Optical fiber up-tapers with index perturbations-performanceanalysis

The performance of step index up-tapers subjected to certain index perturbations in investigated by computer simulation. Concentric symmetric and asymmetric index profile perturbations as well as localized spherical, called regions bubbles, having a different index are studied. It is found that some low-valued perturbations of small scale size (less than a wavelength) do not alter the optical fiber performance. However, the amount of beam expansion in the up-taper may be ultimately limited by such perturbations. Excessive magnification in the presence of perturbations can cause a distortion of the quasi-Gaussian shape and symmetry of the pure step-index fundamental mode as well as increase the excess loss and degrade the lateral and axial displacement tolerance improvements of the up-tapers. For example, an index variation of Δn≈10^-5 in conjunction with a perturbation scale size of 40 μm can be detrimental. Bubble-type perturbations could also cause similar problems. A single 12.8-μm-diameter bubble with a relative index of -0.02, embedded in a 128-μm-diameter step index core with relative index of 0.5%, produced a 0.3-dB excess loss     

Simulation of sulfide buildup in wastewater and atmosphere of sewer networks.

A model concept for prediction of sulfide buildup in sewer networks is presented. The model concept is an extension to--and a further development of--the WATS model (Wastewater Aerobic-anaerobic Transformations in Sewers), which has been developed by Hvitved-Jacobsen and co-workers at Aalborg University. In addition to the sulfur cycle, the WATS model simulates changes in dissolved oxygen and carbon fractions of different biodegradability. The sulfur cycle was introduced via six processes: 1. sulfide production taking place in the biofilm covering the permanently wetted sewer walls; 2. biological sulfide oxidation in the permanently wetted biofilm; 3. chemical and biological sulfide oxidation in the water phase; 4. sulfide precipitation with metals present in the wastewater; 5. emission of hydrogen sulfide to the sewer atmosphere and 6. adsorption and oxidation of hydrogen sulfide on the moist sewer walls where concrete corrosion may take place.     

Highly integrated direct conversion receiver for GSM/GPRS/EDGE with on-chip 84-dB dynamic range continuous-time /spl Sigma//spl Delta/ ADC

This paper describes a highly digitized direct conversion receiver of a single-chip quadruple-band RF transceiver that meets GSM/GPRS and EDGE requirements. The chip uses an advanced 0.25-/spl mu/m BiCMOS technology. The I and Q on-chip fifth-order single-bit continuous-time sigma-delta (/spl Sigma//spl Delta/) ADC has 84-dB dynamic range over a total bandwidth of /spl plusmn/135 kHz for an active area of 0.4 mm/sup 2/. Hence, most of the channel filtering is realized in a CMOS IC where digital processing is achieved at a lower cost. The systematic analysis of dc offset at each stage of the design enables to perform the dc offset cancellation loop in the digital domain as well. The receiver operates at 2.7 V with a current consumption of 75 mA. A first-order substrate coupling analysis enables to optimize the floor plan strategy. As a result, the receiver has an area of 1.8 mm/sup 2/.     

A Method for Measuring Pulsed Amplifier Noise Using a Spectrum Analyzer

Measuring the noise generated by a pulsed RF amplifier is not a simple task [1]. One method of making this measurement converts the RF pulse to video with a phase detector and uses a spectrum analyzer to measure the noise between the lines of the pulse spectrum. The measurement includes the combined effects of timing jitter, power-supply modulation, and amplifier noise. An alternate method, described in this note, requires less test equipment by using an RF spectrum analyzer to measure the noise at a point outside the pulse spectrum. This measurement responds only to amplifier noise and is valid if the noise density is the same both inside and outside the pulse spectrum. Since this situation tends to be true of broad-band amplifiers such as TWT's and CFA's, the second method is preferable because of its relative simplicity. This note describes the procedure for measuring pulsed amplifier noise using an RF spectrum analyzer. The test setup and measurement procedure are described, as well as the conversion of the measured spectral-density ratio to an equivalent CW signal-to-noise ratio.     

Strategies for FH/MFSK Signaling with Diversity in Worst-Case Partial-Band Noise

Optimum diversity and worst-case partial-band noise jamming conditions have been derived for noncoherent energy detection of frequency-hopped (FH)M-ary frequency-shift keyed (MFSK) signals using a soft-chip decision suboptimum linear combining metric with perfect jamming-state side information. However, the assumption implicit in previous publications is that the error rate is first maximized over the jammer's partial-band duty factor for arbitrary diversity, and the result is then minimized over the amount of diversity. This paper shows that if the order of optimization is reversed, different conditions and performance are produced; that is, the previous solution is not a saddlepoint. This introduces some game-theoretic considerations for the communicator and the jammer, the risks and advantages of which are explored.     

8-Gbit/s transmission experiment over 68 km of optical fiber using a Ti:LiNbO3external modulator

We describe the performance of an experimental 1.5-μm lightwave transmission system operating at 8 Gbit/s over 68.3 km of single-mode fiber. The dispersion penalty is limited to 1 dB through the use of external modulation and is attributable to the intrinsic information bandwidth.     

Hydrological simulations in the Rhine basin.

Simulations with regional climate models (RCMs), carried out for the Rhine basin, have been analyzed in the context of implications of the possible future discharge of the Rhine river. In a first analysis, the runoff generated by the RCMs is compared to observations, in order to detect the way the RCMs treat anomalies in precipitation in their land surface component. A second analysis is devoted to the frequency distribution of area averaged precipitation, and the impact of selection of various driving global climate models.     

Religiosity and emotional disturbance: A test of Ellis's thesis in his own counseling center.

Assessed the validity of A. Ellis's (1971, 1973, 1981) contention that being religious was negatively correlated with mental health. 28 very religious, 34 atheist, and 33 religiously-neutral individuals seeking consultation were compared on the frequency and number of 8 reported problems. Contrary to Ellis's prediction, there were no significant differences among the groups. (PsycINFO Database Record (c) 2010 APA, all rights reserved)     

ESD phenomena in GMR heads in the manufacturing process of HDD and GMR heads

It is well known that giant magnetoresistive (GMR) heads used for hard disk drives (HDD) are very sensitive to electrostatic discharge (ESD). In this paper, we describe a method of categorizing ESD damage modes from a standpoint of magnetic influences on the heads as observed by quasi-static test (QST) characteristics as well as electromagnetic characteristics like off-track profiles. In addition, we report an example of GMR stack interlayer diffusion which is one type of hard ESD damage. We also present an example of ESD damage that happened in an actual production process and its preventive measures as guidelines.