Inhibition of acid rock drainage from uranium ore waste using a conventional neutralization and precipitation treatment

Glass columns (length 50 cm, i.d. 4 cm) containing 900 g of uranium ore waste were subjected to a three-step process: (1) acid drainage generation, (2) neutralization and precipitation treatment and, again, (3) acid drainage generation. In the first acid generation step, lasting about one year, different variables (pyrite addition, inoculation and irrigation solution) were tested by measuring effluent pH, redox potential, total iron and sulphate. Conditions of acid generation were satisfactorily reproduced, reaching stable pH values around 2.0 that were determined mainly by pyrite addition and the type of irrigation solution used (distilled water or ferrous sulphate). The neutralization and precipitation treatment consisted of alternating irrigations of a neutralizing solution (CaO saturated plus NaOH) and a precipitating solution (ferric sulphate saturated). This treatment caused accumulation of basic iron sulphate and iron oxide precipitates according to SEM studies. After this treatment, the barrier effect created by the reaction products was checked, using irrigation solutions similar to the first step. The effluents collected showed higher pH and lower redox potential, total iron and sulphate values than those observed before the treatment, evidencing inhibition of acid drainage generation.     

Minimal transistor-only micropower integrated VHF active filter

A minimal integrated filter containing four MOS transistors as the only circuit elements is presented. Voltage tuning is used to set the cutoff frequency and band-edge peaking. A filter test chip occupies an active area of 0006mm2, has acutoff frequency of 40 MHz and dissipates 580W.     

Discrete singular convolution and its application to the analysis of plates with internal supports. Part 2: Applications

Part 2 of this series of two papers presents the applications of the discrete singular convolution (DSC) algorithm. The main purpose of this paper is to explore the utility, test the accuracy and examine the convergence of the proposed approach for the vibration analysis of rectangular plates with internal supports. Both partial internal line supports and complex internal supports are considered for 21 square plates of various combinations of edge support conditions. The effects of different size, shape and topology of the internal supports and different boundary conditions on the vibration response of plates are investigated. The partial internal line supports may vary from a central point support to a full range of cross or diagonal line supports. Several closed‐loop supports, such as ring, square and rhombus, and their combinations are studied for complex internal supports. Convergence and comparison studies are carried out to establish the correctness and accuracy of the DSC algorithm. The DSC results are compared with those in the available literature obtained by using other methods. Numerical results indicate that the DSC algorithm exhibits controllable accuracy for plate analysis and shows excellent flexibility in handling complex geometries, boundary conditions and support conditions. Copyright © 2002 John Wiley & Sons, Ltd.     

Advances in the management and control of optical Internet

Given the ever increasing demand for network bandwidth, and the phenomenal advances in optical wavelength division multiplexing (WDM) networking technologies, a major component of the next generation Internet will be an Internet protocol (IP)-based optical WDM network. As IP over WDM networking technologies mature, a number of important architectural, management and control issues have surfaced. These issues need to be addressed before a true next generation optical Internet can emerge. We enumerate some of the key architectural, management and control issues and discuss corresponding approaches and advances made toward addressing these issues. We first review the different IP/WDM networking architectural models and their tradeoffs. We outline and discuss several management and control issues and corresponding approaches related to the configuration, fault, and performance management of IP over dynamic WDM networks. We present an analysis and supporting simulation results demonstrating the potential benefits of dynamic IP over WDM networks. We then discuss the issues related to IP/WDM traffic engineering in more detail, and present the approach taken in the NGI SuperNet Network Control and Management Project funded by DARPA. In particular, we motivate and present an innovative integrated traffic-engineering framework for reconfigurable IP/WDM networks. It builds on the strength of multiprotocol label switching for fine-grain IP load balancing, and on the strength of reconfigurable WDM networking for reducing the IP network's weighted-hop-distance, and for expanding the bottleneck bandwidth     

