Free vibration of coil springs of arbitrary shape

This paper is concerned with the method for solving the vibration problem of coil springs of arbitrary shape. In the analysis the exact field transfer matrix is derived from the solution of the fundamental equation of the three-dimensional curved beam theory. The transfer matrix is given by combining this field transfer matrix and the point transfer matrix. The analysis derives the frequency equation which is applicable to coil springs of general shape. Numerical calculations have been carried out for hyperboloidal springs and barrel springs. Experimental tests also have been carried out to verify the present results.     

Characterisation of volatile sulphur-containing compounds generated in crushed leaves of Chinese chive (Allium tuberosum Rottler)

To characterise the composition of sulphur-containing constituents in Chinese chive (Allium tuberosum Rottler), GC–MS and HPLC analyses were carried out, using 12 varieties of Chinese origin, 4 varieties of Japanese origin and 6 commercially available cultivars. Five disulphides (dimethyl, allyl methyl, methyl 1-(E)-propenyl, diallyl, and allyl 1-(E)-propenyl), two trisulphides (dimethyl and allyl methyl), and two vinyldithiins (3-vinyl-[4H]-1,2- and 2-vinyl-[4H]-1,3-) were identified on the basis of their mass spectral and GC-retention data. Among the detected sulphur compounds, sulphides with a methyl group predominated over those with an allyl group. This was supported by the HPLC estimations, suggesting that all cultivars examined had much greater amounts of methiin than alliin. Also, two novel compounds were tentatively identified as [3H,4H]-1,2-dithiin and [2H,4H]-1,3-dithiin on the basis of their mass spectral features, GC-retention data, and some experimental results on their formation in reaction mixtures with different proportions of methiin and alliin. Their formation mechanism was proposed.     

日本彩色聚乙烯涂覆钢管的开发

试验了彩色聚乙烯涂覆钢管的耐腐蚀性和耐气候性，由于聚乙烯涂层隔绝水的作用，聚乙烯涂覆钢管具有优良的耐腐蚀性能，电阻绝缘值和优良的机械性能。建立了一个新的方式去研究分析聚乙烯抗老化剂消耗和在聚乙烯中的扩散。用有效测定的方法定量地预测彩色聚乙烯涂覆层的寿命，应用这些分析结果，不仅可使新的有色聚乙烯涂覆钢管在恶劣腐蚀环境介质情况下具有高的耐腐蚀性，而且有长的耐气候性。     

Use of Ponkan mandarin peels as biosorbent for toxic metals uptake from aqueous solutions

Waste Ponkan mandarin (Citrus reticulata) peel was used as biosorbent to extract Ni(II), Co(II) and Cu(II) from aqueous solutions at room temperature. To achieve the best adsorption conditions the influence of pH and contact time were investigated. The isotherms of adsorption were fitted to the Langmuir equation. Based on the capacity of adsorption of the natural biosorbent to interact with the metallic ions, the following results were obtained 1.92, 1.37 and 1.31 mmol g(-1) for Ni(II), Co(II) and Cu(II), respectively, reflecting a maximum adsorption order of Ni(II)>Co(II)>Cu(II). The quick adsorption process reached the equilibrium before 5, 10 and 15 min for Ni(II), Co(II) and Cu(II), respectively, with maximum adsorptions at pH 4.8. In order to evaluate the Ponkan mandarin peel a biosorbent in dynamic system, a glass column was fulfilled with 1.00 g of this natural adsorbent, and it was fed with 5.00 x 10(-4)mol l(-1) of Ni(II) or Co(II) or Cu(II) at pH 4.8 and 3.5 ml min(-1). The lower breakpoints (BP(1)) were attained at concentrations of effluent of the column attained the maximum limit allowed of these elements in waters (>0.1 mg l(-1)) which were: 110, 100 and 130 bed volumes (V(effluent)/V(adsorbent)), for Ni(II), Co(II) and Cu(II), respectively. The higher breakpoints (BP(2)) were attained when the complete saturation of the natural adsorbent occurred, and the values obtained were: 740, 540 and 520 bed volumes for Ni(II), Co(II) and Cu(II), respectively.     

The effect of small dose of topiroxostat on serum uric acid in patients receiving hemodialysis

Introduction : Topiroxostat, a recently developed xanthine oxidase inhibitor, is expected to have fewer adverse effects than allopurinol because it has different mechanism of action from alloprinol. However, its dosage, usage and safety have not been established in patients with impaired renal function or those undergoing dialysis at the development since no studies was conducted in these patients. Methods : Cross over clinical trial using 3 months of allopurinol and topiroxostat on 27 maintain Japanese HD patients were carried out. The effects on oxidative stress status of both drugs were also evaluated by measuring oxidation reduction potential. Findings : Twenty‐five of twenty‐seven patients completed study. The mean serum uric acid levels in the topiroxostat‐treated arm was significantly lower than it in the allopurinol‐treated arm time‐dependently (P < 0.0001). Corrected oxidative stress ratio defined as biological antioxidant potential/diacron reactive oxygen metabolites was significantly increased in topiroxostat‐arm (*P = 0.0035), but not in allopurinol‐arm (P = 0.1429). No significant difference was seen in diacron reactive oxygen metabolites, biological antioxidant potential, static oxidation‐reduction potential, and capacity oxidation‐reduction potential between pre and post treatment of both drugs. Discussion : It is suggested that a low dose of topiroxostat decreased serum uric acid sufficiently to maintain it below 7.0 mg/dL in patients receiving hemodialysis.     

