Design and construction of expanded polystyrene embankments Practical design methods as used in the United Kingdom

This paper covers the history of the use of expanded polystyrene ( ) in light weight fill for road embankments. UK design requirements and physical properties of the foam are covered together with two case studies.     

Far-off and close-up dry matter intake modulate indicators of immunometabolic adaptations to lactation in subcutaneous adipose tissue of pasture-based transition dairy cows

The common practice of increasing dietary energy density during the close-up dry period (last ～3 wk prepartum) has been recently associated with a higher incidence of metabolic disorders after calving. Despite these reports, over-feeding of metabolizable energy (ME) during the far-off, nonlactating period is a common management policy aimed at achieving optimum calving body condition score (BCS) in pasture-based systems, as cows are generally thinner than total mixed ration cows at the end of lactation. Our hypothesis was that both far-off and close-up overfeeding influence the peripartum adipose tissue changes associated with energy balance and inflammatory state. Sixty mid-lactation, grazing dairy cows of mixed age and breed were randomly allocated to 1 of 2 groups that were managed through late lactation to achieve a low and high BCS (approximately 4.25 and 5.0 on a 10-point scale) at dry-off. The low BCS cows were then overfed ME to ensure that they achieved the same BCS as the higher BCS group by calving. Within each rate of BCS gain treatment, cows were offered 65, 90, or 120% of their pre-calving ME requirements for 3 wk pre-calving in a 2 × 3 factorial arrangement of treatments (i.e., 10 cows/treatment). Subcutaneous adipose tissue was collected via biopsy at ?1, 1, and 4 wk relative to parturition. Quantitative PCR was used to measure mRNA and microRNA expression of targets related to adipogenesis and inflammation. Cows overfed in the far-off period had increased expression of miR-143 and miR-378 prepartum (?1 wk) indicating greater adipogenesis, consistent with their rapid gain in BCS following dry-off. Furthermore, the lower postpartum expression of IL6, TNF, TLR4, TLR9, and miR-145, and a higher abundance of miR-99a indicated lower body fat mobilization in early lactation in the same group. In the close-up period, feeding either 65 or 120% of ME requirements caused changes in FASN, IL1B, IL6R, TLR9, and the microRNA miR-143, miR-155, and miR-378. Their respective expression patterns indicate a tentative negative-feedback mechanism in metabolically compromised, feed-restricted cows, and a possible immune-related stimulation of lipolysis in apparently static adipocytes in overfed cows. Data from cows fed 90% of ME requirements indicate the existence of a balance between lipolytic (inflammatory-related) and anti-lipolytic signals, to prime the mobilization machinery in light of imminent lactation. Overall, results indicate that far-off dry cow nutrition influences peripartum adipose tissue metabolism, with neither strategy negatively affecting the physiological adaptation to lactation. Furthermore, to ensure a favorable transition, cows should be subjected to a small feed restriction in the close-up period, irrespective of far-off nutritional management.     

Overview and Lessons from More Than a Decade of Feeder Life Management

This paper provides an overview of the degradation in CANDU~a （Canadian Deuterium Uranium） feeders in operating plants observed from the mid 1990s onward. The degradation has been dominated by feeder wall thinning, caused by FAC （flow accelerated corrosion） and feeder cracking. This paper summarizes the industry＇s response to the discovery of these two degradation mechanisms and the methodologies, tools and technologies developed to monitor the degradation and assess the continued fitness for service to manage the plant life. This paper identifies some of the lessons gained from more than a decade of industry effort, and discusses how these lessons are being implemented in the refurbished and new CANDU plants. CANDU~a is a registered trademark of Atomic Energy of Canada Limited.     

Errors resulting from the reflectivity of calibration targets

For a microwave total-power radiometer, we consider the error introduced by neglecting the difference in the antenna reflection coefficient between when it views a distant scene and when it views a nearby calibration target. An approximate expression is presented for the error, and measurements are described that enable one to estimate the resulting uncertainty in the measured brightness temperature. The measurement results are presented for several combinations of antenna and calibration target. The resulting uncertainty ranges from about 0.1 K to several kelvins for the representative cases considered.     

Interface and layer thickness dependence of the effective mass in InAs/GaSb superlattices studied by high field cyclotron resonance

The effective mass has been studied in a series of semiconducting and semimetallic InAs/GaSb superlattices as a function of superlattice period and band gap. The mass is found to be determined almost entirely by the superlattice period, and is relatively insensitive to both the ratio of the InAs to GaSb thickness, and the structure of the interface layer, which was grown as both a monolayer of InSb and GaAs. Using pulsed magnetic fields of up to 180 T it was possible to observe spin-split cyclotron resonance at room temperature for all samples studied. On cooling the spin-splitting was found to be temperature dependent. This is attributed to the importance of electron-electron interactions which couple the two spin transitions as observed recently in high purity GaAs/GaAlAs heterojunctions at low temperatures.     

