2.488 Gb/s-318 km repeaterless transmission using erbium-dopedfiber amplifiers in a direct-detection system

The authors have achieved a 2.488 Gb/s, 318 km repeaterless transmission without any fiber dispersion penalty through a nondispersion-shifted fiber in a direct detection system. The system was loss limited with a T-R power budget of 57 dB. Three key components enabled the authors to achieve this result: (1) a Ti:LiNbO₃ external amplitude modulator enabling a dispersion-free transmission, (2) erbium-doped fiber amplifiers increasing the transmitting power to +16 dBm, and (3) an erbium-doped fiber preamplifier enabling a high-receiver sensitivity of -4.1 dBm for 10^-9 BER. To the author's knowledge, this result is the longest repeaterless transmission span length ever reported for direct detection at this bit rate. From the experimental results and a theoretical model, the authors identified the sources of the receiver sensitivity degradation from the quantum limit (-48.6 dBm) and estimated the practically achievable receiver sensitivity of ~-44 dBm (~-124 photons/bit) for 2.5 Gb/s optical preamplifier detection     

Indexed in current contents

Indexed in current contents     

Lateral-mode analysis of narrow-stripe semiconductor lasers with acylindrically concave end facet

A beam-propagation method is used to investigate numerically the lateral-mode characteristics of GaAlAs semiconductor lasers having a cylindrically concave facet at one end. Various degrees of index guiding have been considered. Simulations were made for both below- and above-threshold regimes. As expected, the numerical results show that the optical beam divergence parallel to the junction plane can be significantly reduced. In addition, this far-field narrowing is accompanied by lower threshold currents. However, for values of the radius of curvature of the concave facet lying in some specific ranges, the losses of the fundamental lateral mode are higher than that calculated for conventional lasers, and the corresponding eigenvalue shows nonmonotonic variations as the injection current is increased. This phenomenon is due to an enhancement of the index antiguiding over the gain-guiding mechanism     

A 64-Mb DRAM with meshed power line

A 64-Mb dynamic RAM (DRAM) has been developed with a meshed power line (MPL) and a quasi-distributed sense-amplifier driver (qDSAD) scheme. It realizes high speed, t_RAS=50 ns (typical) at V_cc=3.3 V, and 16-b input/output (I/O). This MPL+qDSAD scheme can reduce sensing delay caused by the metal layer resistance. Furthermore, to suppress crosstalk noise, a V_SS shield peripheral layout scheme has been introduced, which also widens power line widths. This 64-Mb DRAM was fabricated with 0.4-μm CMOS technology using KrF excimer laser lithography. A newly developed memory cell structure, the tunnel-shaped stacked-capacitor cell (TSSC), was adapted to this 64-Mb DRAM     

Thiamine pyrophosphatase activity in the Golgi apparatus of calcitonin-treated osteoclasts.

The thiamine pyrophosphatase (TPPase) activity described by Novikoff and Goldfisher was examined in osteoclasts affected by calcitonin in order to elucidate whether the morphological and functional changes of the osteoclasts have an influence over the secretion function of their Golgi apparatus. The Golgi apparatus of osteoclasts of which the ruffled border had disappeared and bone resorption discontinued as the result of treatment with calcitonin showed a slight TPPase activity. The reaction products of the enzyme in these inactive osteoclasts were distinctly fewer than that of control osteoclasts, which were not affected by calcitonin. From these results, it is suggested that there may be a connection between the morphological and functional changes of osteoclasts and the secretion function of the Golgi apparatus.     

Electrical and optical feedback in an InGaAs/InP light-amplifyingoptical switch (LAOS)

A circuit model for optical and electrical feedback has been developed to investigate the cause of negative differential resistance (NDR) switching in a series connected heterojunction phototransistor (HPT) light-emitting diode (LED) device. The model considers optical feedback from the light generated in the LED, electrical feedback from the holes thermally emitted over the LED cladding layer, nonlinear gain of the HPT, the Early effect, and leakage resistance. The analysis shows that either electrical or optical feedback can be the dominant cause for the NDR, depending upon their relative strengths. The NDR observed in the devices was caused primarily by electrical feedback since the optical feedback is weak. For low input power, avalanche breakdown appears to initiate the NDR in the devices although avalanching alone cannot cause NDR     

A Tuning Circuit with Two Half-Wave Distributed Junctions for All-NbN SIS Mixers

A novel broadband tuning circuit composed of two low-current-density half-wave NbN/MgO/NbN tunnel junctions connected by a half-wave NbN/MgO/NbN microstrip line has been successfully tested in a quasi-optical mixer at frequencies above 700 GHz. The circuit had a designed center frequency of 870 GHz, was integrated in a center-fed twin-slot antenna, and was fed via a quarter-wave impedance transformer. Heterodyne measurments showed double-side-band receiver noise temperatures equivalent to 6-9 quanta from 675 to 810 GHz for a mixer with a current density of 6.7 kA/cm². The RF bandwidth was broader than that of a conventional mixer using a full-wave junction with the same current density.     

Improved Poisson intensity estimation: denoising application using Poisson data

Recently, Timmermann and Nowak developed algorithms for estimating the means of independent Poisson random variables. The algorithms are based on a multiscale model where certain random variables are assumed to obey a beta-mixture density function. Timmermann and Nowak simplify the density estimation problem by assuming the beta parameters are known and only one mixture parameter is unknown. They use the observed data and the method of moments to estimate the unknown mixture parameter. Taking a different approach, we generate training data from the observed data and compute maximum likelihood estimates of all of the beta-mixture parameters. To assess the improved performance obtained by the proposed modification, we consider a denoising application using Poisson data.     

Protocol design for scalable and reliable group rekeying

We present the design and specification of a protocol for scalable and reliable group rekeying together with performance evaluation results. The protocol is based upon the use of key trees for secure groups and periodic batch rekeying. At the beginning of each rekey interval, the key server sends a rekey message to all users consisting of encrypted new keys (encryptions, in short) carried in a sequence of packets. We present a scheme for identifying keys, encryptions, and users, and a key assignment algorithm that ensures that the encryptions needed by a user are in the same packet. Our protocol provides reliable delivery of new keys to all users eventually. It also attempts to deliver new keys to all users with a high probability by the end of the rekey interval. For each rekey message, the protocol runs in two steps: a multicast step followed by a unicast step. Proactive forward error correction (FEC) multicast is used to reduce delivery latency. Our experiments show that a small FEC block size can be used to reduce encoding time at the server without increasing server bandwidth overhead. Early transition to unicast, after at most two multicast rounds, further reduces the worst-case delivery latency as well as user bandwidth requirement. The key server adaptively adjusts the proactivity factor based upon past feedback information; our experiments show that the number of NACKs after a multicast round can be effectively controlled around a target number. Throughout the protocol design, we strive to minimize processing and bandwidth requirements for both the key server and users.