Large-Scale Shake Table Experiment and Numerical Simulation on the Nonlinear Behavior of Pile-Groups Subjected to Large-Scale Earthquakes

This paper describes the results of large-scale shake-table experiments involving a 3×3 pile-group. The pile-group was embedded in dry sand and subjected to sinusoidal waves and an earthquake motion recorded from the 1995 Hyogo-ken Nanbu (Kobe) earthquake. The load transfer between soil and pile was derived and the group effect was captured. Numerical simulations were also performed using a Beam-on-Nonlinear-Winkler-Foundation approach with a new hysteretic p-y curve. A comparison of the experimental and numerical results revealed that the numerical simulation is capable of accounting for the soil-pile interaction observed in the experiment.     

Research on some basic deformations in free forging with robot and servo-press

Due to the disadvantages in casting or hot forging of Ti alloy artificial bones, such as low strength and high energy cost, this paper prompted an alternative method to manufacture individuated artificial bones. Free forging with a 6-axis freedom robot and servo-press could be very economical in the forming of complex shape parts because of its high flexibility and simple die-setting. Based on this system, the authors studied deformations of some basic elements, which could be assembled to artificial bones with complex shape. Firstly, the compression limit and effect of compression parameters on the roundness during reducing diameter process were declared for Al alloy and pure Ti. Secondly, an approximate theoretical equation of bending angle or curvature radius was proposed, and it matches experimental results well. Finally, a dimension prediction equation was presented by considering effect of material anisotropy, and then the ladder part without width spread was manufactured accordingly.     

A 0.18-μm 256-Mb DDR-SDRAM with low-cost post-mold tuning methodfor DLL replica

A 200-MHz double-data-rate synchronous-DRAM (DDR-SDRAM) was developed. The chip contains a delay-locked loop (DLL) which performs over a wide range of operating conditions. Post-mold-tuning allows precise replica programming. A 200-MHz intra-chip data bus is suitable for DDR operation     

Organic Analysis of Peridotite Rocks from the Ashadze and Logatchev Hydrothermal Sites

This article presents an experimental analysis of the organic content of two serpentinized peridotite rocks of the terrestrial upper mantle. The samples have been dredged on the floor of the Ashadze and Logatchev hydrothermal sites on the Mid-Atlantic Ridge. In this preliminary analysis, amino acids and long chain n-alkanes are identified. They are most probably of biological/microbial origin. Some peaks remain unidentified.     

Improvement of the surface quality of foam injection molded products from a material property perspective

Microcellular injection molding is an attractive method. However, their surface imperfections have been a major problem hindering wide industrial applications. Several methods have been proposed to improve the surface appearance of foams. In this study, we proposed a method to improve the surface appearance of polypropylene (PP) foams from the material property perspective, especially with regard to crystallization and viscosity. The basic idea of the surface improvement is to reduce the size of bubbles generated at the flow front, delay the solidification behavior of the polymer at the mold interface, squeeze the bubbles existing at the mold–polymer interface, and redissolve the bubbles into the polymer by holding pressure. Blending a low-modulus PP delays the crystallization of the polymers at the skin layer and solidification, taking enough time to squeeze the bubbles smaller. A sorbitol-based gelling agent, bis-O-([4 methylphenyl]methylene)-D-Glucitol, was used to increase the viscosity at a low strain rate to reduce the size of the bubbles generated at the flow front during the filling stage. The foam injection molding experiments demonstrated that the proposed method effectively improved the surface appearance of the foams. In particular, the surface appearance of the foams became almost equivalent to that of solid samples using low-modulus PP.     

A novel MOSFET with vertical signal‐transfer capability for 3D‐structured CMOS image sensors

We have developed a novel MOSFET that can transfer signals vertically without through‐silicon vias but by using a fully depleted silicon‐on‐insulator (FDSOI) structure with its source region connected to the back electrodes as well as the front ones. A prototype MOSFET fabricated using the backside anisotropic wet etching technique has confirmed that the electrical characteristics measured from the front and the back electrodes are identical. The subthreshold factor S of the prototype was found to be 64.5 mV/decade, suggesting a good switching performance. Since the double‐sided MOSFET has vertical signal‐transfer capability and excellent operating characteristics, it is expected to contribute to developing a More‐than‐Moore type device of three‐dimensional integration such as pixel‐parallel image sensors. © 2014 Institute of Electrical Engineers of Japan. Published by John Wiley & Sons, Inc.     

Inhibitory effects of flavonoid glycosides isolated from the peel of Japanese persimmon (Diospyros kaki Fuyu) on antigen-stimulated degranulation in rat basophilic leukaemia RBL-2H3 cells

We found that two distinct flavonoid glycosides isolated from the peel of Japanese persimmon (Diospyros kaki Fuyu), isoquercitrin (Isq) and hyperin (Hyp), are capable of inhibiting antigen-stimulated degranulation in rat basophilic leukaemia RBL-2H3 cells. In order to elucidate the underlying mechanisms, we examined effects of Isq and Hyp on cellular responses induced by antigen stimulation. Treatment with both Isq and Hyp markedly inhibited antigen-stimulated elevation of intracellular free Ca²⁺ concentration and reactive oxygen species (ROS). Isq and Hyp did not affect NADPH oxidase (NOX) activity, but they possessed DPPH radical-scavenging activity similar to that of epigallocatechin gallate, a potent anti-oxidant, Finally, Isq and Hyp showed little or no effects on Ag-stimulated Syk activation or phosphorylation of signalling molecules. These results indicate that inhibition of antigen-stimulated degranulation by Isq and Hyp is mainly due to suppression of intracellular Ca²⁺ elevation, which is caused by direct scavenging of ROS that are generated by NOX. Our findings suggest that Isq and Hyp, isolated from the peel of persimmon, would be beneficial for alleviating symptoms of type I allergy.