The effect of climate variations on glulam—an experimental study

Climate variations affect timber structures by causing moisture induced stresses which may lead to cracks in timber members. The paper presents experimentally determined moisture induced stresses that arise perpendicular to the grain of glulam specimens during exposure to 1-dimensional drying and wetting. Although to a certain extent reduced by creep effects, the determined tensile stresses can significantly exceed the characteristic tensile strength of glulam. Additional measurements of moduli of elasticity (E) and hygroexpansion coefficients (α) revealed that these parameters are strongly affected by the geometrical configuration (pith locations) of the specimens. By means of all the parameters determined here, it can be avoided that parameters have to be selected from different literature sources, which introduces large uncertainties into the numerical simulations.     

Longitudinal Dissemination of Salmonella enterica Clonal Groups through the Slaughter Process of Salmonella-Positive Pig Batches

This study was conducted to assess the dissemination of Salmonella clonal groups in slaughterhouses that received batches of Salmonella -positive pigs and used different routine processing procedures. Eight serial sampling sessions were conducted in three slaughterhouses (A, B, and C). Blood was collected randomly (n = 25) from each batch of pigs and processed for serology. Carcasses (n = 12) were identified and sampled after dehairing, after singeing, after evisceration, and before chilling. A section of cecum also was collected. Salmonella isolates were submitted to pulsed-field gel electrophoresis. The overall seroprevalence of Salmonella was 80.6% (316 of 392 samples), and cecal contents were positive for Salmonella in 23.8% (26 of 109) of the pigs sampled. Carcasses after dehairing had a significantly higher prevalence of Salmonella (P = 0.004) and the highest Salmonella levels (median ～ 0.26 log CFU/300 cm(2)). The singeing step significantly affected the Salmonella status of the carcasses (P = 0.001); however, the efficacy of singeing differed among slaughterhouses. In the prechilling step, 14.7% (16 of 109) of the carcasses were positive for Salmonella. Salmonella pulsotypes found on the prechill carcasses were also found in the lairage, in the cecal contents, and on carcasses after dehairing, suggesting that the main source of contamination was the slaughter process before singeing. Slaughterhouse C was the most likely (odds ration [OR] ～ 6.51) to have pigs carrying Salmonella in the gut, and slaughterhouse B was the most likely (OR ～ 14.66) to have contaminated carcasses at the prechilling step. These findings indicate that the procedures adopted in slaughterhouse B contributed to the spread of Salmonella strains. In contrast, in slaughterhouse C the Salmonella strains carried by the pigs or found in the lairage were not recovered from prechilled carcasses, validating the effectiveness of the slaughterhouse interventions. These results indicate that an effective slaughter process can help decrease the number of Salmonella-positive carcasses in slaughterhouses that receive Salmonella-positive pig batches.     

Transfer of Salmonella Enteritidis to four types of surfaces after cleaning procedures and cross-contamination to tomatoes

The objectives of the present study were to evaluate the spread of Salmonella Enteritidis to different cutting boards (wood, triclosan-treated plastic, glass, and stainless steel) from contaminated poultry skin (5 log CFU/g) and then to tomatoes and to analyze the effect of different protocols used to clean these surfaces to control contamination. The following procedures were simulated: (1) no cleaning after handling contaminated poultry skin; (2) rinsing in running water; (3) cleaning with dish soap and mechanical scrubbing; and (4) cleaning with dish soap and mechanical scrubbing, followed by disinfection with hypochlorite. The pathogen was recovered from all surfaces following procedure 1, with counts ranging from 1.90 to 2.80 log, as well as from the tomatoes handled on it. Reduced numbers of S. Enteritidis were recovered using the other procedures, both from the surfaces and from the tomatoes. Counts were undetectable after procedure 4. From all surfaces evaluated, wood was the most difficult to clean, and stainless steel was the easiest. The use of hypochlorite as a disinfecting agent helped to reduce cross-contamination.     

Water footprint of European cars: potential impacts of water consumption along automobile life cycles

Due to global increase of freshwater scarcity, knowledge about water consumption in product life cycles is important. This study analyzes water consumption and the resulting impacts of Volkswagen's car models Polo, Golf, and Passat and represents the first application of impact-oriented water footprint methods on complex industrial products. Freshwater consumption throughout the cars' life cycles is allocated to material groups and assigned to countries according to import mix shares or location of production sites. Based on these regionalized water inventories, consequences for human health, ecosystems, and resources are determined by using recently developed impact assessment methods. Water consumption along the life cycles of the three cars ranges from 52 to 83 m(3)/car, of which more than 95% is consumed in the production phase, mainly resulting from producing iron, steel, precious metals, and polymers. Results show that water consumption takes place in 43 countries worldwide and that only 10% is consumed directly at Volkswagen's production sites. Although impacts on health tend to be dominated by water consumption in South Africa and Mozambique, resulting from the production of precious metals and aluminum, consequences for ecosystems and resources are mainly caused by water consumption of material production in Europe.     

