In this study, several trialkylamines were immobilized on chloromethylated polystyrene (CMPS), silica gel, and alumina to prepare triphase catalysts for catalyzing the etherification reaction of allyl bromide (the organic reactant) and sodium phenolate (the aqueous reactant). The reactor was agitated mechanically or with the aid of ultrasonic vibration. Performances of the prepared catalysts were compared, and the effect of imposing ultrasound was investigated based on the activity, selectivity, and stability of the catalyst. Experimental results show that tri-n-propylamine is the best active species when CMPS is used as the support, while tri-n-butylamine is the best when SiO2 and Al2O3 are employed as the supports. The CMPS-supported catalyst is far better than the SiO2- and Al2O3-supported catalysts in activity and selectivity but not in stability. Imposing the ultrasound can effectively increase the reaction rate. Mechanical agitation at a low speed with the imposition of ultrasonic vibration not only results in a conversion slightly higher than the case with a high mechanical agitation speed without ultrasonic vibration, but also gives a constant stability for the CMPS-supported catalyst. 相似文献
In the paper, we found a novel method to synthesize dicalcium phosphate dehydrate (DCPD) nanocrystals by in situ reaction in biodegradable PDLLA matrix. Calcium hydrid was selected as calcium source of DCPD, which is different from general methods. The method is not only simple and effective to synthesize Ca–P particles, but also can avoid the aggregation of inorganic nanoparticles in the course of their being dispersed into polymer matrix. 相似文献
This paper presents an efficient resizing technique for the optimum design of tall steel building frameworks. Specifically, an ‘optimality criteria’ method is applied to minimize the weight of a lateral load-resisting structural system of fixed topology subject to constraints on interstorey drift. By exploiting the fact for building frameworks that member forces are relatively insensitive to changes in member sizes, rigorously-derived optimality criteria are shown to be readily satisfied through an iterative pseudo-discrete optimization procedure that converges in but a few cycles to a least-weight design using commercial-standard steel sections. While not considered herein, it is a simple matter to extend the stiffness-based design procedure to account also for strength requirements. Two building framework examples are presented to illustrate the features of the design optimization method. 相似文献
An overview of the present status and future trends in electric vehicle technology is provided. The emphasis is on the impact of rapid development of electric motors, power electronics, microelectronics, and new materials. Comparisons are made among various electric drive systems and battery systems. The market size of electric vehicles in the coming years and the potential electric vehicle impacts are discussed 相似文献
This paper describes the development of an expert system in gearing design application. The knowledge in this design field is vast and involves selection of appropriate data from large amounts of engineering standards data available in engineering catalogues and design handbooks. Experts very oftens have different opinions in determining the design solution. The theme of the work is to organise, systemise, conserve and spread this knowledge relating to gearing design and configuration.
There is a large number of design parameters involved in gearing design. The design of gears also requires an iterative approach to optimize these design parameters that govern the kinematic, as well as the strength performance. Owing to the complex combinations of these aspects, conventional design office practice tends to become complicated and time consuming. Hence, in this piece of work, attempts are made to formulate a design system capable of designing a required type of gear and its configuration under a specified set of working conditions.
The main features of the expert gearing design system are the use of semantic nets in representing the objects, a frame-based data acquisition and representation system, and production rules in representing the domain-specific knowledge base. The system provides a very user-friendly interface through the use of an expert system development tool Prolog. While Prolog is used to set up the various databases and the inference engine, the detail gear design calculations are performed by C. It is found that the communication between these two language media is excellent in terms of performance and efficiency. 相似文献
The present study in conscious rabbits with intracisternal (i.c.) catheters sought to determine the relative contribution of the I1 subtype of imidazoline receptors (IR) and alpha 2 adrenoceptors to the hypotensive effects of rilmenidine, clonidine and moxonidine with an I1-IR/alpha 2 adrenoceptor antagonist efaroxan and a specific alpha 2 adrenoceptor antagonist 2-methoxyidazoxan (2-MI). The alpha 2 adrenoceptor antagonist effect of efaroxan was compared with 2-MI by performing cumulative dose-response curves in the presence of alpha-methyldopa (400 micrograms/kg i.c.). 2-MI was 5.6 times more potent than efaroxan at reversing 75% of the hypotension elicited by alpha-methyldopa (P < .025). This dose ratio was used to match doses of efaroxan and 2-MI for similar alpha 2 adrenoceptor blockade. The effects of efaroxan (4.1, 13, 41 micrograms/kg i.c.) and 2-MI (0.74, 2.3, 7.4 micrograms/kg i.c.) were investigated on a single i.c. dose of rilmenidine (12 micrograms/kg), clonidine (0.75 microgram/kg) and moxonidine (0.51 microgram/kg). These doses of the antihypertensive agents, which were determined from cumulative dose-response curves, produce 90% of the maximum hypotension. Efaroxan was more effective at reversing the hypotension induced by moxonidine and rilmenidine than was 2-MI (P < .01). These findings suggest that rilmenidine and moxonidine act predominantly via IR. By contrast, 2-MI was more effective at reversing the clonidine-induced hypotension than was efaroxan (P < .001), suggesting that clonidine acts mainly via alpha 2 adrenoceptors in conscious normotensive rabbits. Thus, a higher selectivity of the second generation agents moxonidine and rilmenidine for I1-IR over alpha 2 adrenoceptors, compared with the first generation agent clonidine, appears to be necessary for this effect to be manifested in their hypotensive actions. 相似文献
Metabolic Effects of ω-3 Fatty Acids Biological effects of ω-3 fatty acids are related to their properties as structural components of cell membranes, their role as precursors of eicosanoids and their effects on lipoprotein metabolism. This is the basis for a great variety of metabolic effects, many of which of increasing medical interest. Particularly in the cardiovascular field, ω-3 fatty acids have been shown to have a wide spectrum of potentially antiatherogenic effects. Among these are the inhibition of platelet aggregation, reduction of blood viscosity, lowering of blood pressure and suppression of inflammatory reactions in the arteriosclerotic plaque. The principal actions in lipid metabolism are a reduction in triglycerides and a small increase in HDL2. The effect on LDL-cholesterol is complex and an adverse LDL-increase may occur in particular hyperlipoproteinemias. 相似文献
From 1970 to 1992 a total of 63 patients underwent operation for ampullary tumor: 40 pancreatoduodenectomies (PDs), 3 total PDs, 8 ampullectomies, and 12 bypass or exploratory laparotomies. The resectability rate was 68%. There were 9 benign tumors, 1 anaplastic tumor, and 53 adenocarcinomas. According to Martin's classification, there were 7 stage I, 11 stage II, 14 stage III, and 21 stage IV tumors. All patients with stage I, II, and III tumors underwent resection. Patients with stage IV tumors had either resection (n = 11) or bypass (n = 10). The mean duration of hospital stay was 20.6 days. Operative mortality was 12.7% for the whole series and 7.5% after PD (2.5% for the last 10 years). Overall survival was 40% at 5 years (85% for stage I, 65% for stage II, 44% for stage III, and 8% for stage IV). Survival was better for stages I, II, and III after PD than after ampullectomy. For stage IV patients survival was 70% after PD versus 20% after bypass at 1 year and 25% versus 0% after 2 years. In our opinion, PD should be proposed even for benign lesions because two of our patients had to undergo repeat operation (PD) 4 and 22 years later, respectively, for stage IV disease. PD is our choice for all tumors of the ampulla. 相似文献