Experimental Verification of the Thermodynamics of Critical Aspects of the Carbothermic Reduction of Alumina. Part II: Thermogravimetric Study of the Reaction of Al2O3–C Mixtures and the Al2O3–Al4C3 Phase Diagram

The thermodynamics of several aspects of the carbothermic reduction of alumina have been examined. In Part I, the results of measuring the evolved CO from the reaction between Al₂O₃ and C mixtures were used to determine the temperature and carbon contents for carbide formation at alumina saturation and at carbide saturation in the Al₂O₃–Al₄C₃ system. In this part of the paper, results are presented for a thermogravimetric study of the reactions of Al₂O₃ with carbon, as well as those for the determination of the Al₂O₃ liquidus line and the Al₂O₃–Al₄O₄C eutectic in the Al₂O₃–Al₄C₃ phase diagram. The critical temperature for Al₂O₃ and C to react, producing gas at 1 atm., was in agreement with that predicted from thermodynamics and measured in Part I of this paper. However, the Al₂O₃ liquidus appeared to be steeper and the eutectic temperature lower than the predicted phase diagram.     

The effect of a helmet on cognitive performance is,at worst,marginal: A controlled laboratory study

The present study looked at the effect of a helmet on cognitive performance under demanding conditions, so that small effects would become more detectible. Nineteen participants underwent 30 min of continuous visual vigilance, tracking, and auditory vigilance (VTT + AVT), while seated in a warm environment (27.2 (±0.6) °C, humidity 41 (±1)%, and 0.5 (±0.1) m s⁻¹ wind speed). The participants wore a helmet in one session and no helmet in the other, in random order. Comfort and temperature perception were measured at the end of each session. Helmet-wearing was associated with reduced comfort (p = 0.001) and increased temperature perception (p < 0.001), compared to not wearing a helmet. Just one out of nine cognitive parameters showed a significant effect of helmet-wearing (p = .032), disappearing in a post-hoc comparison. These results resolve previous disparate studies to suggest that, although helmets can be uncomfortable, any effect of wearing a helmet on cognitive performance is at worst marginal.     

Improvement of fuel properties of cottonseed oil methyl esters with commercial additives

The low temperature operability and oxidative stability of cottonseed oil methyl esters (CSME) were improved with four anti‐gel additives as well as one antioxidant additive, gossypol. Low temperature operability and oxidative stability of CSME was determined by cloud point (CP), pour point (PP), cold filter plugging point (CFPP), and oxidative stability index (OSI). The most significant reductions in CP, PP, and CFPP in all cases were obtained with Technol®, with the average reduction in temperature found to be 3.9 °C. Gunk®, Heet®, and Howe's® were progressively less effective, as indicated by average reductions in temperature of 3.4, 3.0, and 2.8 °C, respectively. In all cases, the magnitude of CFPP reduction was greater than for PP and especially CP. Addition of gossypol, a polyphenolic aldehyde, resulted in linear improvement in OSI (R² = 0.9804). The OSI of CSME increased from 5.0 to 8.3 h with gossypol at a concentration of 1000 ppm.     

Photopolymerizable Reproduction Systems Chemistry and Applications*

Several practical reproduction systems are based on photopolymerization. This review describes the chemistry of photopolymerization including absorption of radiant energy, photogeneration of free radicals, the polymerization reaction, inhibition, and methods of image detection and readout. Sensitometry is presented together with the performance of several commercial photographic applications of photopolymerization.     

Structural Influence on the Thermal Conversion of Self‐Catalyzed HfB2/ZrB2 Sol–Gel Precursors by Rapid Ultrasonication of Oxychloride Hydrates

Sol–gel precursors to HfB₂ and ZrB₂ are processed by high‐energy ultrasonication of Hf,Zr oxychloride hydrates, triethyl borate, and phenolic resin to form precipitate‐free sols that turn into stable gels with no catalyst addition. Both precursor concentration and structure (a sol or a gel) are found to influence the synthesis of the diboride phase at high temperature. Decreasing sol concentration increases powder surface area from 3.6 to 6.8 m²/g, whereas heat‐treating a gel leads to residual oxides and carbides. Particles are either fine spherical particles, unique elongated rods, and/or platelets, indicating particle growth with directional coarsening. Investigation of the conversion process to ZrB₂ indicates that a multistep reaction is likely taking place with: (1) ZrC formation, (2) ZrC reacts with B₂O₃ or ZrC reacts with B₂O₃ and C to form ZrB₂. At low temperatures, ZrC formation is limiting, while at higher temperatures the reaction of ZrC to ZrB₂ becomes rate limiting. ZrC is found to be a direct reducing agent for B₂O₃ at low temperature (~1200°C) to form ZrB₂ and ZrO₂, whereas at high temperatures (~1500°C) it reacts with B₂O₃ and C to form pure ZrB₂.