Improvement of part load efficiency of a combined cycle power plant provisioning ancillary services

According to the type of ancillary service provisioned, operation mode of a power plant may change to part load operation. In this contribution, part load operation is understood as delivering a lower power output than possible at given ambient temperature because of gas turbine power output control. If it is economically justified, a power plant may operate in the part load mode for longer time. Part load performance of a newly built 80 MW combined cycle in Slovakia was studied in order to assess the possibilities for fuel savings. Based on online monitoring data three possibilities were identified: condensate preheating by activation of the currently idle hot water section; change in steam condensing pressure regulation strategy; and the most important gas turbine inlet air preheating. It may seem to be in contradiction with the well proven concept of gas turbine inlet air cooling, which has however been developed for boosting the gas turbine cycles in full load operation. On the contrary, in a combined cycle in the part load operation mode, elevated inlet air temperature does not affect the part load operation of gas turbines but it causes more high pressure steam to be raised in HRSG, which leads to higher steam turbine power output. As a result, less fuel needs to be combusted in gas turbines in order to achieve the requested combined cycle’s power output. By simultaneous application of all three proposals, more than a 2% decrease in the power plant’s natural gas consumption can be achieved with only minor capital expenses needed.     

A randomized controlled trial of cognitive behavioral therapy for adherence and depression (CBT-AD) in HIV-infected individuals.

Objective: To evaluate cognitive-behavioral therapy to enhance medication adherence and reduce depression (CBT-AD) in individuals with HIV. Design: A two arm, randomized, controlled, cross-over trial comparing CBT-AD to enhanced treatment as usual only (ETAU). ETAU, which both groups received, included a single-session intervention for adherence and a letter to the patient's provider documenting her or his continued depression. The intervention group also received 10 to 12 sessions of CBT-AD. Main Outcome Measures: Adherence to antiretroviral therapy as assessed by Medication Event Monitoring Systems (MEMs) and depression as assessed by blinded structured evaluation. Results: At the acute outcome assessment (3-months), those who received CBT-AD evidenced significantly greater improvements in medication adherence and depression relative to the comparison group. Those who were originally assigned to the comparison group who chose to cross over to CBT-AD showed similar improvements in both depression and adherence outcomes. Treatment gains for those in the intervention group were generally maintained at 6- and 12-month follow-up assessments. By the end of the follow-up period, those originally assigned CBT-AD demonstrated improvements in plasma HIV RNA concentrations, though these differences did not emerge before the cross-over, and hence there were not between-groups differences. Conclusions: CBT-AD is a potentially efficacious approach for individuals with HIV struggling with depression and adherence. Replication and extension in larger efficacy trials are needed. (PsycINFO Database Record (c) 2010 APA, all rights reserved)     

Auswirkungen von Baggerungen und Verklappungen hochwasserbedingter Feinsedimentablagerungen am Fallbeispiel Winterhafen Linz/Donau

In the case study “Winterhafen Linz” the effects of dredging/excavating fine sediments previously deposited by flood events and their subsequent dumping into the Danube mainstream were investigated. While this maintenance work was in progress, the temporal and spatial extent of the sediment plume and the changes in bed topography were measured. By employing air-lift samplers and grab samplers in the dredging and dumping areas, the question as to whether, and if so to what extent, the benthic invertebrate community was disturbed by the maintenance work. It could be clearly demonstrated that the sediment dredging severely affected the benthic invertebrates (an 82 % decline in biomass), while the dumping of the material had no effects on the Danube biota. Numerical modeling was used to simulate discharges and dumping locations other than those actually encountered during the monitoring campaign, thus making it possible to extrapolate and draw conclusions beyond the concrete results. These findings in turn provided the basis for recommendations on how to optimize dredging and dumping procedures on the Danube in future.     

