A simulation study on the enhancement of the shift reaction by water injection into a gasifier

Although coal gasification is a clean and efficient use of coal, a reduction of CO₂ emissions is needed to mitigate global warming. The aim of this study was to improve the thermal efficiency of fuel production and electricity generation by dry coal feed gasification. The primary cause of thermal efficiency loss is steam use in a water-gas shift reactor. The shift reactor, installed downstream from the gasifier, uses a catalyst to adjust the H₂/CO ratio of the syngas. We have proposed a new process in which water is injected at the outlet of the gasifier and is vaporized to enhance the extent of the shift reaction. This process utilizes the high temperature of the syngas, which is sufficient for the shift reaction to occur without a catalyst. We have developed a model that incorporates the shift reaction velocity to evaluate our proposed process. In an optimized 5-stage water supply case, we found that the CO conversion reaches 9.9% at a water/syngas ratio of 0.14 mol/mol (water/CO = 0.25 mol/mol); the CO conversion needed for dimethyl ether production is 31%. This new process can improve the efficiency and reduce the cost of coal gasification.     

Ultrashort X-ray pulse generation using subpicosecond electron linac

As a promising tool for ultrafast material analyses, we propose to utilize the X-ray pulse which may be generated in a quite simple manner using subpicosecond electron linacs. The properties of the X-ray were numerically studied with the EGS4 code. Verification of the X-ray generation was also conducted at the Nuclear Engineering Research Laboratory (NERL) linac and clear diffraction patterns of characteristic X-ray were obtained for typical single crystals.     

A High-Frequency Resonant Inverter Using Current-Vector Control Scheme and Its Performance Evaluations

The authors introduce a new configuration of resonant-type high-frequency inverter having inherent fast control response of the output power and variable-voltage variable-frequency (VVVF) capability. The circuit is composed of a parallel combination of two series-resonant inverters with common input and output terminals. Both inverter units are operated at synchronous frequency and with an adjustable phase difference from 0° to 180°, allowing control of the output power from full to null power, respectively. Operation of this inverter is explained and computer-simulated operating waveforms and characteristic curves are shown in terms of normalized control variables and circuit parameters. A prototype inverter using Power MOSFET modules has been originally tested with a high-frequency induction heating and melting load to demonstrate experimentally the proposed control principle and the steady-state inverter performances under parallel tuned load conditions.     

Synthesis and hydrophilic property of polypropylene-graft-poly(polyethylene glycol-methacrylate) (PP-g-P(PEGMA))

Polypropylene-graft-poly(polyethylene glycol-methacrylate) (PP-g-P(PEGMA)), which is a hydrophobic-hydrophilic graft copolymer, was synthesized by a combination of an atom transfer radical polymerization (ATRP) of PEGMA with brominated polypropylene (PP-Br), which was synthesized from PP-OH prepared by metallocene-catalyzed copolymerization. Its structure was confirmed by ¹H NMR and GPC analyses. Transmission electron microscope (TEM) micrographs of PP-g-P(PEGMA) revealed the nanometer level microphase-separation morphology between the PP segment and the P(PEGMA) segment. The obtained PP-g-P(PEGMA) showed water-absorbing property as well as thermostability.     

Polonium evaporation and adhesion experiments for the development of polonium filter in lead–bismuth cooled reactors

Fundamental experiments were performed to determine the adhesion characteristics of polonium to different metals and to develop a filter for polonium evaporated from neutron-irradiated LBE. The results of the first experiments suggested that adhesion characteristics are almost the same for stainless steel and nickel metal. The results of the preliminary experiments for a polonium filter suggested that stainless steel mesh with thin wires could effectively collect polonium evaporated from neutron-irradiated LBE. In the experiments, stainless steel wire mesh was used, but from the results of adhesion experiment, it is expected that the same effect can be obtained with wire mesh made of other kinds of metal.     

High performance liquid chromatographic separation of monoacylglycerol enantiomers on a chiral stationary phase

High performance liquid chromatographic separation of monoacylglycerol enantiomers as di-3,5-dinitrophenylurethane derivatives was carried out on a chiral stationary phase, N-(S)-2-(4-chlorophenyl)isovaleroyl-D-phenylglycine chemically bonded tov-aminopropyl silanized silica. Complete separation of the urethane derivatives of racemic monoacylglycerols with saturated acyl groups of C₁₂−C₁₈ was achieved using a stainless steel column (25 cm long) packed with the 5μ particles, an isocratic elution at ambient temperature with a mixture of hexane/ethylene dichloride/ethanol as a mobile phase, and a UV detector. Thesn-1 enantiomers were eluted ahead of the correspondingsn-3 enantiomers. Complete separation of thesn-2 isomers from the corresponding enantiomers and partial separation of the enantiomer homologues differing by two acyl carbons also were observed.     