370 W output power GaN-FET amplifier for W-CDMA cellular base stations

A single-ended amplifier using small packaged GaN-FETs exhibits a record 2.14 GHz W-CDMA output power. The amplifier, composed of paralleled 48 mm gate periphery FET die, delivers a peak saturated output power of 371 W with a linear gain of 11.2 dB at a drain voltage of 45 V under 2.14 GHz 3GPP W-CDMA signal input. The output power density (output power/package size) of 1.1 W/mm/sup 2/ is twice as high as that of the existing over 300 W GaAs-FET amplifiers. A low 5 MHz offset ACLR of -36 dBc with a drain efficiency of 24% is also obtained at 8 dB power back off from the saturated output power.     

The effects of FG7142 on two types of forgetting in 18-day-old rats.

The authors studied the role of gamma-aminobutyric acid (GABA) in 2 types of forgetting of fear in the developing rat. One type of forgetting studied was that observed after an intermediate retention interval (the "Kamin effect"); the other type studied was that observed after a longer interval (infantile amnesia). Rats were given pairings of an auditory conditioned stimulus with shock, and learned fear was assessed by freezing. Forgetting at an intermediate retention interval (1 hr) was not alleviated by the GABAA receptor partial inverse agonist FG7142 (0, 1, 5, or 10 mg/kg), whereas forgetting at a longer retention interval (48 hr) was alleviated. These results suggest that in the developing rat, forgetting observed at different retention intervals is mediated by different physiological mechanisms. (PsycINFO Database Record (c) 2010 APA, all rights reserved)     

Process issues in treatment: Application to sexual offender programs.

How critical is the therapeutic alliance in the treatment of sexual offenders? To date such process issues have been neglected in the field of sex offender treatment. This article reviews the literature on the influence on behavior change of therapist features, clients' perceptions, and the therapeutic alliance. Among the many therapist features identified as helpful are empathy, warmth, and being directive and rewarding. Therapists who are aggressively confrontational appear not to foster beneficial changes in their clients. These issues are directly related to treatment issues faced by therapists who work with sexual offenders, such as dealing with cognitive distortions, lack of empathy, and lack of motivation to change. (PsycINFO Database Record (c) 2010 APA, all rights reserved)     

High-resolution electron microscopy of the twinning and intergrowth in Ca4Al6SO16 and Ca3SrAl6SO16

The microstructures of unhydrated calcium aluminosulphate Ca₄Al₆SO₁₆ and Ca₃SrAl₆SO₁₆ have been studied by high-resolution electron microscopy (HREM). The results showed that twinning and twinned slabs could be introduced taking the [1 1 2] direction as the twin axis so that it seems to be coincident with the law of twinning formed in body-centred cubic structures. A previously reported superlattice with a repeat period twice that of the fundamental structure along the 〈1 1 0〉 direction has also been found in both matrix and twin variants. The close intergrowth of Ca₃SrAl₆SO₁₆ and another phase, possibly Sr₃Al₂O₆ existing as an inclusion between these two twin variants, was determined and clearly revealed by electron diffraction and HREM images. The coherent interphase boundaries and orientation relationship between them can also be deduced.     

Novel T-rail electrodes for substrate removed low-voltage high-speed GaAs/AlGaAs electrooptic modulators

A novel traveling-wave electrode utilizing capacitively loaded T-rail elements was developed for low-voltage high-speed substrate-removed GaAs/AlGaAs electrooptic modulators. Electrodes with varying dimensions were fabricated and characterized. Electrode phase velocity, characteristic impedance, loss coefficient, and capacitive loading were extracted from the measured s-parameters up to 40 GHz. Electrode was also simulated using a finite-element solver. The measured and calculated electrode capacitance values were found to be in excellent agreement, showing that the electrode can be precisely designed. Approaches were outlined to provide a group velocity-matched very high-speed modulator electrode suitable for a low drive-voltage substrate-removed GaAs/AlGaAs electro-optic modulator