Subspace-Based Blind Channel Identification for Cyclic Prefix Systems Using Few Received Blocks

In this paper, a novel generalization of subspace-based blind channel identification methods in cyclic prefix (CP) systems is proposed. For the generalization, a new system parameter called repetition index is introduced whose value is unity for previously reported special cases. By choosing a repetition index larger than unity, the number of received blocks needed for blind identification is significantly reduced compared to all previously reported methods. This feature makes the method more realistic especially in wireless environments where the channel state is usually fast-varying. Given the number of received blocks available, the minimum value of repetition index is derived. Theoretical limit allows the proposed method to perform blind identification using only three received blocks in absence of noise. In practice, the number of received blocks needed to yield a satisfactory bit-error-rate (BER) performance is usually on the order of half the block size. Simulation results not only demonstrate the capability of the algorithm to perform blind identification using fewer received blocks, but also show that in some cases system performance can be improved by choosing a repetition index larger than needed. Simulation of the proposed method over time-varying channels clearly demonstrates the improvement over previously reported methods.     

横流均匀环境中三维线源型正负浮力射流特性研究

本文利用混合有限分析法及交错网格。对横流均匀环境中三维线源型正负浮力射流及负浮力射流的特性进行研究，分析了不同工况下流速，温度和湍动能在断面上的分布及影响射流轨迹线的因素，讨论了轨迹线上温度的变化及浮力射流的贴壁现象。对三维长线源型负浮力射流，分析了流速比，喷口弗汝德数对负浮力射流的影响。     

无线信道中的电波传播

分析了信号在无线信道中传输时所经受的两种衰落,介绍了主要的无线传播模型,在此基础上提出了对抗衰落的措施。     

Penalty interference of nonlinear intra-channel effects and PMD inultra high-speed TDM systems

Penalty interference of nonlinear propagation impairments and polarisation mode dispersion (PMD) caused signal distortions is experimentally investigated     

定向井井眼轨道预测方法研究及其应用

对定向井片眼轨道进行预测是实现井眼轨道定量控制的关键.本文提出了井眼轨道预测控制的力-位移模型.在此基础上,建立了描述侧向切削问题的多元幂积模式,推导了预测井斜、方位及其变化率的基本预测公式,形成了井眼轨道预测控制系统,并进一步研制了适于井场快速预测的自适应信号跟踪顶测软件,针对IBM-PC微机,开发了定向井井眼控制预测软件包DTCPS.多例预测实践表明,使用该软件包预测井眼轨道,精度较高,相符程度较好.     

动态聚焦电子枪的模拟与实验研究

动态聚焦技术是为了满足大屏幕高分辨率彩色显像管及高分辨率彩色显示管的发展需求而产生的一项新技术。在本文中，作者首先提出了一种动态聚焦电子枪结构，进行了数值计算与分析，制作了动态聚焦电子枪并装管实验。通过对实验样管的测试与分析。证实该枪性能良好，动态聚集效果明显。     

On the Direct Addition of Amine N–H to Ch≡C Triple Bonds with Late Transition Metal Catalysts

The kinetics of the transition metal-catalysed direct addition of amine NH bonds to carbon--carbon multiple bonds (hydroamination) has been explored by in situ spectroscopic techniques. From an open mass balance it was concluded that an intermediate species was formed during the cyclisation of 6-aminohex-1-yne. This species was identified as the enamine 2-methylene-piperidine, which is the primary hydroamination product.     

Assessment of underground cable ratings based on distributed temperature sensing

Numerous power utilities have installed advanced distributed temperature sensing (DTS) systems to measure the temperature of underground cables. This paper presents a general procedure for real-time assessment of underground cable ratings based on DTS. After the identification and location of hot spots on a cable, the cable installation data, load, and DTS-recorded temperature over a period of time are used to estimate soil thermal parameters and assess cable ratings under normal and overloading conditions. In order to accurately estimate soil thermal parameters, a combined technique of the finite-element method and gradient-based optimization is used. The technique was validated in the laboratory and applied to a rating assessment of a 230-kV/500-MVA cable circuit. The assessed continuous and emergency ratings are helpful in improving the operation of this circuit.     

InGaN/GaN MQW p–n junction photodetectors

InGaN/GaN multiquantum well (MQW) p–n junction photodetectors with semi-transparent Ni/Au electrodes were fabricated and characterized. It was found that the fabricated InGaN/GaN MQW p–n junction photodetectors exhibit a 20 V breakdown voltage and a 3.5 V forward 20 mA turn on voltage. It was also found that the photocurrent to dark current contrast ratio is higher than 10⁵ when a 0.4 V reverse bias was applied to the InGaN/GaN MQW p–n junction photodetectors. Furthermore, it was found that the maximum responsivity was 1.28 and 1.76 A/W with a 0.1 and 3 V applied reverse bias, respectively.