Transmission Fiber Chromatic Dispersion Dependence on Temperature: Implications on 40 Gb/s Performance

In this letter, we will evaluate the performance degradation of a 40 km high‐speed (40 Gb/s) optical system, induced by optical fiber variations of the chromatic dispersion induced by temperature changes. The chromatic dispersion temperature sensitivity will be estimated based on the signal quality parameters.     

The Ultrawideband Leaky Lens Antenna

A novel directive and nondispersive antenna is presented: the ultrawideband (UWB) leaky lens. It is based on the broad band Cherenkov radiation occurring at a slot printed between different infinite homogeneous dielectrics. The first part of the paper presents the antenna concept and the UWB design. The issues that are specifically addressed include the impedance matching, the radiation pattern and the phase purity. Subsequently the hardware demonstrator and the results of the measurement campaign are shown. The results fully validate the antenna concept. The antenna presents decade bandwidth impedance matching, directive and frequency independent patterns in the H-plane over two octaves, negligible cross-polarization levels, weak amplitude dispersivity and, according to the authors, the most stable phase center for a directive antenna over an ultra wide frequency range.     

Identification of thermoresistive solar radiation sensors

An identification procedure to estimate the parameters of a thermoresistive solar radiation sensor is presented. The proposed technique employs only electrical excitation for the sensor. The estimation algorithm is recursive and is applied to the sensor model derived from the thermodynamic equilibrium differential equations. The simulation and the experimental results demonstrate the validity of the proposed approach     

Dysprosium doped Ga:La:S glass for an efficient optical fibreamplifier operating at 1.3 μm

The authors present experimental results which indicate that a Dy ³⁺-doped Ga:La:S glass fibre amplifier may be operated efficiently at 1.3 μm with an optimum device length significantly shorter than a comparable Pr³⁺-doped glass fibre amplifier. Moreover, the efficiency exceeds that obtained from the Pr³⁺-doped ZBLAN devices currently available     

Screening of supports for the immobilization of pectinmethylesterase from acerola (Malpighia glabra L)

A partially purified extract of pectinmethylesterase (PME) from acerola fruit was immobilized on various supports: glass, celite, chrysotile, agarose, concanavalin A Sepharose 4B, egg shell, polyacrylamide and gelatin. In addition, reticulation with glutaraldehyde was assessed, as well as the use of gelatin in the presence of celite, glass and silica. The highest immobilization yields were obtained when the pectinmethylesterase was immobilized in concanavalin A Sepharose 4B (81.7%) and in gelatin‐water (78.0%). Copyright © 2004 Society of Chemical Industry     

Electrical Conductivity Measurement Through the Loaded Q Factor of a Resonant Cavity

We present a method for measuring the electrical conductivity of metallic materials that relies on the ratio of two loaded Q factors, Q_R/Q_X, with Q_R corresponding to a TE₀₁₁-mode reference cavity made of aluminum, and Q_X the Q that results upon replacing the aluminum plate with the one fabricated from the material to be examined. Electrical conductivity is mathematically inferred from the ratio Q_R/Q_X where the loaded Q factors are measured by using the transmission-type method. Within a 3.0 percent accuracy, conductivities determined at 8.7 GHz for electrolytic copper (5.6 times 10⁷ S/m) and brass (1.6 times 10⁷ S/m) show to be in good agreement with those reported in the literature.     

Equivalence between Ampere and Grassmann's forces

We calculate the force on part of a single closed circuit due to the remaining circuit in four different geometries according to the forces of Ampere and Grassmann. All analytical calculations are performed using surface or volume current elements in order to avoid the divergences which appear with linear current elements of zero diameter. We conclude that when we consider the action of a closed circuit as a whole and utilize only circuits with closed lines of current, there will be an equivalence between the expressions of Grassmann and Ampere. This means that both of them are compatible with the experimental findings related to Ampere's bridge, contrary to the opinion of some authors