A 250-Mb/s/pin, 1-Gb double-data-rate SDRAM with a bidirectionaldelay and an interbank shared redundancy scheme

This paper describes three circuit technologies indispensable for high-bandwidth multibank DRAM's. (1) A clock generator based on a bidirectional delay (BDD) eliminates the output skew. The BDD measures the cycle time as the quantity charged or discharged of an analog quantity, and replicates it in the next cycle. This achieves a 0.18-mm ², two-cycle-lock clock generator operating from 25 to 167 MHz with a 30-ps resolution. (2) A quad-coupled receiver eliminates the internal skew caused by the difference between a rise input and a fall input by 40%. (3) An interbank shared redundancy scheme (ISR) with a variable unit redundancy (VUR) efficiently increases yield in multibank DRAM's. The ISR allows redundancy match circuits to be shared with two or more banks. The VUR allows the number of units replaced to be variable. These circuit technologies achieved a 250-Mb/s/pin, 8-bank, 1-Gb double-data-rate synchronous DRAM     

Processing of ethanol fermentation broths by Candida krusei to separate bioethanol by pervaporation using silicone rubber‐coated silicalite membranes

BACKGROUND: Pervaporation employing ethanol‐permselective silicalite membranes as an alternative to distillation is a promising approach for refining low‐concentration bioethanol solutions. However, to make the separation process practicable, it is extremely important to avoid the problems caused by the adsorption of succinate on the membrane during the separation process. In this work, the pervaporation of an ethanol fermentation broth without succinate was investigated, as well as the influence of several fermentation broth nutrient components. RESULTS: Candida krusei IA‐1 produces an extremely low level of succinate. The decrease in permeate ethanol concentration through a silicone rubber‐coated silicalite membrane during the separation of low‐succinate C. krusei IA‐1 fermentation broth was significantly improved when compared with that obtained using Saccharomyces cerevisiae broth. By treating the fermentation broth with activated carbon, bioethanol was concentrated as efficiently as with binary mixtures of ethanol/water. The total flux was improved upto 56% of that obtained from the separation of binary mixtures, compared with 43% before the addition of activated carbon. Nutrients such as peptone, yeast extract and corn steep liquor had a negative effect on pervaporation, but this response was distinct from that caused by succinate. CONCLUSION: For consistent separation of bioethanol from C. krusei IA‐1 fermentation broth by pervaporation, it is useful to treat the low nutrient broth with activated carbon. To further improve pervaporation performance, it will be necessary to suppress the accumulation of glycerol. Copyright © 2009 Society of Chemical Industry     

Recombinant Long-Acting Thioredoxin Ameliorates AKI to CKD Transition via Modulating Renal Oxidative Stress and Inflammation

An effective strategy is highly desirable for preventing acute kidney injury (AKI) to chronic kidney disease (CKD) transition. Thioredoxin-1 (Trx), a redox-active protein that has anti-oxidative and anti-inflammatory properties, would be a candidate for this but its short half-life limits its clinical application. In this study, we examined the renoprotective effect of long-acting Trx that is comprised of human albumin and Trx (HSA-Trx) against AKI to CKD transition. AKI to CKD mice were created by renal ischemia-reperfusion (IR). From day 1 to day 14 after renal IR, the recovery of renal function was accelerated by HSA-Trx administration. On day 14, HSA-Trx reduced renal fibrosis compared with PBS treatment. At the early phase of fibrogenesis (day 7), HSA-Trx treatment suppressed renal oxidative stress, pro-inflammatory cytokine production and macrophage infiltration, thus ameliorating tubular injury and fibrosis. In addition, HSA-Trx treatment inhibited G2/M cell cycle arrest and apoptosis in renal tubular cells. While renal Trx protein levels were decreased after renal IR, the levels were recovered by HSA-Trx treatment. Together, HSA-Trx has potential for use in the treatment of AKI to CKD transition via its effects of modulating oxidative stress and inflammation.