Future Direction on Research and Development of Seismic-Response-Controlled Structures

Abstract: Seismic-response-controlled structures are being accepted as a fresh concept that can respond to the needs of a society in the new century. The author already had announced the basic principle of this concept at the midpoint of this century (1950s). This concept has advanced significantly thanks to technologic innovations in the recent years, and in the beginning of 1985, full-scale research was launched for its practical application. Recently, its theoretical research and application developed rapidly both in Japan and overseas. Therefore, in this paper, the current state of the R&D and practical application of seismic-response-control systems in Japan and the United States are described. Based on this information, the author proposes the future direction of R&D on seismic-response-control technology.     

Statistical analysis of lightning performance of distribution lines based on observation in fields

Because of the lower insulation level than for transmission lines, in this study on lightning protection design of distribution lines, not only direct lightning strokes but also induced voltages caused by nearby strokes must be taken into account. Thus, it is necessary to grasp the frequency of occurrence of lightning phenomena around distribution lines. For this aim, lightning phenomena on TEPCO's distribution lines in use were continuously observed for 6 years (1996 to 2001). Through this observation, new interesting statistical data that can be a useful basis for rationalization of lightning protection design of distribution lines were obtained. Two hundred and four lightning strokes were observed through the six‐year period. Probability of occurrence of a direct stroke was 22% (45 direct strokes were obtained). The fact that in 47% of direct strokes the electric outage did not occur is very interesting. Moreover, the value of surge discharge current of the arrester in the case of nearby stroke is the basis for conventional theory of grounding system. Therefore, statistical analysis of ZnO discharging current in the case of nearby strokes was carried out. As a result, in the case of nearby strokes, 5% value of cumulative frequency of discharging current is 0.5 kA. This value is half the conventional data. © 2006 Wiley Periodicals, Inc. Electr Eng Jpn, 155(2): 8–16, 2006; Published online in Wiley InterScience ( www.interscience.wiley.com ). DOI 10.1002/eej.20180     

Preparation of cationic polystyrene latexes in the absence of emulsifiers

Preparation of cationic polystyrene latexes has been investigated in the absence of emulsifiers. It is clarified that a stable latex can be obtained by using 2,2′-azobis(2-amidinopropane) hydrochloride as initiator (initiator process). The latex seems to be stabilized with the fragments of the initiator chemically bound to the surface of particles. More stable latexes can be obtained by copolymerizing cationic monomers such as dialkyl aminoethyl methacrylates (copolymerization process). The stability of these latexes may predominantly be attributed to cationic monomers chemically bound to the surface of particles. Stable latexes with high solids content can be obtained by using the two-step polymerization technique in the copolymerization process. The particle formation process in the initiator process and the copolymerization process is discussed.     

The role of polyvinyl alcohol in emulsion polymerization

Emulsion polymerization of styrene (St) and vinyl acetate (VAc) in the presence of conventional polyvinyl alcohol (PVA), PVA modified with a terminal alkyl group or PVA modified with a terminal thiol group (HS-PVA) was compared. Whereas stable PVAc latexes were obtained, a stable PSt latex was obtained only in the case of HS-PVA. From the adsorption isotherms of these PVAs on the surface of PVAc and PSt latex particles, as well as the grafting efficiencies of VAc and St onto HS-PVA in relation to the stability of the polymerization process, the role of PVA in the emulsion polymerization was discussed.     

Properties and substrate specificities of proteolytic enzymes from the edible basidiomycete Grifola frondosa

Highly active proteolytic enzymes are found in the fruiting bodies of Grifola frondosa. The general properties and substrate specificities of these proteases from G. frondosa (ProGF) were studied. The optimal pH for ProGF activity was pH 3 or 7 using hemoglobin or Hammersten casein as a substrate, respectively. The ProGF exhibited over 70% of maximal activity within the pH range of 4.5–8.5. In terms of temperature, the ProGF were maximally active at 55 °C, while over 80% of maximal activity was observed within the range of 50–75 °C. These proteases were substrate-specific, mainly cleaving at Ala¹⁴-Leu¹⁵, Tyr¹⁶-Leu¹⁷, and Pro²⁸-Lys²⁹ bonds, with occasional cleavage of Phe²⁴-Phe²⁵ bonds in the oxidized insulin B-chain. The ProGF also liberated hydrophobic amino acids, such as valine, leucine, and phenylalanine, using the oxidized insulin B-chain as a substrate. When soy protein was used as a substrate, valine, leucine, phenylalanine, and tyrosine were selectively released from the hydrolysate. Thus, over the time course of incubation, the peptide concentration increased as the average peptide chain length decreased. These results indicate that the ProGF include both endopeptidases recognizing leucine, phenylalanine, and lysine at the P1′ position, and aminopeptidases preferentially releasing hydrophobic and aromatic amino acids such as valine, leucine, phenylalanine, and tyrosine.     

