Cooperative spectrum sensing in cognitive radio network using multiobjective evolutionary algorithms and fuzzy decision making

The cognitive radio has emerged as a potential solution to the problem of spectrum scarcity. Spectrum sensing unit in cognitive radio deals with the reliable detection of primary user’s signal. Cooperative spectrum sensing exploits the spatial diversity between cognitive radios to improve sensing accuracy. The selection of the weight assigned to each cognitive radio and the global decision threshold can be formulated as a constrained multiobjective optimization problem where probabilities of false alarm and detection are the two conflicting objectives. This paper uses evolutionary algorithms to solve this optimization problem in a multiobjective framework. The simulation results offered by different algorithms are assessed and compared using three performance metrics. This study shows that our approach which is based on the concept of cat swarm optimization outperforms other algorithms in terms of quality of nondominating solutions and efficient computation. A fuzzy logic based strategy is used to find out a compromise solution from the set of nondominated solutions. Different tests are carried out to assess the stability of the simulation results offered by the heuristic evolutionary algorithms. Finally the sensitivity analysis of different parameters is performed to demonstrate their impact on the overall performance of the system.     

Composition,structure and electrical properties of DC reactive magnetron sputtered Al2O3 thin films

Thin films of alumina (Al₂O₃) were deposited over Si 〈1 0 0〉 substrates at room temperature at an oxygen gas pressure of 0.03 Pa and sputtering power of 60 W using DC reactive magnetron sputtering. The composition of the as-deposited film was analyzed by X-ray photoelectron spectroscopy and the O/Al atomic ratio was found to be 1.72. The films were then annealed in vacuum to 350, 550 and 750 °C and X-ray diffraction results revealed that both as-deposited and post deposition annealed films were amorphous. The surface morphology and topography of the films was studied using scanning electron microscopy and atomic force microscopy, respectively. A progressive decrease in the root mean square (RMS) roughness of the films from 1.53 nm to 0.7 nm was observed with increase in the annealing temperature. Al–Al₂O₃–Al thin film capacitors were then fabricated on p-type Si 〈1 0 0〉 substrate to study the effect of temperature and frequency on the dielectric property of the films and the results are discussed.     

Optimization of nitrilase production from a new thermophilic isolate

A new thermostable nitrilase‐producing isolate identified as Streptomyces sp. MTCC 7546 has been studied extensively for the optimization of enzyme production operating in batch mode. The benzonitrile was observed as inducer of nitrilase production. The isolate showed maximum nitrilase production after 24 h of incubation at optimal conditions. The strain grows well on a variety of carbon sources and produces the nitrilase that catalyses the hydrolysis of nitriles to acids without formation of amides. The enzyme is mostly active against mono‐ and di‐aliphatic nitriles (10 mmol L^?1) at pH of 7.4 and at a temperature of 50 °C. Copyright © 2007 Society of Chemical Industry     

Isolation of ellagic acid from the aqueous extract of the roots of Decalepis hamiltonii: Antioxidant activity and cytoprotective effect

Roots of Decalepis hamiltonii are consumed as pickles and as a beverage and are believed to possess health-promoting properties. Roots of D. hamiltonii exhibit antioxidant properties. We have isolated an antioxidant compound from the aqueous extract of the roots of D. hamiltonii and identified it as ellagic acid (EA), based on NMR and MS. EA exhibited free radical-scavenging activity, inhibited LDL oxidation and showed cytoprotective effect against xenobiotic-induced oxidative stress in Ehrlich Ascites tumor cells. EA is a new addition to the list of antioxidant compounds in the roots of D. hamiltonii.     

Liquid phase exfoliated WS2 nanosheet-based gas sensor for room temperature NO2 detection

Journal of Materials Science: Materials in Electronics - Layered transition metal dichalcogenide (TMD) materials possess novel and unique semiconducting properties when exfoliated into thin sheets...     

