Stages of surface erosion under ion irradiation

Initial stages of surface erosion have been studied for NaCl and LiF single crystals bombarded by Ar⁺ ions with 20 keV. For irradiation with doses D=10¹⁰-10¹¹ ions/cm², exoelectron emission has been used, whereas for higher doses, we have used electron microscopy. Two stages of initial surface erosion have been identified; for small doses, there is slow development of atomic-scale roughening, which reaches its peak when areas damaged by closest incident ions start to overlap, and then, beginning with D=10¹⁶ ions/cm², there is rapid etching, deep into the crystal, followed by the emergence of secondary microscopic structure, i.e. caverns, concentric closed steps and terraces. Ion-induced surface structure of alkali halide crystals has been shown to depend strongly on the presence of foreign particles on the surface, as well as on segregation. Topography of thin carbon films and some metals have been discussed.     

Cointegration of Gate-All-Around MOSFETs and Local Silicon-on-Insulator Optical Waveguides on Bulk Silicon

In this work we present a bulk silicon technology platform able to cointegrate gate-all-around (GAA) MOSFETs and local SOI waveguides with pentagonal cross section. Wire diagonals of 100-800 nm are obtained using a lithographic resolution of 0.8 mum. Well-functioning triangular multigate MOSFETs are reported, and tested up to 150 degC. A significant increase is observed in the low-field mobility mu₀ for small devices (W_effles500 nm), which is attributed to local volume inversion in the corners. Preliminary characterization of the optical waveguides is carried out, showing optical losses of a few dB/cm. The processing is entirely CMOS compatible, does not require access to advanced lithography equipment, and is based on a silicon bulk substrate. Thus, this technology might serve as the basis for a low-cost, high-performance optical signaling platform     

Microstructural Investigation on Failure of Internal Drive Shaft

17-4 PH stainless steel is used as internal drive shaft material in liquid engine pumps. One of the drive shafts failed during operation. The shaft pieces were in contact for short duration after failure, which has resulted in abrasion of fractured surfaces. Samples from the location of failure were taken, and investigation of the failure was carried out using optical and scanning electron microscopy. The microstructural analysis of the material and fractographic analysis of the fractured surface show that the failure was caused by excessive torsion.     

Model for Nanoscopic Domain Formation in Dipalmitoyl-PC/Dilauroyl-PC/Cholesterol Mixture

We describe the lyotropic liquid crystalline phase transitions in the lipid mixture dipalmitoil-PC/dilauroy-PC/cholesterol by 3D spin-1 lattice model. The formation of nanoscale domains with the characteristic size about 300 nm was studied in experiments on confocal fluorescence microscopy (CFM) (G. V. Feigenson and J. T. Buboltz, Biophys. J. 80, 2775 (2001)). The structure parameters of the lamellar vesicle in dipalmitoil-PC-rich phase, corresponding to these regions, are verified by numerical Monte Carlo simulations on the lattice. We point its superconductivity analogy properties at the region of phase stability for composition-dependent nanoscopic region.     

Unconventional Charge Density Wave Arising from Electron–Phonon Interaction

We report of a theoretical study on quasi-one dimensional unconventional charge density wave (UCDW) driven by electron–phonon interaction. Within mean field theory, we find that the wavevector dependence of the coupling leads to a momentum dependent single particle gap on the Fermi surface. The presence of small energy single particle excitations around the gap nodes significantly changes the optical conductivity compared to the conventional CDW result. In addition to that, the collective phase excitation arising from fluctuation of the order parameter leads to further qualitative changes of the conductivity and results in an effective mass that is nonmonotonic in temperature.      

