基于朗伯型反射微结构的LED室内照明光源设计

提出了一种基于朗伯型反射面的LED间接照明系统,即LED光源出射的光全部通过朗伯型反射面反射后再照射目标区域,该系统具有光源亮度均匀、灯具效率高等优点,很好地解决了高亮度LED点光源给室内照明带来的眩光问题。首先提出了一种能够很好逼近朗伯反射面的复合型微结构表面,并通过Lighttools光学仿真对其分布参数进行了优化,使最终结果在不同光线入射角的情况下,都具有较理想的余弦反射特性。在此基础上,设计了整体光学系统,使其实现了近180°范围的角度亮度的均匀性和高达84.7%的灯具效率,验证了间接照明方法的可行性。     

High-speed Modulation of InGaAs: Sb-GaAs-GaAsP quantum-well vertical-cavity surface-emitting lasers with 1.27-/spl mu/m emission wavelength

1.27-/spl mu/m InGaAs: Sb-GaAs-GaAsP vertical-cavity surface-emitting lasers (VCSELs) were grown by metal-organic chemical vapor deposition and exhibited excellent performance and temperature stability. The threshold current changes from 1.8 to 1.1 mA and the slope efficiency falls less than /spl sim/35% as the temperature raised from room temperature to 70/spl deg/C. With a bias current of only 5 mA, the 3-dB modulation frequency response was measured to be 8.36 GHz, which is appropriate for 10-Gb/s operation. The maximal bandwidth is measured to be 10.7 GHz with modulation current efficiency factor (MCEF) of /spl sim/5.25 GHz/(mA)/sup 1/2/. These VCSELs also demonstrate high-speed modulation up to 10 Gb/s from 25/spl deg/C to 70/spl deg/C.     

A novel motor drive design for incremental motion system via sliding-mode control method

This paper proposes a particular motor position control drive design via a novel sliding-mode controller. The newly designed controller is especially suitable for the motor incremental motion control which is specified by a trapezoidal velocity profile. The novel sliding-mode controller is designed in accordance with the trapezoidal velocity profile to guarantee the desired performance. A motor control system associated PC-based incremental motion controller with permanent-magnet synchronous motor is built to verify the control effect. The validity of the novel incremental motion controller with sliding-mode control method is demonstrated by simulation and experimental results.     

Very low noise RF nMOSFETs on plastic by substrate thinning and wafer transfer

A very low minimum noise figure (NF/sub min/) of 1.2 dB and a high associated gain of 12.8 dB at 10 GHz were measured for six-finger, 0.18-/spl mu/m radio frequency (RF) metal-oxide semiconductor field-effect transistors mounted on insulating plastic following substrate-thinning (/spl sim/30 /spl mu/m) and wafer transfer. Before this process, the devices had a slightly better RF performance of 1.1-dB NF/sub min/ and a 13.7-dB associated gain. The small RF performance degradation of the active transistors transferred to plastic shows the potential of integrating electronics onto plastic.     

毫米波辐射下悬液细胞膜电压变化研究

根据有效介质理论,用Maxwell-Wagner等效公式计算细胞悬液中的平均场．然后基于时变场中单细胞膜电压第二计算模型,用场近似等效方法,建立了毫米场辐射下悬液中细胞膜电压计算模型．模型表明悬液细胞膜电压变化和毫米波的功率、频率、细胞半径、细胞排列及细胞的浓度有关。     

一种DC-DC芯片内建可测性设计

DC-DC芯片设计中有许多内部参数需要检测和控制，有限的引脚数目使得直接测试内部参数比较困难. 文中提出一种通用性很强的内建可测性设计方法，在芯片内部设计时只需要增加规模较小的测试电路，就可以在芯片外引脚上测量芯片内部众多的参数.     

杂质非完全离化对SiC n-MOSFET电特性的影响

文章研究了SiC中杂质非完全离化对器件性能的影响.通过考虑场致离化效应,分析了空间电荷区电荷密度与表面势的关系,得出在SiC MOSFET反型条件下,可近似认为杂质完全离化.在此基础上,模拟了4H-SiC MOSFET的漏电流-栅压曲线和迁移率-栅压曲线.模拟结果与实验数据非常吻合.     

STUDY ON GIS BASED PREDICTION SYSTEM FOR RADIO WAVE PROPAGATION IN UBAN REGION

In this letter, an integrated application of the prediction for radio wave propagation with the Geographic Information System (GIS) is presented and a real prediction system based on GIS is implemented.     

Ni/Cu电极耐中压MLCC的试制

Ni/Cu电极MLCC具有高可靠性、低成本的特点,但是耐中高压性能较差.本文通过下述设计与改进后的工艺制得耐中压的Ni/Cu电极MLCC:介质叠层40层,介质层厚度为55um,在高温烧结后在40PPM的O2中再氧化3小时,制作出容量为1μF,尺寸为3035规格,温度系数是X7R特性的MLCC产品,该MLCC平均耐电压达到了950V,可以满足500V工作电压的要求.     

脉冲响应函数在Monte Carlo模拟中的应用研究

MonteCarlo方法是研究复杂面光源入射条件下光在生物组织分布规律的唯一有效手段,但直接的MonteCarlo模拟存在计算量大、收敛速度慢的问题。通过引入生物组织脉冲响应函数的概念,利用卷积方法计算光在穿过组织一定深度后的分布规律,编制了相应的程序并进行了大量计算机模拟,在此基础上,提出了一种对模拟结果进行评价的方法,利用该方法分析了光源离散量与脉冲响应函数模拟量对光场分布计算结果的影响,证明基于脉冲响应函数的MonteCarlo模拟可以极大地提高计算效率和收敛速度。