Fixed bed column study for heavy metal removal using phosphate treated rice husk

This paper reports the results of the study on the performance of low-cost adsorbent such as raw rice husk (RRH) and phosphate treated rice husk (PRH) in removing the heavy metals such as lead, copper, zinc and manganese. The adsorbent materials adopted were found to be an efficient media for the removal of heavy metals in continuous mode using fixed bed column. The column studies were conducted with 10 mg/l of individual and combined metal solution with a flow rate of 20 ml/min with different bed depths such as 10, 20 and 30 cm. The breakthrough time was also found to increase from 1.3 to 3.5 h for Pb(II), 4.0 to 9.0 h for Cu(II), 12.5 to 25.4h for Zn(II) and 3.0 to 11.3 h for Mn(II) with increase in bed height from 10 to 30 cm for PRH. Different column design parameters like depth of exchange zone, adsorption rate, adsorption capacity, etc. were calculated. It is found that the adsorption capacity and adsorption rate constant were increased and the minimum column bed depth required was reduced when the rice husk is treated with phosphate, when compared with that of RRH.     

Dyeing studies with hydroxyanthraquinones extracted from Indian madder. Part 1: Dyeing of nylon with purpurin†

Purpurin (1,2,4‐trihydroxyanthraquinone) is the major colorant present in the roots of Indian madder (Rubia cordifolia). Its structure is similar to that of disperse dyes. To gain an understanding of the dyefibre interactions involved, kinetic and thermodynamic studies have been conducted with purpurin on nylon fibre. Dyeing corresponds to the Nernst isotherm as linear isotherms were obtained. The dye is found to be sensitive to pH and high temperature. The rate of dye uptake, diffusion coefficient, standard affinity, heat of dyeing and entropy have been calculated and discussed.     

Green synthesis of biocompatible gold nanoparticles using Fagopyrum esculentum leaf extract

This report describes the use of ethnolic extract of Fagopyrum esculentum leaves for the synthesis of gold nanoparticles. UV-visible spectroscopy analysis indicated the successful formation of gold nanoparticles. The synthesized nanoparticles were characterized by transmission electron microscopy (TEM), high resolution TEM (HRTEM) and were found to be spherical, hexagonal and triangular in shape with an average size of 8.3 nm. The crystalline nature of the gold nanoparticles was confirmed from X-ray diffraction (XRD) and selected-area electron diffraction (SAED) patterns. Fourier transform infrared (FT-IR) and energy-dispersive X-ray analysis (EDX) suggested the presence of organic biomolecules on the surface of the gold nanoparticles. Cytotoxicity tests against human HeLa, MCF-7 and IMR-32 cancer cell lines revealed that the gold nanoparticles were non-toxic and thus have potential for use in various biomedical applications.     

Fabrication and testing of natural fibre composites: Vakka, sisal, bamboo and banana

A study has been carried out to investigate the tensile, flexural and dielectric properties of composites made by reinforcing vakka as a new natural fibre into a polyester resin matrix. The fibres extracted by retting and manual processes have been used to fabricate the composites. These composites are tested for tensile, flexural and dielectric properties and compared with those of established composites like sisal, bamboo and banana made under the same laboratory conditions. The composites are fabricated up to a maximum volume fraction of fibre of 0.37 in the case of tensile testing, and 0.39 for flexural and dielectric testing. It has been observed that the tensile properties increase with respect to volume fraction of fibre for vakka fibre composite and are also more than those of sisal and banana composites and comparable to those of bamboo composites. The flexural strength of vakka fibre composite is more than that of banana composite and is closer to sisal fibre composite with respect to the volume fraction of fibre, where as the flexural modulus is much higher than those of banana and sisal fibre composites and also very much closer to bamboo fibre composites. The dielectric strength of vakka fibre composite increases with increase in volume fraction of fibre in the composite unlike the case of sisal, bamboo and banana composites. The dielectric strength being a unique feature of vakka fibre composite, can be suggested for electrical insulation applications.     

TV shearography: quantitative measurement of shear-magnitude fields by use of digital speckle photography

Digital speckle photography combined with TV shearography is developed for precise measurement of the magnitude of the shear field in a linear shear configuration. As an application the method is implemented to determine the slope-change variations of a three-dimensional object with TV shearography in which the shear magnitude is obtained with the digital speckle photography technique.