基于数字信号处理器的直流电机控制系统

介绍了定点数字信号处理器（DSP）TMS320F240的一般性能及其在永磁无刷直流电机控制上的应用，给出了硬件设计方案、软件策略及输出结果。     

X60管线钢疲劳特性的研究

利用2、4和14mm的X60钢紧凑拉伸试样进行同样应力水平、固定应力比（R＝0．1）的疲劳裂纹扩展试验，揭示出高韧性管道钢的疲劳裂纹扩展存在显著的厚度效应。由于应力水平低，相应的离面应力也低，不足以导致分层开裂，因此，裂纹端部的三维应力约束随厚度增加而增大。4mm试样的疲劳裂纹速率远高于2mm试样，但厚度再增大，裂纹扩展速率不再有显著变化。进一步对表面裂纹试样进行疲劳裂纹扩展试验，并用勾线法纪录裂纹扩展情况，利用穿透裂纹的da/dN-ΔK曲线预测表面裂纹扩展，用2mm厚试样的数据控制裂纹表面长度的扩展，用14mm厚试样的数据控制裂纹底部沿厚度方面的扩展，得到了与表面裂纹扩展实验吻合很好的预测结果。     

Bandpass filters using periodically loaded combline resonators

A novel combline filter is proposed for cellular‐radio base stations. The Q‐factor is significantly improved. The eigenvalue equation is expressed with the single‐team approximation in the gap region of the combline resonator. A two‐pole combline filter is designed. The calculation, simulation, and experiment results are presented and are in good agreement. © 2005 Wiley Periodicals, Inc. Int J RF and Microwave CAE, 2006.     

Trace elements in particles of motor vehicle exhaust in Shanghai

A nuclear microprobe with high spatial resolution and high analytical sensitivity was applied to analyze trace elements,especially lead,in vehicle exhaust of Shanghai city.The result shows that the chemical composition and its corresponding x-ray relative intensity are different among different vehicle exhausts.There are many kinds of metal elements in particles of vehicle exhaust.most are harmful to people,such as Ti,Cr,Mn,Pb,etc.We found that the lead concentration was 6820μg/g and the bromine concentration was 5300μg/g in the exhaust from Santana using leaded gasoline(SULG).which is higher than any other kinds of vehicle exhausts.We have also detected the minimum lead in the particles of unleaded gasoline and its content varies from one to another.Its mean concentration was 450μg/g and the highest reached 6210μg/g.The unleaded gasoline‘s Pb existed in the whole particle while the leaded gasoline‘s enriched in the surface of the particle and was more harmful to the human beings.     

平面近场测试系统在天线测试和诊断中的应用

介绍了天线近场测量的基本原理和HD-1型平面近场测试系统,并对近场测量在实际天线测试中的应用情况、发展方向和应用前景等作了简单的描述。     

FCC原料掺入裂解焦油的研究及其机理分析

在催化裂化固定流化床小试装置上，对裂化原料中掺入富含芳烃的添加剂－裂解焦油进行了考察，确定了添加剂的最佳掺入量为1％，与不掺添加剂的裂化原料相比，其汽油产率提高，生焦量和干气产率减少，汽油选择性变好。同时通过对添加剂的原料体系的结构研究，对添加剂影响催化裂化过程的机理进行了探讨。     

秦山核电厂燃耗深度对DNBR限值的影响分析

本文研究了在秦山核电厂批平均卸料燃耗深度超过原定限值的情况下，为保证电厂的安全运行对DNBR限值进行重新确认的问题。研究过程中，综合考虑了由燃耗加深所引起的核焓升因子的变化和棒弯曲这两种效应对DNBR限值的影响。结果表明，对秦山核电厂而言，在批平均卸料燃耗超过原定限值的情况下，维持原DNBR限值不变仍是安全可行的。     

尿素解吸废液及甲醇残液联合处理工艺的应用

安阳化学工业集团公司(以下简称安化集团)现有2套200 kt/a尿素装置及1套60 kt/a甲醇装置.尿素及甲醇装置在生产过程中会产生大量的尿素解吸废液和甲醇残液,废液中的氨氮(NH3-N)含量和化学需氧量(CODCr)较高,给该公司废水的达标排放带来很大压力.     

JOINING MECHANISMS OF β''''-Al2O3 CERAMIC AND PYREX GLASS TO Al MATRIX COMPOSITE

The bonding of β'-Al2O3 and pyrex glass to Al matrix composites by anodic bonding process is achieved. The microstructure of the bonded interface and the joining mechanisms are analyzed with scanning electron microscope (SEM), energy dispersive X-ray fluorescence spectrometer (EDX). It is observed that the bonding region across the interface consists of the metal layer, oxide transitional layer and the ceramic layer, with the transitional layer composed of surface region and sub-surface region. The bonding process can mainly be categorized into anodic bonding process and solid state diffusing process. The pile-up of the ions and its drift in the interface area are the main reasons for anode oxidation and joining of the interface. The temperature, voltage and the drift ions in the ceramic or glass during the bonding process are the essential conditions to solid state diffusing and oxide bonding at the interface. The voltages, temperature, pressure as well as the surface state are the main factors that influence the anodic bonding.     

基于PCI总线的中文字符液晶屏显示设计

介绍一个汉字点阵屏幕显示电路的组成、工作原理及其实现.着重介绍了PLX9052的ISA接口模式配置、WDM驱动程序地址重定位以及与应用程序的通信的原理及方法.最后给出汉字屏幕显示效果图.