Uptake of fluoride from aqueous solution on nano-sized hydroxyapatite: examination of a fluoridated surface layer

Hydroxyapatite (Ca(10)(PO(4))(6)(OH)(2), HAP), both as a synthetic material and as a constituent of bone char, can serve as an effective and relatively inexpensive filter material for fluoride (F(-)) removal from drinking water in low-income countries. Fluoride uptake on HAP can occur through different mechanisms, which are, in principle, influenced by solution composition. Suspensions of HAP (2 g L(-1)) were equilibrated under controlled pH conditions (pH 6.5, 7.3, 9.5) at 25 °C for 28 d after the addition of different F(-) concentrations (0.5-7.0 mM). The reacted HAP solids were examined with Transmission Electron Microscopy (TEM), Fourier Transform Infrared Spectroscopy (FTIR), X-ray Photoelectron Spectroscopy (XPS), and Nano Secondary Ion Mass Spectroscopy (NanoSIMS). Fluoride uptake on HAP was dependent on pH, with the highest capacity at pH 6.5; the lowest uptake was found at pH 9.5. Under all experimental conditions, the thermodynamically stable mineral phase was fluorapatite, (Ca(10)(PO(4))(6)F(2), FAP). Fluoride uptake capacity was quantified on the basis of FTIR and XPS analysis, which was consistent with F(-) uptake from solution. The results of XPS and NanoSIMS analyses indicate that a fluoridated surface layer with a thickness of several nanometers is formed on nanosized HAP.     

Increased mercury loadings to western Canadian alpine lakes over the past 150 years

We reconstructed historical trends in mercury (Hg) accumulation over the past ～ 150 years in nine western Canadian alpine lakes. Recent Hg accumulation rates (fluxes) ranged between ～ 7 and 75 μg m(-2) yr(-1), which were an average of 1.8 times higher than preindustrial (i.e., pre-1850) fluxes. Increased Hg fluxes in these lakes were less than at lower elevation sites, showing that despite the potential for increased deposition, alpine lakes are no more susceptible to Hg accumulation. Unlike other studies, we found that geographic setting, changes in chlorophyll-inferred algal production, and climate were not significant predictors of [Hg] or Hg flux in lakes. Instead, our findings highlight how a combination of atmospheric deposition and site-specific processes, including organic matter supply and catchment weathering, better explain sequestration of Hg in alpine lakes.     

Cyclocondensation of 2,3-butanedione in the presence of amino acids and formation of 4,5-dimethyl-1,2-phenylendiamine

The chemical interaction of 2,3-butanedione with amino acids through Strecker reaction has been studied extensively. However, the formation of previously reported 4,5-dimethyl-1,2-benzoquinone from 2,3-butanedione/amino acid model systems has not been investigated in detail. In this study such model systems containing 2,3-butanedione were investigated under pyrolytic conditions using glycine, sodium glycinate and glycine hydrochloride as amino acids able to modulate acid/base catalytic activity of the reaction medium. The analysis of the data indicated that replacing glycine with its corresponding salts promoted significantly the generation of 2,3,6,7-tetramethylquinoxaline relative to tetramethylpyrazine, the indicator compound for the Strecker reaction. The origin of the 2,3,6,7-tetramethylquinoxaline was traced back to the formation of 4,5-dimethyl-1,2-benzoquinone through isotope labelling studies. Furthermore, these studies have also indicated the ability of glycine not only to catalyse the cyclocondensation of butanedione into 4,5-dimethyl-1,2-benzoquinone but also its conversion into 4,5-dimethyl-1,2-phenylenediamine through Strecker-type transformations. The trapping of 2,3-butanedione by this in situ generated 4,5-dimethyl-1,2-phenylenediamine gave rise to the observed 2,3,6,7-tetramethylquinoxaline.     

Effects of pectinolytic yeast on the microbial composition and spoilage of olive fermentations

This study resulted in the identification of pectinolytic yeasts in directly brined Sicilian-style green olive fermentations and examination of the influence of those yeasts on the microbial composition and quality of fermented olives. Firstly, defective olives processed in Northern California from 2007 to 2008 and characterized by high levels of mesocarp tissue degradation were found to contain distinct yeast and bacterial populations according to DNA sequence-based analyses. Strains of (pectinolytic) Saccharomyces cerevisiae, Pichia manshurica, Pichia kudriavzevii, and Candida boidinii isolated from directly brined olives were then inoculated into laboratory-scale olive fermentations to quantify the effects of individual yeast strains on the olives. The pH, titratable acidity, and numbers of lactic acid bacteria (LAB) and yeasts varied between the fermentations and fermentations inoculated with P. kudriavzevii and C. boidinii promoted the development of LAB populations. Olive tissue structural integrity declined significantly within 30, 74, and 192 days after the inoculation of pectinolytic S. cerevisiae, P. manshurica and C. boidinii, respectively. In comparison, tissue integrity of olives in control fermentations remained intact although pectinolytic yeasts were present. Notably, pectinolytic yeasts were not found in fermentations inoculated with (non-pectinolytic) P. kudriavzevii and olives exposed to a 1:1 ratio of P. kudriavzevii and P. manshurica exhibited no significant tissue defects. This study showed that pectinolytic yeast are important components of directly brined green olive fermentations and damage caused by pectinolytic yeasts might be prevented by other microbial colonists of the olives.