Analysis and Simulation of S-shaped Waveguide in Silicon-on-insulator

The simulation and analysis of S-shaped waveguide bend are presented.Bend radius larger than 30 mm assures less than 0.5 dB radiation loss for a 4-μm-wide silicon-on-insulator waveguide bend with 2-μm etch depth.Intersection angle greater than 20° provides negligible crosstalk (<-30 dB) and very low insertion loss.Any reduction in bend radius and intersection angle is at the cost of the degradation of characteristics of bent waveguide and intersecting waveguide, respectively.     

Experimental Research on Erbium-doped Superfluorescent Fiber Source

The effects of the variations in fiber length, fiber mirror reflectance on efficiency and output power are experimentally investigated for erbium-doped double pass backward superfluorescent fiber sources (SFSs). The influence of fiber length on mean wavelength stability (MWS) has also been demonstrated. By incorporating a short section of un-pumped erbium-doped fiber (EDF) at the output port, the pump power dependent on MWS becomes independent of pumped EDF length. This is a novel phenomenon that hasn‘t been reported up to now,and should be helpful to SFS fabrication and theory analysis. By using a fiber Michelson interferometer as spectrum slicing component,a multi-wavelength fiber source (MWFS) with ～20 channels (from 1542nm to 1559nm) is got. The MWFS has a channel spacing of ～0. 8 nm which satisfies ITUstandard. The intensity fluctuation among channels is less than 0.5dB,and the extinction ratio of all channels is above 14dB. This kind of MWFS should be useful to wavelength division multiplexing systems.     

会计政策选择的效率性分析

会计政策选择类型在理论上大体可分为机会主义型和效率(或有效契约)型。会计政策选择具有效率性,但也为经理人员的机会主义行为打开了大门。在我国,由于企业缺乏一系列有效的激励约束机制,会计政策选择的机会主义仍然严重。为此,必须建立适合我国企业有效的激励约束机制。     

Approach for Overcoming Numerical Inaccuracy Caused by Load Discontinuity

It was found that the discontinuity at the end of an impulse will lead to numerical inaccuracy as this discontinuity will result in an extra impulse and thus an extra displacement in the time history analysis. In addition, this extra impulse is proportional to the discontinuity value at the end of the impulse and the size of integration time step. To overcome this difficulty, an effective approach is proposed to reduce the extra impulse and hence the extra displacement. In fact, the novel approach proposed in this paper is to perform a single small time step immediately upon the termination of applied impulse, whereas other time steps can be conducted by using the step size determined from accuracy consideration in period. The feasibility of this approach is analytically explored. Further, analytical results are confirmed by numerical examples. Numerical studies also show that this approach can be applied to other step-by-step integration methods. It seems that to slightly complicate the programming of dynamic analysis codes is the only disadvantage of this approach.     

重视并做好人力资源开发工作

每个国定的经济能不能持续发展 ;能不能在激烈的国际竞争中始终不衰 ;关键在于这个国家能不能开发人力资源 ;占领人力资源、用好人力资源。     

油管电热清防蜡技术在强水敏油田的应用

江苏油田的庄 2、韦 2油田属强水敏油田 ,采用热 (水 )洗油井和化学清防蜡效果较差 ,两油田每年因洗井造成地层污染影响的产量损失在 5 0 0 0t以上 ,约占油田产量的 4 5 %。根据集肤效应 ,采用油管电热清蜡技术 ,在含水小于 6 0 %、井斜小于 4 0°的油井上可正常使用 ,一般通电加热 4 0～ 80min后 ,油井井口温度能达到 5 0℃左右 ,最高可达到 6 5℃以上 ,连续加热 5～ 6h即可达到清蜡目的 ,电热清蜡为周期 6 0～ 90d。影响电热清蜡主要指标因素是油井的产液量 ,产液量越小 ,所需要的加热电流和加热电压也越小 ,井口温度达到最高值越低 ,清蜡效果越差。试验的 7口井平均年度投入产出比达到 1∶5 ,经济效益和社会效益十分明显。     

Applying CIM technology to image factories

Image processing allows the automation of the business transaction, turning “paper factories” into “image factories.” This burgeoning new area of computerization needs new paradigms, theories, and methods to maximize its effectiveness at cutting time and costs. This paper investigates what this new area of computerization can gain from CIM technology. It examines the similarities between the processing of computer images in a paperless business environment and the processing of materials into products in the manufacturing plant. These similarities will allow us to apply mature, well-tested CIM techniques to emerging image factories.     

真空预压影响区安全措施有限元分析

分析了不同研究深度的沟、不同模量的桩、不同渗透系数的桩以及不同桩长等安全保障措施下真空预压对周围环境影响的效果。分析结果表明：挖沟可较有效地减弱真空预压影响区土体的水平位移与竖向位移；当桩土的模量比达到100倍以上之后，桩土模量比的增加对影响区的沉降基本上无影响；不同渗透系数的桩对影响区的沉降有一定的影响，随着桩体渗透系数的减少，影响区的沉降量有不同程度的减少；随着桩长的增加，影响区的沉降量随之减少。     

Ozonation of CI Reactive Black 5 using rotating packed bed and stirred tank reactor

This study investigates the ozonation of CI Reactive Black 5 (RB5) by using the rotating packed bed (RPB) and completely stirred tank reactor (CSTR) as ozone contactors. The RPB, which provides high gravitational force by adjusting the rotational speed, was employed as a novel ozone contactor. The same ozone dosage was separately introduced into either the RPB or the CSTR for the investigation, while the experimental solution was continuously circulated within the apparatus consisting of the RPB and CSTR. The decolorization and mineralization efficiencies of RB5 in the course of ozonation are compared for these two methods. Moreover, the dissolved and off‐gas ozone concentrations were simultaneously monitored for the further analysis. As a result, the ozone mass transfer rate per unit volume of the RPB was significantly higher because of its higher mass transfer coefficient and gas–liquid concentration driving force. Furthermore, ozonation kinetics was found to be independent of the gravitational magnitude of an ozone gas–liquid contactor. Therefore, the results suggest employing RPBs as ozone‐contacting devices with the advantage of volume reduction. The experimental results, which can be used for further modeling of the ozonation process in the RPB, also show the requirement of correct design for the RPB. Consequently, the present study is useful for the understanding of practical application of RPBs. Copyright © 2004 Society of Chemical Industry     

Designing better adaptive sampling algorithms for ECG Holtersystems

Let Ψ be any adaptive sampling algorithm that can run in real time on a tapeless multichannel electrocardiogram (ECG) Holter system. Simple methods which can significantly improve Ψ's fidelity are described and their results are compared in this paper. It is shown that by adding some simple tests to Ψ, the signals reconstructed by Ψ can be improved as much as 5.45 dB. It is also shown that under the same data rate, a good data compressor with slowly sampled input ECG is preferable to a bad data compressor with highly sampled input ECG