Growth energetics of Lactococcus lactis subsp. lactis biovar diacetylactis in cometabolism of citrate and glucose

Certain strains of lactic acid bacteria present in commercial cheese starters, characterized by faint transparent colonies on an agar plate containing 1 mg kg ⁻¹ crystal violet (CVT), were identified as Lactococcus lactis subsp. (ssp) lactis biovar diacetylactis. The effect of citrate on the growth of these strains (CVT strains) in the presence of glucose was studied, in comparison with L. lactis strains. Molar growth yield from glucose (Y_G, g dry weight/mole of glucose consumed) for CVT strains grown on glucose plus citrate was significantly higher than the control (i.e. without citrate), but not for other L. lactis strains tested. Enhanced Y_G was also observed at a pH-controlled experiment, indicating that enhanced Y_G did not result from a buffering effect of citrate. CVT strains, in contrast to other strains of the same species, were shown to obtain enough energy to enhance Y_G on glucose–citrate mixtures.     

Ytterbium-decreasing Streptomyces sp. and its naphthoquinone-pigment production in the presence of rare-earth elements

We screened for oligotrophic microorganisms capable of decreasing the concentration of ytterbium (Yb), a representative of the heavy rare-earth elements, in a culture medium. From 476 strains of oligotrophic microorganisms (grown on 1/100 diluted nutrient agar) isolated from soil and river water samples, 5 strains capable of reducing the concentration of Yb in diluted nutrient broth containing 5 ppm Yb were selected. Among them, a strain capable of reducing the concentration of all rare-earth elements to a great extent was identified as Streptomyces sp. (strain YB-1). This strain produced redish-purple pigment(s) only in the presence of rare earths, but not in that of other metals. The pigment was extracted with ethyl acetate and purified by a series of column chromatography steps. From the results of structural analysis using ultraviolet or infrared absorption spectrometry and 13C-NMR, the pigment was determined to be a kind of naphthoquinone similar to nanaomycin produced by a Streptomyces sp. These results suggested that rare earths might affect the physiological activity of this strain.     

Iterative receiver employing phase noise compensation and channel estimation for millimeter-wave OFDM systems

This paper proposes an iterative OFDM millimeterwave receiver employing low-complexity decision-directed phase noise compensation (DD-PNC) to alleviate degradation due to the phase noise. High bit-rate OFDM transceivers based on the single-chip Si RF-CMOS IC technology in the 60-GHz millimeter-wave band have been extensively studied for wireless personal area network (WPAN) systems, and the relatively large phase noise in the phase locked loop (PLL) synthesizer severely degrades transmission performance. The proposed OFDM receiver iterates DD-PNC and decision-directed channel estimation (DDCE) by exploiting the output of the channel decoder. DDPNC estimates the phase noise each sampling time by using the decoder output, and then it removes the estimate from a time-domain received signal. In addition, DDCE estimates a channel impulse response by using the compensated received signal. Computer simulations demonstrate that in the 64QAM modulation with the coding rate of 3/4, the proposed receiver with DD-PNC and DDCE can perfectly remove the phase noise of -85 dBc/Hz at 1 MHz offset, and that it can alleviate the degradation of the channel estimation due to the phase noise.     

Compensation of oxygen defects in La-silicate gate dielectrics for improving effective mobility in high-k/metal gate MOSFET using oxygen annealing process

Oxygen incorporation for compensation of oxygen defects is investigated with La-silicate dielectrics in directly contacted with the Si substrate. The amount of oxygen is controlled by the temperature of annealing in oxygen atmosphere (oxygen annealing) and the thickness of the gate electrode. The positive shift in flatband voltage (V_FB) by oxygen incorporation is an experimental evidence for defects compensation in La-silicate dielectrics. Optimum oxygen annealing provides the V_FB shift toward positive direction without increasing equivalent oxide thickness (EOT). Although the oxygen annealing degrades the interfacial property at La-silicate/Si interface, subsequent forming gas annealing (FGA) can recover the interfacial property. It is experimentally revealed that the positive V_FB shift of La-silicate dielectrics is stable even after subsequent FGA. The supplied oxygen in La-silicate is expected to maintain even after reducing process. Movement of Fermi level toward the Si valence band edge caused by oxygen incorporation is successfully observed by XPS. Moreover, no chemical reaction between La-silicate and Si substrate by oxygen annealing are confirmed from TEM observation and analyses of X-ray photoelectron spectra. It is experimentally demonstrated that effective hole mobility can be improved without increase in EOT by combination of oxygen annealing and FGA.     

Thermoelectric Generation Using Water Lenses

A solar light concentrator composed of water and plastic transparent film has been designed. This flexible lens design can trace the solar movement through control of the tensile stress and amount of water, and concentrate the solar energy onto the thermoelectric (TE) module surface. An experimental water lens was constructed, and the concentrated intensity was monitored by a photodiode as a function of x–z position; For example, when 3.0 kg water was filled and tension of 69.0 N/m was applied to the transparent vinyl sheet, the concentration ratio was evaluated as the maximum of 28.0 at a depth of 657 mm from the water lens bottom surface. TE generation was tested to show the validity of the water lens. The surface condition of the receiver was found to be critical.     