Controlling the Critical Temperature in Mg1−x Al x B2

Here we report synthesis and characterization of high quality samples of the superconducting system Mg_1−x Al _x B₂, with a novel optimized preparation method, in a wide range of Al concentration. All the physical properties of the samples can be tuned continuously with increasing Al content. We have characterized the samples for their structural, morphological and magnetic properties with high resolution XRD, SEM-EDS and susceptibility measurements. We have prepared a large number of Al doped MgB₂ in the range 0<x<0.57. All the samples are bulk superconductors and the critical temperature show a smooth and regular behavior as a function of x. This work was supported by European project 517039 “Controlling Mesoscopic Phase Separation” (COMEPHS) (2005). An erratum to this article can be found at     

Thermoelectric Converters of Human Warmth for Self-Powered Wireless Sensor Nodes

Solar cells are the most commonly used devices in customer products to achieve power autonomy. This paper discusses a complementary approach to provide power autonomy to devices on a human body, i.e., thermoelectric conversion of human heat. In indoor applications, thermoelectric converters on the skin can provide more power per square centimeter than solar cells, particularly in adverse illumination conditions. Moreover, they work day and night. The first sensor nodes powered by human heat have been demonstrated and tested on people in 2004-2005. They used the state-of-the-art 100-muW watch-size thermoelectric wrist generators fabricated at IMEC and based on custom-design small-size BiTe thermopiles. The sensor node is completed with a power conditioning module, a microcontroller, and a wireless transceiver mounted on a watchstrap     

Sorption Recovery of 137Cs and 90Sr with Carbonate-Containing Natural Mineral Tripolite

The sorption characteristics of a carbonate-containing mineral (tripolite) were studied on model aqueous solutions and real wastewaters in a wide range of pH in the presence of isotopic and nonisotopic carriers and organic impurities. The sorption of ¹³⁷Cs and ⁹⁰Sr is adequately described by a power function. Analysis of ¹³⁷Cs sorption isotherms suggests that radiocesium is adsorbed by the ion-exchange mechanism, during which Cs⁺ ions from the solution exchange mainly with bivalent ions of the sorbent, whereas in ⁹⁰Sr sorption trivalent ions of the sorbent also participate in the process. The saturation capacities of tripolite with respect to cesium and strontium were evaluated to be 0.3 and 1.0 mg-equiv g^{- 1}, respectively.     

Interlaboratory ring test of time-resolved fluoroimmunoassays for zeranol and alpha-zearalenol and comparison with zeranol test kits.

Many zeranol immunoassay test kits cross-react with toxins formed by naturally occurring Fusarium spp. fungi, leading to false-positive screening results. This paper describes the evaluation and application of recently published, dry reagent time-resolved fluoroimmunoassays (TR-FIA) for zeranol and the toxin alpha-zearalenol. A ring test of bovine urine fortified with zeranol and/or alpha-zearalenol in four European Union National Reference Laboratories demonstrated that the TR-FIA tests were accurate and robust. The alpha-zearalenol TR-FIA satisfactorily quantified alpha-zearalenol in urine fortified at 10-30 ng ml(-1). The specificity-enhanced zeranol TR-FIA accurately quantified zeranol in the range 2-5 ng ml(-1) and gave no false-positive results in blank urine, even in the presence of 30 ng ml(-1) alpha-zearalenol. Zeranol TR-FIA specificity was demonstrated further by analysing incurred zeranol-free urine samples containing natural Fusarium spp. toxins. The TR-FIA yielded no false-positive results in the presence of up to 22 ng ml(-1) toxins. The performance of four commercially available zeranol immunoassay test kits was more variable. Three kits produced many false-positive results. One kit produced only one potential false-positive using a protocol that was longer than that of the TR-FIA. These TR-FIAs will be valuable tools to develop inspection criteria to distinguish illegal zeranol abuse from contamination arising from in vivo metabolism of Fusarium spp. toxins.     

1/f noise and self-organized criticality in crisis regimes of heat and mass transfer

Thermal fluctuations under the transition from nucleate to film boiling of water on a wire heater and fluctuations of jet form during an outflow of superheated liquid from a pressure vessel were experimentally investigated. It has been found that power spectrum of the fluctuations has got a low frequency component corresponding to a 1/f law (flicker noise).The effect given is connected with the occurrence of nonequilibrium phase transitions in the systems: a crisis of heat transfer under the transition from nucleate to film boiling and a crisis of a flow in boiling-up of superheated liquid jet.