Optimal solutions for a dynamic bandwidth allocation scheme in high-speed networks

In this paper, we investigate the problem of determining the optimal bandwidth allocation for a Dynamic Bandwidth Allocation Scheme (DBAS). The objective is to minimize the total amount of bandwidth required to satisfy the Quality of Service (QoS) requirements of all traffic streams. It is shown that when the performance functions satisfy a certain number of conditions, there exists a unique optimal bandwidth allocation such that, for each traffic stream, either its QoS is just satisfied or its QoS is over-satisfied and it is allocated zero bandwidth. Such an allocation is said to be efficient. It is also shown that there exists a unique efficient allocation in the entire feasible region. An iterative algorithm is developed to compute the efficient allocation employing its special properties. Numerical examples are presented to demonstrate how the algorithm works. Future extensions of this work are also discussed.Partially supported by NSERC of Canada through grants OGP14020 and STRIN-200.     

Self-aligned offset gated poly-Si TFTs with a floating sub-gate

We have fabricated a self-aligned offset-gated poly-Si thin film transistor (TFT) by employing a novel photoresist reflow process. The gate structure of the new device is consisted of two unique patterns: A main-gate and a sub-gate. The new fabrication method extends the gate-oxide over the offset region. With the assistance of the sub-gate and reflowed photoresist a self-aligned offset region is successfully obtained due to the offset oxide acting as an implantation mask. The poly-Si TFT with symmetrical offsets is easily fabricated and the new method does not require any additional offset mask step. Compared with the misaligned offset gated poly-Si TFTs, excellent symmetric electrical characteristics are obtained     

关于项目管理中施工进度控制的研究

阐述了项目管理中施工进度控制的地位与作用，分析了影响工程进度的因素，提出项目进度控制需做好的工作，以提高进度控制水平，确保合同工期的实现。     

Observation of atomic steps on CaCO3 crystal surface

By using scanning polarization force microscopy,the deliquescence process and the atomic steps on the cleavage surface of CaCO3 in air were studied in situ.Under an exposure to medium umidity(-57%),the sloiw step movement has been observed.     

Enhancement mode InP MISFET's with sulfide passivation andphoto-CVD grown P3N5 gate insulators

High performance enhancement mode InP MISFET's have been successfully fabricated by using the sulfide passivation for lower interface states and with photo-CVD grown P₃N₅ film used as gate insulator. The MISFET's thus fabricated exhibited exhibited pinch-off behavior with essentially no hysteresis. Furthermore the device showed a superior stability of drain current. Specifically under the gate bias of 2 V for 10⁴ seconds the room temperature drain current was shown to reduce from the initial value merely by 2.9% at the drain voltage of 4 V. The effective electron mobility and extrinsic transconductance are found to be about 2300 cm ²/V·s and 2.7 mS/mm, respectively. The capacitance-voltage characteristics of the sulfide passivated InP MIS diodes show little hysteresis and the minimum density of interface trap states as low as 2.6×10¹⁴/cm² eV has been attained     

The prospects of non-volatile phase-change RAM

Phase-change read-and-write memory (PRAM) is a promising memory that can solve the problems of conventional memory—scalability, read/write speed, and reliability. We will review the opportunities and technical challenges of PRAM. The most important challenge of PRAM is the reduction of the writing current. Various approaches to reduce the writing current will be reviewed and the prospects of PRAM are discussed.     

~（60）Co辐照对聚四氟乙烯表面润湿性的影响

研究了具有低表面能的氟聚合物聚四氟乙烯（ＰＴＦＥ），经６０Ｃｏγ射线辐照后表面状态的变化，以及其对液体介质蒸馏水的润湿性。较详细地论述了辐照后表面粗糙度、结晶度以及表面化学基因等不同因素对ＰＴＦＥ表面润湿性的影响。通过对ＰＴＦＥ及其表面的红外、Ｘ光衍射，表面粗糙度的分析，弄清了辐照后ＰＴＦＥ表面化学基团的改变对有机氟聚合物表加的润湿性影响很大，而粗糙度和结晶度的变化对润湿性影响较小。     

6M32(51)氮氢气压缩机系统的技术改造

1 机组简介 6M32(51)-190/320-BX型氮氢气压缩机的基础件采用德国博尔格公司的专有技术,具体参数如下: 压缩介质:氮氢气,压缩级数:6级;转速:375rpm;行程:320mm,轴功率:2920kW,容积流量:190m~3/min;气量调节:回路调节,冷却填料润滑油:1.95 kg/h;重量:主机69.45t,     

Performance of trellis coded-8PSK with cochannel interference

The performance of trellis coded-8PSK in the presence of cochannel interference is analyzed and compared with the performance of uncoded QPSK. The analytical expressions are derived and supported by simulating the bit error rate performance of different TC-8PSK systems. The analytical and simulation results show that TC-8PSK is slightly more robust to cochannel interference than uncoded QPSK     

An important factor affecting synergism on coprocessing of Taiheiyo coal with Athabasca oil sand bitumen

A series of mixtures of Japanese subbituminous Taiheiyo coal and Athabasca oil sand bitumen (AOB) with various coal concentrations (0–100 wt%) was coprocessed in a 70 ml autoclave at 420°C for 1 h in the presence of H₂ (50 kg/cm² at room temperature) and sulfided Ni---Mo/Al₂O₂ catalyst. The mixture containing 2 wt% coal produced the largest amount of hexane soluble fraction (HS) and the smallest amount of benzene insoluble fraction (BI). Thus, a synergistic liquid production occurred for this mixture with 2 wt% coal by suppressing the retrogressive reactions which proceeded for pure AOB. The HS obtained from mixtures with 2–30 wt% showed higher H/C ratios and lower heteroatom contents than those obtained from pure AOB and the mixtures with more than 30 wt% coal. The amounts of transferable hydrogen contained in the mixtures were estimated using anthracene as a hydrogen acceptor. The mixtures with 2–10 wt% coal contained higher amounts of donor hydrogen than pure AOB. The HS yield from the various mixtures was correlated with the amount of donor hydrogens contained in the mixtures, except for the mixture with 10 wt% coal. Thus, the important factor which results in synergism is suggested to be the amount of donor hydrogens contained in the feed mixtures.