乳液聚合中单体醋酸乙烯酯与保护胶体聚乙烯醇的接枝反应研究

研究了以聚乙烯醇为保护胶体的醋酸乙烯乳液聚合中,聚乙烯醇与单体的接枝反应。探讨了引发剂用量、聚合反应温度、保护胶体聚合度等因素对接枝反应的影响。     

冷冻凝聚工艺生产CR322的研制

对原电解质凝聚工艺生产CR322(混合调节型氯丁橡胶)进行了改进，实现了冷冻凝聚新工艺法生产切块CR322，即主乳化剂由松香皂／脂肪酸皂复合型代替了单一松香皂。新工艺解决了冷冻转鼓装置生产CR322过程中“黏杆”及干胶门尼黏度控制等问题。产品无焦烧粒子。且焦烧时间明显延长。     

PBT共混改性研究最新进展

综述了最近几年国内外聚对苯二甲酸丁二醇酯(PBT)共混改性的研究进展,分类介绍PBT/聚烯烃、PBT/同系聚酯、PBT/液晶、PBT/弹性体、PBT/聚碳酸酯等不同共混体系,讨论了各体系中的相行为、相容性、热稳定性、力学性能等,并对该类共混物的发展趋势作了简要的分析。     

胶层厚度对拉伸试样应力分布影响的数值分析

运用弹塑性有限元法研究了胶层厚度对承受拉伸载荷的对接接头胶层内应力分布的影响．三维有限元法数值分析的结果表明，随胶层厚度减小，胶层中正应力SZ与剪应力SYZ的分布趋于均匀；而对正应力SY而言，胶层厚度为0．15mm时，其边缘峰值应力最低。     

The onset of Taylor-Görtler vortices in impulsively decelerating swirl flow

The onset of hydrodynamical instability induced by impulsive spin-down to rest in a cylinder containing a Newtonian fluid is analyzed by using propagation theory. It is well-known that the primary transient swirl flow is laminar, but with initial high velocities secondary motion sets in at a certain time. The dimensionless critical time Τ_c to mark the onset of instability is presented here as a function of the Reynolds number Re. Available experimental data indicate that for large Re deviation of the velocity profiles from their momentum diffusion occurs starting from a certain time Τ≈4Τ_c. This means that secondary motion is detected at this characteristic time. It seems evident that during Τ_c⪯Τ⪯4Τ_c, secondary motion is relatively very weak and the primary diffusive momentum transfer is dominant.     

纳米稀土复合固体超强酸催化合成乙酸苄酯

采用共沉淀法制备了纳米稀土复合固体超强酸SO4^2-／ZrO2-2％Nd2O3催化剂，电镜分析表明，催化剂颗粒直径在25nm左右，比表面积测定：71．03m^2／g。酸强度-12．70〈Ho〈-11．99。并对合成乙酸苄酯的最佳反应条件进行了研究。研究表明：当苯甲醇与乙酸的物质的量比为1：2，反应时间为5h，反应温度为120℃，催化剂用量为6％苯甲醇的质量时，酯化率可达92．04％。研究发现，该催化剂可重复使用并可活化再生。     

Preparation of micro-patterned surfaces of Si-N-O films and their influence on adhesion behavior of endothelial cells

Microgrooves were prepared on Si(100) surface by photolithography and wet etching.Subsequently,Si-N-O films were deposited on the microgrooves by unbalanced magnetron sputtering(UBMS) and micro-patterned surfaces of Si-N-O films were obtained.The size of the micropatterns was measured by surface profilometer.The chemical composition of Si-N-O films were characterized by X-ray photoelectron spectrometry(XPS) and the wettability of the micropatterned surfaces was evaluated by contact angle measurement.The beh...     

Dynamic equivalent method of interconnected power systems with consideration of motor loads

The existing equivalent methods usually only deal with static load models and neglect the dynamic characteristics of loads such as induction motors.This paper presents a dynamic equivalent method which considers motor dynamics.At first,the clustering criterion of motor loads is given.The motors with similar dynamic characteristics are classified into one group.Then,reduction of motors in the same group is carried out.Finally,parameters of the equivalent motor are calculated and the equivalent system is thus...     

一种高效的网格资源监测算法ACTC的改进算法

资源监控是网格计算的关键组成部分。资源监控算法既要保证网格系统中资源信息高保真度又要考虑资源信息在网络传输中的负担最低。ACTC算法就是为实现以上目的而被提出,但是算法中对资源信息更新量的动态门槛值(d_threshold)计算方式不合理,有可能导致算法演变成低级的单纯依靠时间敏感机制(TSM)来发送资源更新通知,并且算法中遗漏了一些极端情况的考虑。提出了新的d_threshold计算公式和限制条件,进行性能改进和完善,并对改进前后两算法进行实验对比。实验表明,改进后算法提高了资源信息准确性,并使监控系统     

Application of open-pit and underground mining technology for residual coal of end slopes

Given the conditions of residual coal from the boundary of a flat dipping open-pit mine,which uses strip areas mining and inner dumping with slope-covering,we propose an open-pit and underground integrated mining technology for residual coal of end slopes.In the proposal a conveyance road and ventilation conveyance near the slope are built,corresponding to the pit mining area and the surface coal mine dump,as well as an interval haulage tunnel and air-inlet tunnel.The outcome shows that such mining method may reduce the effect to slope stability from underground mining,it does not affect the dumping advance and has a high recovery rate of residual coal resources.The working face is timbered by single hydraulic props,transported by a scraper conveyor and supported by coal walls.This method of mining is one of layered top coal caving,with high resource recovery,low production cost where positive economic benefit can be realized.