Robust Space Time Receiver for CDMA-based Antenna Arrays

In this paper, we propose a new robust code division multiple access (CDMA) receiver of which weight vector is obtained by projecting the effective spatio-temporal signature waveform onto the signal subspace of the data covariance matrix. We verified our proposed algorithm by the field measured data obtained with a custom-built wideband CDMA test-bed. It will be shown that the proposed algorithm is robust to the signal mismatch.     

地基设计基本原则的探讨

地基设计是整个建（构）筑物设计中的重要组成部分，它关系到建（构）筑物的安全及其功能能否正常发挥。本文着重分析探讨了在地基设计中应遵循的原则及注意事项。以保证建（构）筑物的安全和正常使用，充分发挥地基的作用。     

Correlation study on infrared thermography and nerve root signs in lumbar intervertebral disk herniation patient: a short report

OBJECTIVE: To determine whether infrared skin thermography is an objective measurement reflecting the seriousness of nerve root irritation in lumbar disk herniation patients. DESIGN: Quantified nerve root signs by physical examination were collected from the patients along with the infrared skin temperature measurement on the lumbosacral region and posterior part of thighs. A correlation study was applied to observe the relation between the nerve root signs and the skin temperature before a successful conservative treatment (mainly spine manipulation), and between the alteration of nerve root signs and that of skin temperature after the treatment. SETTING: Hospitalized care. PATIENTS: Twenty-seven hospitalized samples with computed tomography or magnetic resonance approval were consecutively selected during the latter half of 1990. MAIN OUTCOME MEASURE: Changes in nerve root signs. RESULTS: The temperature difference between a troubled thigh and healthy one is significantly correlated to the score of the nerve root signs before the treatment; and the reduction of temperature difference between two thighs is also significantly correlated with decreasing score of nerve root signs after the treatment. The correlation between the temperature difference on the left and right sides of the lumbosacral region and the nerve root signs before the treatment is insignificant; and the variation of the temperature difference of the same region after the treatment is not correlated with the decreasing score of the nerve root signs. CONCLUSION: Infrared skin thermography of lower extremities might be an objective sign in signaling the soothing process of the nerve root irritation in lumbar disk herniation patients, which may help a doctor in checking the responses of the patient to treatment.     

关于生物系统超微弱发光的实验研究

生物系统存在超微弱光子辐射现象。通过一系列实验研究,我们认为,这种光子辐射既有低水平化学发光的性质,又有受激辐射的性质,是受激的低水平化学发光。     

Quartz microbalance study of4He and H2 on sodium

A quartz microbalance technique has been used to study the growth of⁴He and H₂ adsorbed on sodium. In contrast to cesium, adsorption of⁴He and H₂ do occur on a sodium surface.     

焊接史

本文追溯了19世纪末发明的电弧焊接的历史。当Oscar Kjellberg成立伊萨公司以探索他发明的涂层焊条时，伊萨从一开始就和电弧焊的发展结下了不解之缘。     

Selective and nonselective wet etching of Zn0.9Mg0.1O/ZnO

Wet etch rates at 25°C for Zn_0.9Mg_0.1O grown on sapphire substrates by pulsed laser deposition (PLD) were in the range 300–1100 nm · min⁻¹ with HCl/H₂O (5×10⁻³−2×10⁻² M) and 120–300 nm · min⁻¹ with H₃PO₄/H₂O (5×10⁻³−2×10⁻² M). Both of these dilute mixtures exhibited diffusion-limited etching, with thermal activation energies of 2–3 kCal · mol⁻¹. By sharp contrast, the etch rates for ZnO also grown on sapphire by PLD were much slower in similar solutions, with rates of 1.2–50 nm · min⁻¹ in HCl/H₂O (0.01–1.2 M) and 12–54 nm · min⁻¹ in H₃PO₄/H₂O (0.02–0.15 M). The etching was reaction limited over the temperature range 25–75°C, with activation energies close to 6 kCal · mol⁻¹. The resulting selectivity of Zn_0.9Mg_0.1O over ZnO can be a high as ∼400 with HCl and ∼30 with H₃PO₄.     

Training sequence design and channel estimation of OFDM-CDMA broadband wireless access networks with diversity techniques

In this paper, an OFDM-CDMA system employing various diversity schemes is considered for a possible candidate of broadband wireless access networks and broadcasting applications. With an emphasis on a preamble design for multi-channel separation, we address a channel estimation based on the time-domain windowing and its imperfectness in OFDM-based multiple-antenna transmission systems. By properly designing each preamble for multiple antennas to be orthogonal in the time domain, the channel estimation can be applied to the HIPERLAN/2 and IEEE 802.11a standards in the case of more than two transmit antennas. Also, the effect of diversity techniques on the performance of OFDM-CDMA based broadband wireless access networks is investigated and the maximum achievable diversity gain for a two-path Rayleigh fading environment is evaluated. Simulation results show that the OFDM-CDMA system applying a space-time-frequency diversity with a full-rate full diversity code can give the diversity of D=4 and D=8 for both multi-user cases of maximum user and half user capacities, respectively.     

Monolithic SiGe Up‐/Down‐Conversion Mixers with Active Baluns

The purpose of this paper is to describe the implementation of monolithically matching circuits, interface circuits, and RF core circuits to the same substrate. We designed and fabricated on‐chip 1 to 6 GHz up‐conversion and 1 to 8 GHz down‐conversion mixers using a 0.8 µm SiGe hetero‐junction bipolar transistor (HBT) process technology. To fabricate a SiGe HBT, we used a reduced pressure chemical vapor deposition (RPCVD) system to grow a base epitaxial layer, and we adopted local oxidation of silicon (LOCOS) isolation to separate the device terminals. An up‐conversion mixer was implemented on‐chip using an intermediate frequency (IF) matching circuit, local oscillator (LO)/radio frequency (RF) wideband matching circuits, LO/IF input balun circuits, and an RF output balun circuit. The measured results of the fabricated up‐conversion mixer show a positive power conversion gain from 1 to 6 GHz and a bandwidth of about 4.5 GHz. Also, the down‐conversion mixer was implemented on‐chip using LO/RF wideband matching circuits, LO/RF input balun circuits, and an IF output balun circuit. The measured results of the fabricated down‐conversion mixer show a positive power conversion gain from 1 to 8 GHz and a bandwidth of about 4.5 GHz.