Existence states of deuterium irradiated into LiAlO2

The existence states of deuterium in LiAlO₂ were analyzed by in situ IR absorption spectroscopy during irradiation with 3 keV at room temperature. Multiple IR absorption peaks that were related to O-D stretching vibrations were observed, mainly at 2650 cm⁻¹ (O-D_α), 2600 cm⁻¹ (O-D_β), and 2500 cm⁻¹ (O-D_γ). The O-D_α was assigned to the surface O-D. The O-D_β and O-D_γ were interpreted as two distinct O-D states for three candidates: O-D of substitutional D⁺ for Li⁺; O-D of substitutional D⁺ for Al³⁺; and O-D of interstitial D⁺. O-D_β was the dominant O-D state for deuterium irradiated into LiAlO₂, and had higher stability than O-D_γ. Heating after ion irradiation led to the desorption of D₂ and an increase in the intensity of O-D_β, which implies that some of the deuterium irradiated into LiAlO₂ exists in non-O-D states, such as D⁻ captured by F centers.     

Low-pressure CO2 sorption in poly(vinyl benzoate) conditioned to high-pressure CO2

Sorption of CO₂ in poly(vinyl benzoate) was gravimetrically measured at pressures up to 1 atm. Sorption isotherms were determined above and below the glass transition temperature T_g from 5 to 85°C. The isotherms were analyzed by the dual-mode sorption model assuming that the plasticizing effect of sorbed CO₂ is negligible at this pressure range. The solubilities and Henry's law dissolution parameters were compared with those obtained by the high-pressure sorption and permeation measurements. Henry's law dissolution parameters were in good agreement with one another. However, the solubilities first determined here were smaller than those determined by the high-pressure sorption experiment at the same temperature. It was clear that the Langmuir capacity of the present specimen was smaller in spite of similar high-pressure CO₂ exposure. Relaxation of the polymer was expected to be one of the reasons. This expectation was confirmed from the observation and analysis of sorption isotherms after two kinds of treatments. After annealing above T_g, the Langmuir capacity was shown to be decreased to 1/2 or even to 1/3 from the sorption isotherms below 45°C. This means that the conditioning to the high-pressure CO₂ surely has a large effect on the nature of glassy polymer. Just after high-pressure CO₂ exposure at 25°C, increased solubility was observed. Furthermore, the slow decrease of solubility, that is, the decrease of conditioning effect, was also followed from the continual measurements at 25°C. This result reflects not only the characteristic of sorption capacity after high-pressure CO₂ exposure, but also the relaxation of polymer in glassy state.     

Biomarkers for colorectal cancer

Colorectal cancer (CRC) is the third most common epithelial malignancy in the world. Since CRC develops slowly from removable precancerous lesions, detection of the lesion at an early stage by regular health examinations can reduce the incidence and mortality of this malignancy. Colonoscopy significantly improves the detection rate of CRC, but the examination is expensive and inconvenient. Therefore, we need novel biomarkers that are non-invasive to enable us to detect CRC quite early. A number of validation studies have been conducted to evaluate genetic, epigenetic or protein markers for identification in the stool and/or serum. Currently, the fecal occult blood test is the most widely used method of screening for CRC. However, advances in genomics and proteomics will lead to the discovery of novel non-invasive biomarkers.     

Vacancy site occupation by Co and Ir in half-Heusler ZrNiSn and conversion of the thermoelectric properties from n-type to p-type

The n-type thermoelectric properties of the half-Heusler compound ZrNiSn can be converted to p-type by the addition of Co and Ir. We found that Co and Ir atoms preferably occupy the vacancy sites instead of substituting at Ni sites. This implies that the phase stability of the compound gradually changes towards that of the Heusler compound Zr(Ni,M)₂Sn, where M is Co and/or Ir. The occupation of vacancy sites by Co and Ir atoms leads to a drastic reduction in lattice thermal conductivity owing to the enhancement of phonon scattering by the solid solution effect.     

Gas transport in poly(vinyl-p-isopropylbenzoate): Comparison and correlation with some other poly(vinyl esters)

Gas permeability in poly(vinyl-p-isopropylbenzoate) (PVp-i-PrB) was determined by a timelag method. The transport properties were discussed from comparison with the permeability data of other poly(vinyl esters), which were studied previously. All these polymers are structurally related, and the size of a side group or the position of its substituent was changed systematically. The isopropyl group of PVp-i-PrB is attached at the para position of a phenyl ring and is the largest in size. As a result gas diffusivity and therefore permeability were increased. The effect of the substituent on gas diffusivity was explained as it increases the interchain and intrachain distances. The discussion was supported from the comparison of the density data between PVp-i-PrB and other poly(vinyl esters). The diffusion coefficients of six glassy poly(vinyl esters) were correlated at their T_g and good correlations were shown to the free volume and its fraction. On the other hand, gas solubility was little affected by the change of an alkyl group on a phenyl ring. The solubility data of PVp-i-PrB and poly(vinyl benzoate) were shown to be clearly correlated with the critical properties of the penetrants. © 1995 John Wiley & Sons, Inc.