flumazenil, the sedative and attentional effects of diazepam were blocked, but a marked impairment in episodic memory still occurred. This demonstrates that, using neuropharmacological methods, it is possible to produce a dissociation of memory impairment from inattention and sedation. Such distinct patterns of cognitive dysfunction may serve as models for clinical cognitive syndromes.     

Some experimental findings in compression-after-impact (CAI) tests of CF/PEEK (APC-2) and conventional CF/epoxy flat plates

Compression-after-impact (CAI) tests have been conducted for quasi-isotropic thick plates with 48 plies by using the NASA method and on plates with 32 plies by using the SACMA method. Specimens are made of CF/PEEK (APC-2) and conventional CF/epoxy for the NASA plates and CF/epoxy for the SACMA plates. In the NASA CAI tests, the sequence of delamination buckling and its propagation is clearly revealed through various experimental techniques. One major technique is moiré topography, and the other is thermo-mechanical stress analysis with a high-accuracy infrared sensor. The arrest of delamination propagation just before catastrophic failure due to high fracture toughness is clearly captured by the moiré camera. This behavior provides good CAI values of CF/PEEK. The initial buckling properties of the delaminated region by the impact are then extensively discussed. Numerical predictions of initial buckling stress have been obtained by modelled geometry of the delaminated region simplified from its precise structure clarified by ultrasonic C-scanning. They agree fairly well with the experimental results. The in-plane stress distribution in the delaminated region before initial buckling is measured by an infrared stress graphic system. This compared favorably with finite element predictions. Two types of symmetric buckling modes with respect to the central plate surface, twin and single peak ones, are experimentally captured.     

Effective sludge solubilization treatment by simultaneous use of ultrasonic and electrochemical processes.

Sludge disintegration treatment by using simultaneously ultrasonic irradiation and electrolysis was investigated experimentally. A lab-scale diaphragm cell irradiated with ultrasound at a constant oscillating frequency of 20 kHz was used as a reactor. The batch experiments were carried out under different conditions of electric outputs of the ultrasonic generator, electric current for the electrolysis and different initial SS concentrations. A simultaneous treatment in the cathodic compartment without any chemical doses considerably facilitated the sludge solubilization, compared to the sonication alone. An increase in the electric current up to 400 mA under a constant ultrasonic density decreased the specific energy by 55% within the experimental range. The specific energy consumption was also reduced when the initial SS concentration increased. In addition, before carrying out the simultaneous treatment, a brief electrolysis was effective for further reduction of the specific energy and the acceleration of soluble COD generation.     

The cause of the uneven carbonization process in wet coal charging in coke oven chamber

In the case of the wet coal charging process in coke oven chamber, it is known that the coking process is uneven and a local carbonization delay occurs. The reason was investigated through a laboratory-scale experiment and a quantitative estimation. A partial carbonization test in a test coke oven replicated the uneven plastic layer and local carbonization delay. It was revealed that most of the gas generated in the uncarbonized coal layer results from the evaporation of condensed water and that steam can break through the plastic layer in a test coke oven. Moreover, the order estimation implied that steam that generates in the uncarbonized coal layer and breaks through the plastic layer has sufficient heat capacity to cool the heating wall and delay the carbonization. It was also shown that the steam pressure peak measured in a commercial coke oven is much lower than the estimated steam pressure in this study assuming steam not breaking through the plastic layer. The above-mentioned results and quantitative investigation strongly support the ‘steam breaking through the plastic layer’ theory proposed by Dr. Rohde that an uneven carbonization process is caused by vaporized coal moisture breaking through the plastic layer at definite, unforeseeable points, which results in cooling of the wall by the steam flow.     

Changes in the thermomechanical behavior of epoxy glasses under the state of strain aging

Changes in thermomechanical behavior with structural relaxation taking place in epoxy glasses were studied. Differential scanning calorimetry measurements and thermostimulated strain recovery tests were performed for specimens deformed and then aged under fixed strain. In the course of heating, the specimens started to absorb thermal energy, whereas plastic strain was still stable. At higher temperatures, plastic strain started recovery, which was accompanied by exothermic behavior of the specimen. With an increase in the aging duration, the endothermic peak signified and moved to a higher temperature. These results indicated that the longer the aging duration was, the harder the plastic strain and strain energy were frozen in the glassy structure. This freeze‐strain phenomenon was observed for crosslinked epoxy glass, as well as polymeric glasses with linear molecular structures, aged under strain. © 2007 Wiley Periodicals, Inc. J Appl Polym Sci, 2008     

NiCoFe/C cathode electrocatalysts for direct ethanol fuel cells

A direct ethanol fuel cell (DEFC), which is less prone to ethanol crossover, is reported. The cell consists of PtRu/C catalyst as the anode, Nafion^® 117 membrane, and Ni–Co–Fe (NCF) composite catalyst as the cathode. The NCF catalyst was synthesized by mixing Ni, Co, and Fe complexes into a polymer matrix (melamine-formaldehyde resins), followed by heating the mixture at 800 °C under inert atmosphere. TEM and EDX experiments suggest that the NCF catalyst has alloy structures of Ni, Co and Fe. The catalytic activity of the NCF catalyst for the oxygen reduction reaction (ORR) was compared with that of commercially available Pt/C (CAP) catalyst at different ethanol concentrations. The decrease in open circuit voltage (V_oc) of the DEFC equipped with the NCF catalysts was less than that of CAP catalyst at higher ethanol concentrations. The NCF catalyst was less prone to ethanol oxidation at cathode even when ethanol crossover occurred through the Nafion^®117 film, which prevents voltage drop at the cathode. However, the CAP catalyst did oxidize ethanol at the cathode and caused a decrease in voltage at higher ethanol concentrations.     

Surgical treatment of ventricular tachycardia after surgical repair of tetralogy of Fallot. Relation between intraoperative mapping and histological findings

BACKGROUND: The mechanism of ventricular tachycardia (VT) after correction of tetralogy of Fallot (TF) is poorly understood. The purpose of this study was to examine the histopathology of the arrhythmogenic area detected by intraoperative mapping. METHODS AND RESULTS: The patients were three men who underwent radical surgery for TF at age 3, 3, or 5 years, respectively. VT developed at 8, 9, or 11 years, respectively, after surgery, and shock developed during VT in every case. The ECG revealed monomorphic VT in two cases and polymorphic VT in one case. Induction of VT resulted in a wide left-axis deviation-pattern QRS with cycle lengths varying between 260 and 330 milliseconds. The VT origin was identified at the right ventricular outflow tract (RVOT). A radical operation was performed with the patient under cardiopulmonary bypass. On epicardial mapping, delayed activation of the RVOT was recorded during sinus rhythm, and clockwise circus movement of the macroreentry current during VT on the right ventricular free wall was documented in each case. The VTs were treated successfully by surgical resection and cryoablation of the myocardium. In every patient, histology of the myocardial specimens showed degeneration, adiposis, fibrosis, inflammatory cell infiltration, and scattered myocyte islets. These lesions corresponded anatomically to the area of myocardium in which delayed activation was evident during epicardial mapping. CONCLUSIONS: The results of this study indicate that patients with VT after radical correction of the TF have abnormal histopathological findings at the site of the prior right ventriculotomy scar. These lesions were noted within the region of delayed activation found during epicardial mapping and were found to be a part of the reentrant circuit.