A sub-0.5-V operating embedded SRAM featuring a multi-bit-error-immune hidden-ECC scheme

The mobile multi-media applications require to lower the operating voltage of embedded SRAMs. The ECC circuit implementation for increasing soft-error and the access timing control that tracks access delay fluctuation in memory core should be considered for the low-voltage operation. A hidden error-check-and-correction (HECC) scheme compensated the access time penalty caused by the ECC logic on the output critical path. And a multi-column ECC word assignment (MCE) increased the multi-bit-error immunity while using only 1-bit-correctable ECC which minimized area penalty. A source-level-adjusted direct sense amplifier (SLAD) and a write-replica circuit with an asymmetrical replica memory cell (WRAM) for the device-fluctuation-tolerant access control were also designed. A 130-nm CMOS 32-Kbit SRAM-macro was fabricated with these circuit techniques, which demonstrated: 1) 0.3-V operation with 6.8 MHz; 2) 30-MHz operation which is feasible for mobile use even at 0.4 V, while keeping 960MHz at 1.5 V; and 3) a reduction by 3.6/spl times/10/sup 5/ in soft-error rate compared with that of conventional ECC.     

Correlation study between VAD preform deposition surface and Germanium doping profiles

The refractive index profile of germanium doped preforms for optical fibers is determined by the radial distribution of germanium concentration. Knowing that there is a correlation between the germanium doping profile and the deposition surface profile of vapor-phase axial deposition (VAD) preforms, the study of this correlation has been carried out in order to estimate, indirectly, the refractive index profile of VAD preforms for optical fibers during the deposition stage. This correlation was studied through the parameterization of the preform deposition surface using two parameters: the power law index profile that best fits the preform bottom profile (/spl alpha/) and the axial distance from the bottom tip to a reference height (h). A range of values of these parameters to produce VAD preforms with standard and special doping profiles has been presented. Preforms with triangular index profile can be fabricated with /spl alpha/ and h values of about 2.0 and 5.0 mm, respectively, and preforms with parabolic index profiles can be produced with /spl alpha/ and h values of about 2.0 and 4.0 mm, respectively.     

Coding combinatorial sources with costs

We consider coding infinite sequences of a finite alphabet. The source is defined as a set of sequences (combinatorial source). The problem is to minimize the worst asymptotic compression ratio between each sequence and its coding output among the sequences in the combinatorial source. Ryabko showed that the optimal value coincides with the Hausdorff dimension of the combinatorial source. This correspondence extends the previous work in that the input and output costs are expressed in terms of not lengths but generalized costs. The essential quantity turns out to be the Hausdorff dimension with respect to the measure associated with the input cost. We construct an asymptotically optimal coding procedure, and also show that no coding scheme can beat the lower bound.     

A Terahertz Video Camera Patch Sheet with an Adjustable Design based on Self-Aligned, 2D,Suspended Sensor Array Patterning

Terahertz (THz) imaging is expected to become powerful tools for non-destructive inspections. To ensure the practical use of THz non-destructive monitoring, versatile THz imagers with adjustable designs that can eliminate the complexities and the bulkiness of the device are urgently required. Herein, a self-aligned filtration process for a 2D, free-standing carbon nanotube film array and its application to a THz video camera patch are reported. The presented techniques enable a) to freely design the camera size, sensor array pattern, and suspended shape according to its applications, b) to cut the camera patch into desired shapes, and c) to attach them to the objects that are intended to be measured. Real-time, non-destructive monitoring of various infrastructures is demonstrated. These results indicate that it can function regardless of restrictions, such as the shapes and locations of the measurement samples, thus providing a strong possibility for use in future non-destructive sensor networks.     

Ocular Effects of Exposure to 40, 75, and 95 GHz Millimeter Waves

The objective of this study was to develop a model of ocular damage induced by 40, 75, and 95 GHz continuous millimeter waves (MMW), thereby allowing assessment of the clinical course of ocular damage resulting from exposure to thermal damage-inducing MMW. This study also examined the dependence of ocular damage on incident power density. Pigmented rabbit eyes were exposed to 40, 75, and 95 GHz MMW from a spot-focus-type lens antenna. Slight ocular damage was observed 10 min after MMW exposure, including reduced cornea thickness and reduced transparency. Diffuse fluorescein staining around the pupillary area indicated corneal epithelial injury. Slit-lamp examination 1 day after MMW exposure revealed a round area of opacity, accompanied by fluorescence staining, in the central pupillary zone. Corneal edema, indicative of corneal stromal damage, peaked 1 day after MMW exposure, with thickness gradually subsiding to normal. Three days after exposure, ocular conditions had almost normalized, though corneal thickness was slightly greater than that before exposure. The 50% probability of ocular damage (DD₅₀) was in the order 40?>?95?≈?75 GHz at the same incident power densities.