Improved magnetic particle tracking technique in dense gas fluidized beds

Noninvasive monitoring of multiphase flow is rapidly gaining increased interest. More specifically noninvasive particle tracking techniques have received a lot of attention in recent years to study dense granular flow. However, these techniques are usually quite expensive and require strict safety measures. An improved magnetic particle tracking (MPT) technique for dense granular flow will be presented in this article. The improvements of the analysis technique for MPT will be demonstrated and rigorously tested with a three‐dimensional system and two‐dimensional sensor system. The strengths and limitations of the MPT technique will also be reported. Finally, the results of the MPT are compared with data obtained from a combined particle image velocimetry and digital image analysis technique. © 2014 American Institute of Chemical Engineers AIChE J, 60: 3133–3142, 2014     

Stearidonic Acid Increases the Red Blood Cell and Heart Eicosapentaenoic Acid Content in Dogs

Plant sources of omega-3 fatty acids (FA) are needed that can materially raise tissue levels of long-chain omega-3 FA [i.e., eicosapentaenoic acid (EPA; 20:5n-3) and docosahexaenoic acid (DHA; 20:6n-3)]. Stearidonic acid (SDA; 18:4n-3) is the delta-6 desaturase product of alpha-linolenic acid (ALA; 18:3n-3), and when fed to humans, increases red blood cell (RBC) content of EPA to a greater extent than does ALA. This study was undertaken to determine the dose-dependence and time course of the increase in the EPA and DHA content of the heart and RBC in dogs. Adult male Beagles were fed 21, 64, or 193 mg/kg of SDA in in their food daily for up to 12 weeks. Positive and negative controls were given EPA (43 mg/kg) or high oleic acid sunflower oil, respectively. The baseline EPA content of RBC was 0.38 ± 0.03% which increased (P < 0.01) in a dose-dependent manner, with the high dose of SDA and EPA achieving levels of 1.33 ± 0.26 and 1.55. ± 0.28%, respectively. In the heart, the content of EPA rose from 0.06 ± 0.01 to 1.24 ± 0.22% in the EPA group and to 0.81 ± 0.32% in the high SDA group (both P < 0.01). In both tissues, DHA did not change. Compared to dietary EPA, SDA was 20–23% as efficient in raising tissue EPA levels. In conclusion, SDA supplementation increased the EPA content of RBC and heart and may have utility as a plant-based source of omega-3 FA.     

Comparison of Repeated Doses of C-kit-Positive Cardiac Cells versus a Single Equivalent Combined Dose in a Murine Model of Chronic Ischemic Cardiomyopathy

Using a murine model of chronic ischemic cardiomyopathy caused by an old myocardial infarction (MI), we have previously found that three doses of 1 × 10⁶ c-kit positive cardiac cells (CPCs) are more effective than a single dose of 1 × 10⁶ cells. The goal of this study was to determine whether the beneficial effects of three doses of CPCs (1 × 10⁶ cells each) can be fully replicated by a single combined dose of 3 × 10⁶ CPCs. Mice underwent a 60-min coronary occlusion; after 90 days of reperfusion, they received three echo-guided intraventricular infusions at 5-week intervals: (1) vehicle × 3; (2) one combined dose of CPCs (3 × 10⁶) and vehicle × 2; or (3) three doses of CPCs (1 × 10⁶ each). In the combined-dose group, left ventricular ejection fraction (LVEF) improved after the 1st CPC infusion, but not after the 2nd and 3rd (vehicle) infusions. In contrast, in the multiple-dose group, LVEF increased after each CPC infusion; at the final echo, LVEF averaged 35.2 ± 0.6% (p < 0.001 vs. the vehicle group, 27.3 ± 0.2%). At the end of the study, the total cumulative change in EF from pretreatment values was numerically greater in the multiple-dose group (6.6 ± 0.6%) than in the combined-dose group (4.8 ± 0.8%), although the difference was not statistically significant (p = 0.08). Hemodynamic studies showed that several parameters of LV function in the multiple-dose group were numerically greater than in the combined-dose group (p = 0.08 for the difference in LVEF). Compared with vehicle, cardiomyocyte cross-sectional area was reduced only in the multiple-dose group (−32.7%, 182.6 ± 15.1 µm² vs. 271.5 ± 27.2 µm², p < 0.05, in the risk region and −28.5%, 148.5 ± 12.1 µm² vs. 207.6 ± 20.5 µm², p < 0.05, in the noninfarcted region). LV weight/body weight ratio and LV weight/tibia length ratios were significantly reduced in both cell treated groups vs. the vehicle group, indicating the attenuation of LV hypertrophy; however, the lung weight/body weight ratio was significantly reduced only in the multiple-dose group, suggesting decreased pulmonary congestion. Taken together, these results indicate that in mice with chronic ischemic cardiomyopathy, the beneficial effects of three doses of CPCs on LV function and hypertrophy cannot be fully replicated with a single dose, notwithstanding the fact that the total number of cells delivered with one or three doses is the same. Thus, it is the multiplicity of doses, and not the total number of cells, that accounts for the superiority of the repeated-dose paradigm. This study supports the idea that the efficacy of cell therapy in heart failure can be augmented by repeated administrations.     

