Use of driven piles in rammed holes during construction in soils prone to slump-type settlement

Conclusions The experiment with the use of piles cast in rammed holes in lieu of continuous foundations placed on a bed compacted by tamping produced positive results and will be expanded upon further, since the strength properties of the materials in the foundations and the soils in the foundation beds can be more fully utilized, the reliability of the structure increased, the volume of earthwork reduced, labor and material outlays diminished, and the rate of construction and the level of the industrial nature of the work increased.State Institute for the Projection of the Greenhouse Industry. Translated from Osnovaniya, Fundamenty i Mekhanika Gruntov, No. 2, p. 10, March–April, 1977.     

Design Water Levels in Tidal River Systems under the Influence of Typhoons

Water levels in tidal rivers are subject to the influence of both fluvial and tidal factors. The interaction between these factors is rendered more complex in regions affected by typhoons, which typically result in the combined occurrence of heavy rainfall and high sea levels.
Previous studies have outlined an analytical approach for calculating design water levels based on dividing the fluvial and tidal series into a typhoon and a non-typhoon component. This paper illustrates the steps involved in the analytical approach and describes its application to drainage basins in Hong Kong.
The approach provides a practical means for calculating design water levels, and is recommended for final design purposes. The results of using the full analysis may be approximated by using a sub-set of analytical results, and should prove satisfactory for the purposes of outline design.     

Compartment tests of polyurethane foam seating assemblies

Data from compartment tests of polyurethane foam seating assemblies are reported. Results show that the behavior of such assemblies during fires is strongly dependent on the type and position of interliners and upholstery fabrics. An incidental comparison of peak rate of heat release obtained in a compartment test with a predictive model equation is made and selected data from the tests are presented.     

Decomposing regional productivity growth using an aggregate production frontier

The main contribution of this paper is the implementation of a new model which combines the two parametric approaches most commonly used in the productivity literature: fixed effects and stochastic frontiers. This allows us to discuss whether it is better to use average or frontier functions to estimate regional productivity. The empirical section uses panel data of Spanish regions over the period 1980–1995. Additionally, we calculate and decompose total factor productivity growth for the Spanish regions.     

Toxicity bioassay of heavy metals in water using Tetrahymena pyriformis

The toxicities of five heavy metal compounds on the survival of the ciliated protozoan Tetrahymena pyriformis were determined. Three-day old cultured cells were exposed to five concentrations of each test compound in one or more of three water series; distilled, soft, and hard water. A culture of each sample was placed in a plastic petri dish and covered with mineral oil to prevent evaporation. The cells were counted initially, then again at 0·5 h, 1 h, 2 h, 1 day, 2 days, 3 days, and on the fourth day. Lethal threshold concentrations and tolerance limit medians were determined by graphic methods. On a weight bases cadmium was most toxic, followed in decreasing toxicity by mercury, cobalt, zinc, and lead. Compared to similar fish data, all heavy metals were more toxic to T. pyriformis except lead. The toxicity of lead in soft versus hard water exemplified an antagonistic effect with greater than seven times the amount of lead necessary in hard water to produce comparable mortality as lead in soft water. On the other hand, the toxicity of mercury is about twice as great in hard water as in soft water (a synergistic effect). T. pyriformis appears to be a more sensitive indicator than fish of heavy metal contamination of water. T. pyriformis bioassay should prove a good means of determining the existence of many water pollutants.     

Results of evaluation of the strength of concrete placed in the shafts of cast-in-place piles

Conclusions 1. Application of the method of underwater concreting with the use of a container is inexpedient in connection with the presence of a large number of flaws detected in the shafts of cast-in-place piles formed by this method; concreting of holes by the VAT method is preferable.2. The strength of concrete in the shafts of cast-in-place piles increases, reaching a maximum at a depth of 0.4–0.5 the length of the shaft. Variation in strength along the shaft is explained primarily by the percentage of coarse aggregate contained in the concrete.3. The quality of pile concrete should be monitored during all stages of pile installation, and, primarily during the stage of concreting, i.e., when there is a chance of correcting an observed defect.All-Union Institute for the Design and Planning of Health Resorts. Scientific-Research Institute of Foundations and Underground Structures. Translated from Osnovaniya, Fundamenty i Mekhanika Gruntov, No. 5, pp. 14–17, September–October, 1976.     

Combined biological and ozone treatment of log yard run-off

Batch biological treatment of log yard run-off reduced biochemical oxygen demand (BOD), chemical oxygen demand (COD) and tannin and lignin (TL) concentration by 99%, 80%, and 90%, respectively. Acute (Microtox) toxicity was decreased over treatment, from an initial EC50 of 1.83% to a value of 50.4% after 48 h of treatment. Kinetics of biodegradation were determined using respirometry and fitted using the Monod and Tessier model. For the Monod model the maximum substrate uptake rate, and Ks values determined were 0.0038 mg BOD/mgVSS min, and 1.4 mg/L, respectively. The efficacy of ozone as a pre- and post- biological treatment stage was also assessed. During ozone pretreatment, TL concentration and acute toxicity were rapidly reduced by 70% and 71%, respectively. Pre-ozonation reduced BOD and COD concentration by < 10%, however a larger fraction of residual COD was non biodegradable after ozonation. Biologically treated effluent was subjected to ozonation to determine whether further improvements in effluent quality could be achieved. A reduction in COD and TL concentration was observed during ozonation, however no further improvement in toxicity was observed. Ozonation increased BOD by 38%, due to conversion of COD to BOD.     

Trace-metal concentrations in normal human liver: methods to cope with marked variability

Concentrations of trace elements in human tissues characteristically vary widely, and the distributions of most concentrations are skewed to the right. Examination of some of the factors which contribute to the marked variability and skewness of the concentrations revealed that: (1) distributions of concentrations are satisfactorily normal (Gaussian) after logarithmic transformation, (2) ash weight is the best frame of reference in which to report results, (3) the distributions of metal concentrations are not further normalized by adjustments which assume that tissue lipid or collagen contains a fixed fraction of the metal found in the parenchyma, and (4) the choice of sample site within the liver is of minimal significance.     

Combined nitrification/denitrification in a membrane reactor

An ever stricter legislation regulating wastewater leads to an increasing demand for biological treatment plants which are able to selectively eliminate nitrogen from wastewaters with a high influent concentration, even when operating in partial influent mode. A membrane-tube-module (MSM) reactor (Membran-Schlauch-Modul-Reaktor) was constructed and realized in the IUV at the University of Bremen. The present approach makes use of all the various layers of the whole biofilm, enabling nitrification and denitrification processes to run simultaneously in one and the same biofilm under optimized conditions. The biological degradation capacity of the system was first successfully tested with synthetic wastewater, and subsequently in a real application with effluents from a recycling of animal carcasses plant and from a coke-oven plant. A mathematical model was devised which describes this biofilm system. The resulting equations were solved by means of the simulation software AQUASIM.