除尘器新型褶式滤筒的结构优化及系列化设计

以新型褶式滤筒为研究对象,选取滤筒褶数N_2、褶夹角θ、褶高h、过滤风速v为影响因子,除尘器压力损失为响应值,基于响应曲面法分析影响因子对压力损失的影响,建立滤筒除尘器压力损失的预测模型并得到滤筒褶皱结构最优参数。以滤筒内径D、筒体高度D_1为标准尺寸,依据相关国家标准设计滤筒筒体部分;以锥体高度D_2、锥体上圆直径D_3为系列尺寸,利用尺寸变化法设计锥体部分;通过Access软件建立滤筒产品数据库。结果表明:当θ=5.2°,N_2=50,v=0.01 m/s,h=0.035 m时,除尘器压力损失最低;当D_1=1 000 mm,D=320 mm时,D_2和D_3最佳值分别为600,130 mm,故采用D_2/D_1=0.6,D_3/D=0.4的比值设计相应滤筒锥体系列。     

A distributed energy system integrating SOFC-MGT with mid-and-low temperature solar thermochemical hydrogen fuel production

Solar thermochemical hydrogen production with energy level upgraded from solar thermal to chemical energy shows great potential. By integrating mid-and-low temperature solar thermochemistry and solid oxide fuel cells, in this paper, a new distributed energy system combining power, cooling, and heating is proposed and analyzed from thermodynamic, energy and exergy viewpoints. Different from the high temperature solar thermochemistry (above 1073.15 K), the mid-and-low temperature solar thermochemistry utilizes concentrated solar thermal (473.15–573.15 K) to drive methanol decomposition reaction, reducing irreversible heat collection loss. The produced hydrogen-rich fuel is converted into power through solid oxide fuel cells and micro gas turbines successively, realizing the cascaded utilization of fuel and solar energy. Numerical simulation is conducted to investigate the system thermodynamic performances under design and off-design conditions. Promising results reveal that solar-to-hydrogen and net solar-to-electricity efficiencies reach 66.26% and 40.93%, respectively. With the solar thermochemical conversion and hydrogen-rich fuel cascade utilization, the system exergy and overall energy efficiencies reach 59.76% and 80.74%, respectively. This research may provide a pathway for efficient hydrogen-rich fuel production and power generation.     

秸秆微晶纤维素用作片剂崩解剂的初步评价

对实验室自制秸秆微晶纤维素用作片剂崩解剂进行了初步评价。参照《中国药典》(2010版)中微晶纤维素的有关规定,评估自制秸秆微晶纤维素的质量;以阿司匹林为模型药物,以市售微晶纤维素(PH-101)为对照,测定秸秆微晶纤维素的溶胀性、崩解性。结果表明,自制的秸秆微晶纤维素质量符合《中国药典》有关规定,且溶胀性和崩解性优于市售微晶纤维素(PH-101),可用作片剂崩解剂。在秸秆微晶纤维素含量为20%时,崩解速度最快。     

氯甲烷在镁修饰的ZSM-5分子筛催化剂上催化转化研究

在镁修饰的ZSM-5分子筛催化剂上,氯甲烷可以被催化转化为烃类产品。分别采用了离子交换和浸渍的方法来修饰ZSM-5分子筛。离子交换的Mg-ZSM-5催化剂和浸渍的Mg/ZSM-5催化剂都可以提高反应产物中的低碳烯烃的选择性,降低烷烃的选择性,并且保持较高的反应活性,但高的浸渍量对反应活性有一定的影响。NH3-TPD的结果表明,浸渍镁的ZSM-5催化剂的强酸中心数目明显减少。镁的修饰对催化剂酸性的影响导致了产物中低碳烯烃的增加。浸渍Mg的ZSM-5催化剂是潜在氯甲烷转化生成低碳烯烃的催化剂。     

长江下游船舶溢油应急处理措施框架

介绍长江下游船舶溢油污染的现状,论述溢油污染对沿岸生态和环境的影响以及溢油防治研究的重要性。以长江南京段为例,分析影响江中及岸边事故溢油迁移转化规律的因素,提出船舶事故溢油应急处理措施的三个重要部分,即溢油模拟及污染区预测、溢油清除回收和溢油风险评价。针对三个部分提出了具体的研究内容,为国内各大中型江河不同河段的船舶溢油的研究提供参考。     

铁塔加工中型材零件优化下料管理系统

介绍了铁塔加工中角钢零件优化下料管理系统,阐明了系统的模块化结构及工作原理。建立的面向角钢加工工艺的优化下料管理系统可以将生产管理与下料优化两大功能整合为一体,使用极为方便。该系统在铁塔生产中,可节省大量材料,有效地提高了企业的经济效益。     

Structure, properties, and thermal stability of nanocrystallite Fe-Ti-N soft magnetic films

We deposited Fe-Ti-N magnetic films with a high sputtering power of 7 W/cm/sup 2/. When the composition of the films was in the range of Fe-Ti(3.9 at.%)-N(8.8 at.%) to Fe-Ti(3.3 at.%)-N(13.5 at.%), the films were composed of /spl alpha/' and Ti/sub 2/N precipitates. With the addition of nitrogen, 4/spl pi/M/sub s/ became higher than that of pure iron, reaching a maximum of 23.8 kG. At the same time, H/sub c/ was reduced to a minimum of 1.12 Oe. The best films can meet the needs of the recording head in dual-element giant magnetoresistive/inductive heads, yielding high storage density (10 Gb/in/sup 2/). The incorporation of N in /spl alpha/-Fe brought about the /spl alpha/' phase with its higher saturation magnetization. Ti additions inhibited the equilibrium decomposition /spl alpha/'/spl rarr//spl alpha/+/spl gamma/'. Because H/sub C//sup D//spl prop/D/sup 6/, where D is average grain diameter, grain size control is very important. The nitrogen induces severe distortion of the /spl alpha/' lattice, which can cause the grains to break into pieces and reduce the grain size. High sputtering power also led to the formation of fine grains, with diameter in the order of 14 nm. Probably Ti/sub 2/N is preferentially precipitated on the grain boundary, pinning the grain boundary and stabilizing the grain size during high-temperature heat treatment. The temperature limit for stability of the structure and its associated low coercivity was not less than 520/spl deg/C.     

压电驱动器迟滞特性的Preisach模型研究

压电驱动器的迟滞特性是影响其位移输出精度的主要因素。该文采用改进的Preisach模型对压电驱动器的迟滞特性进行建模，并进行了相应的实验研究。实验结果表明该模型可以很好地预测压电驱动器在经过一定的控制电压序列以后的位移输出值．能够有效地降低迟滞特性对压电驱动器位移输出精度的影响。     

3G用户细分研究

对3G用户的细分方法及3G目标市场的定位进行了初步的研究，提出了3G用户细分的体系框架和3G目标市场定位的考虑要素及初步的定位建议。