Computer-algebra calculations and measurements on AB spin systems for double-spin-echo sequences

The time evolution of the density operator of an AB spin system during a double-spin-echo pulse sequence is evaluated analytically by a computer-algebra system. The computer-algebra system allows one to generate the extensive formulas describing the density operator and yields an expression for the integral of the spectral signals. The simulation of spectra for arbitrary sequence timings can be easily performed by this new tool without risking errors that might occur in conventional calculations. The computer-algebra method can be extended straightforward to other pulse angles and types of sequences. The double-spin-echo pulse sequence is used in the point-resolved spectroscopy (PRESS) method which is often applied for volume selective examinationsin vivo. For verification of the results generated by the computer-algebra system,¹H spectra from a half-liter spherical sample with an aqueous solution that was 0.1 M in sodium citrate and 0.1 M in sodium acetate were recorded after 90°-180°-180° double-spin-echo pulse sequences on a 1.5-T whole-body unit. The measured behavior of the citrate AB spin system corresponds very well with the theoretical predictions. Thus, the theory provides the basis for the optimization of sequence timings for double-spin-echo measurements with high signal gain from AB systems as, for example, citrate. In addition, the theoretically predicted signal modulations could be fitted to the experimental data, providing the transverse relaxation time of the AB-coupled protons.     

(Ba,Ca)TiO3 PTCR Ceramics with LaNiO3 Thin-Film Electrodes: Preparation and Characterization of the Interface

Conductive LaNiO₃ thin film electrodes were deposited by chemical solution deposition (CSD) from nitrate solutions onto polycrystalline Al₂O₃ and (Ba,Ca)TiO₃ PTCR ceramic substrates. The electrical properties of the LaNiO₃ thin film on Al₂O₃ and of the interface consisting of LaNiO₃ and the semiconductive oxide ceramic were investigated. The deposited LaNiO₃ films were about 250 nm thick and consisted of nanosized particles. The resistivity of the LaNiO₃ film was about 3 × 10^-3cm at 20°C. The PTCR ceramic consisted of m sized particles and exhibited an electronic resistivity of about 10 cm at 20°C and a steep increase of the resistivity of a few orders of magnitude above the Curie point at about 120°C. The electrical properties of the LaNiO₃/PTCR interface were dominated by the properties of a barrier layer between the PTCR ceramic and the LaNiO₃ electrode. The potential dependence of the impedance indicated that the barrier layer consisted of a depletion layer within the PTCR ceramic, when the flat band potential of LaNiO₃ on the PTCR ceramic at about –250 mV was exceeded. Additionally the formation of an insulating layer at the LaNiO₃ electrode has to be taken into account.     

Planar-integrated optical vector-matrix multiplier

We present the design of a planar-integrated optoelectronic vector-matrix multiplier. The inherent parallel-processing potential is fully exploited by optical implementation of multiplications and summations. Planar integration makes the free-space optical system compatible with electronic VLSI technologies. It is composed of phase-only diffractive optical elements, which implement lens and multiple-beam-splitter functions. A demonstrator version of the optical system for a matrix of size 10 x 10 was fabricated on quartz glass by means of multimask lithography and reactive ion etching. It shows low cross talk and good uniformity of the signals.     

Relative changes in F-actin during the first cell cycle: evidence for two distinct pools of F-actin in the sea urchin egg

The cortical actin cytoskeleton undergoes dramatic rearrangements during fertilization of sea urchin eggs. To characterize these changes further, we quantified the relative changes in filamentous actin (F-actin) during fertilization and the first cell cycle in both intact eggs and in isolated cortices by quantitative fluorescence microscopy. The level of F-actin in the intact egg decreased after fertilization and continued to decrease throughout the first cell cycle. By 60 min after fertilization, the level of F-actin had decreased to 50% of the unfertilized sea urchin egg. By cytokinesis, the level of F-actin had decreased to 30% of the unfertilized egg. After completion of cell division, individual blastomeres had 10% of the F-actin in the unfertilized egg. In contrast, there was an increase in cortical F-actin to 370% of the level in the unfertilized egg after fertilization. This increase corresponded to the formation of microvilli. There was little change in the level of cortical F-actin during the first cell cycle. We draw parallels to other systems that increase the amount of F-actin in the Triton-insoluble cytoskeleton by recruiting actin from a Triton-soluble pool of F-actin.