Preparation of BaPbO3 functional ceramics from leaded waste

In this study, Pb was separated and used to prepare BaPbO3 conductive ceramics from leaded waste.The experimental results show that BaPbO3 powder synthesized at 700 °C has particle size of 2–5 lm. The powders were densified by sintering at 1,000 °C for 2 h in the air.Synthesized BaPbO3 ceramics have high Curie temperature and high-temperature positive temperature coefficient（PTC） resistivity characteristics. Electrical resistivity of BaPbO3 compact increases from 5 × 10^-6Ω·m at room temperature to 4 × 10^-4Ω·m at 750 °C. Compared with the one prepared by pure chemical reagents, the BaPbO3 prepared from leaded waste has the similar characteristics of high Curie temperature and PTC resistivity.     

A genetic technique for robotic trajectory planning

There are many multi-stage optimization problems that are not easily solved through any known direct method when the stages are coupled. For instance, the problem of planning a vehicle's control sequence to negotiate obstacles and reach a goal in minimum time is investigated. The vehicle has a known mass, and the controlling forces have finite limits. A genetic programming technique is developed that finds admissible control trajectories that tend to minimize the vehicle's transit time through the obstacle field. The immediate application is that of a space robot that must rapidly traverse around two or three dimensional structures via application of a rotating thruster or non-rotating on-off thrusters. (An air-bearing floor test-bed for such vehicles is located at the Marshal Space Flight Center in Huntsville, Alabama.) It appears that the developed method is applicable to a general set of optimization problems in which the cost function and the multi-dimensional multi-state system can be any non-linear functions that are continuous in the operating regions. Other applications include: the planning of optimal navigation pathways through a traversability graph, the planning of control input for underwater maneuvering vehicles which have complex control state-space relationships, the planning of control sequences for milling and manufacturing robots, the planning of control and trajectories for automated delivery vehicles, and the optimization of control for racing vehicles and athletic training in slalom sports.     

Photon-assisted synthesis of ultra-thin yttria-doped zirconia membranes: Structure, variable temperature conductivity and micro-fuel cell devices

We report on the synthesis and functional properties of nanoscale (50 nm) dense Y-doped zirconia (YDZ) electrolyte thin films by photon-assisted oxidation of Zr–Y precursor alloy thin films. Crystalline zirconia films with grain size of 5 nm were successfully grown at room temperature by oxidation under ultra-violet (UV) photon irradiation. Microstructure of the films was characterized by transmission electron microscopy. The electrochemical conductivity of UV grown YDZ electrolytes was investigated over a broad range of temperatures using Pt electrodes as a function of yttria doping concentration. The slightly lower electrical conductivity in UV grown films at intermediate temperature range (400–550 °C) is consistent with previous reports on oxygen defect annihilation under photo-excitation. Micro-fuel cells utilizing such ultra-thin YDZ membranes yielded 12 mW cm⁻² power density at 550 °C. The results are of potential relevance in advancing low temperature ultra-thin oxide membrane synthesis for energy applications.     

Hydrogen production in steam reforming of glycerol by conventional and membrane reactors

The aim of this study is to produce hydrogen through the glycerol steam reforming process. The reaction is carried out in a traditional reactor and an electrolessly plated Pd/Ag alloy membrane reactor, with varying reaction temperature, weight hourly specific velocity (WHSV) and water glycerol molar ratio (WGMR). The non-catalytic test was also employed for comparative purposes. The results show that the reaction is highly depending on temperature, and the maximum glycerol conversion achieved to 96.24% at 800 °C with a hydrogen yield of 5.82 mol-H₂/mol-C₃H₈O₃. It also found that the Pd/Ag membrane can effectively separate hydrogen from the reaction side and subsequently enhance the reaction rate in the membrane reactor. TGA measurements were employed to quantify the amounts of deposited carbon and the results also confirmed that the CeO₂ modified catalyst can improve the carbon resistance as well as activity and stability.     

Probabilistic seismic damage assessment of reinforced concrete buildings considering directionality effects

Most of buildings and structures are usually projected according to two main axes. However, the geographical position of these buildings varies randomly. Such random distributions of the azimuthal positions of structures, in most of the cities, generally, are not accounted for when assessing their seismic risk; certainly, the direction of the seismic loads is another highly random variable. Moreover, an additional important source of uncertainty is related to the structural response, mainly due to the random character of the mechanical properties. There is a consensus that uncertainties must be considered for adequately assessing the seismic risk of structures, but these directionality effects have not been deeply explored so far. In this article, the influence of the high uncertainty involved in these input variables on the expected seismic damage is analysed. Thus, an actual earthquake, which affected the southern part of Spain, is studied. Notably, damages on a group of affected buildings, located close to the epicentre, are analysed and discussed in detail. The results show that the influence of the random azimuthal position of structures is an important source of uncertainty and that it should be taken into account when estimating the expected seismic risk in urban areas.