Preface

Multimedia Tools and Applications -     

Electric field–temperature phase diagram of sodium bismuth titanate-based relaxor ferroelectrics

The electric field–temperature phase diagrams of three bismuth sodium titanate-based relaxor ferroelectrics are reported, namely 0.94(Na_1/2Bi_1/2TiO₃)–0.06(BaTiO₃), 0.80(Na_1/2Bi_1/2TiO₃)–0.20(K_1/2Bi_1/2TiO₃) and 0.75(Na_1/2Bi_1/2TiO₃)–0.25(SrTiO₃). Relaxor behavior is demonstrated by temperature-dependent dielectric permittivity measurements in the unpoled and poled states, as well as by the field-induced phase transition into a ferroelectric phase from the relaxor phase. From temperature-dependent thermometry measurements, we identified the threshold electric field to induce the ferroelectric phase and obtained the released latent heat of the phase transition. We determined the nonergodic and ergodic relaxor phase temperature range based on the absence or presence of reversibility of the relaxor to ferroelectric transition. For all three compositions, the electric field–temperature phase diagram was constructed and a critical point was identified. The constructed electric field–temperature phase diagrams are useful to find optimum operational ranges of ferroelectrics and relaxors for electromechanical and electrocaloric applications.     

Threshold Stress for Crack Healing of Mullite Reinforced by SiC Whiskers and SiC Particles and Resultant Fatigue Strength at the Healing Temperature

A mullite/SiC whisker/SiC particle multi-composite, having excellent crack-healing ability and mechanical properties, was hot pressed in order to investigate the crack-healing behavior under stress and the resultant fatigue strength at the temperature of healing. A semi-elliptical surface crack 100 μm in surface length was introduced on each specimen. The pre-cracked specimens were crack healed under cyclic or constant stress by using a three-point bending stress at 1473 K, and the resultant bending strength and cyclic fatigue strength were measured at 1473 K. The pre-crack on the surface of the specimens could be healed even under stress. The threshold stresses for crack healing, as determined by evaluating the strengths of crack-healed specimens at a healing temperature of 1473 K, were 170 MPa for both constant and cyclic stresses, corresponding to 77% of the bending strength of the pre-cracked specimens. The static and cyclic fatigue behaviors of crack-healed specimens were also investigated at a healing temperature of 1473 K.     

Synthesis and Characterization of Tetravalent Cerium Complexes with p-Tert-butylcalix[ n ] arenes （ n = 4, 6, 8）

Ａｓａｂｒａｎｃｈｏｆｓｕｐｅｒａｍｏｌｅｃｕｌａｒｃｈｅｍ ｉｓｔｒｙ ,ｌａｎｔｈａｎｉｄｅｃａｌｉｘａｒｅｎｅｃｈｅｍｉｓｔｒｙｈａｓａｔ ｔｒａｃｔｅｄｃｏｎｓｉｄｅｒａｂｌｅｒｅｓｅａｒｃｈｉｎｔｅｒｅｓｔｆｏｒｓｅｖｅｒ ａｌｙｅａｒｓ[1～ 5 ] .Ｉｎｔｈｉｓｒｅｓｐｅｃｔ,Ｈａｒｒｏｗｆｉｅｌｄｅｔａｌ.[6～ 13] ｓｙｎｔｈｅｓｉｚｅｄａｌｏｔｏｆｌａｎｔｈａｎｉｄｅｃａｌ ｉｘａｒｅｎｅｃｏｍｐｌｅｘｅｓ ,ａｎｄｒｅｖｅａｌｅｄｔｈｅｉｒｃｒｙｓｔａｌｓｔｒｕｃｔｕｒｅｓ .Ａｍｏｎｇｓｔｔ…     

Multi agent architecture for dynamic incremental process planning in the flexible manufacturing system

Due to rapid changes of markets and pressures of competitions, industries are adopting their production ways to support diversity of customer’s needs and increase of new product developments. This paper deals with development of an agent-based architecture of dynamic systems for process planning in the manufacturing systems. In consideration of alternative manufacturing processes and machine tools, the process plans and the schedules of the manufacturing resources are generated incrementally and dynamically. A previously proposed negotiation protocol is customized and improved to generate suitable process plans for the target products real-timely and dynamically, based on the alternative manufacturing processes. The alternative manufacturing processes are presented by the process plan networks and the suitable process plans are searched and generated to cope with both the dynamic status and disturbances of the manufacturing systems. We initiatively combine the heuristic search algorithms of the process plan networks with the negotiation protocols, in order to generate suitable process plans.