浅析企业人才的"留"与"流"

文章分析了人才在企业管理和促进企业发展中的重要性,提出在人才招聘中应注意的三个方面因素,全方位分析了留住人才与人才流动之间的关系.     

Comparisons of PWM and one-cycle control for power amplifier with multilevel converter

Based on the concepts of cascade multilevel converters and one-cycle technique, comparisons are conducted to characterize the distortion of the pulsewidth modulation (PWM) and one-cycle control methods that were applied to converters. Simulation results for the different control schemes are obtained in PSIM software initially to see the effect of one-cycle control different from that of PWM control. Through the comparisons, the advantages and disadvantages are identified for each method. The one-cycle scheme is better than PWM control in reducing undesirable harmonics and tracing dynamic waveforms. Simulation and experimental results are also provided to verify the conclusions.     

Low RF noise and power loss for ion-implanted Si having an improved implantation process

Very-low-transmission line noise of <0.25 dB at 18 GHz and low power loss /spl les/0.6 dB at 110 GHz have been measured on transmission lines fabricated on proton-implanted Si. In contrast, a standard Si substrate gave much higher noise of 2.5 dB and worse power loss of 5 dB. The good RF integrity of proton-implanted Si results from the high isolation impedance to ground, as analyzed by an equivalent circuit model. The proton implantation is also done after forming the transmission lines at a reduced implantation energy of /spl sim/4 MeV. This enables easier process integration into current VLSI technology.     

《石油沥青纸胎油毡》国家标准的修订

《石油沥青纸胎油毡》国家标准进行了第三次修订。本文介绍了修订的理由、修订的内容与依据，并与国内外同类产品标准进行了比较。     

西气东输工程用X70热轧板卷屈服强度检测值波动大的探讨

对西气东输工程用X70热轧板卷检验过程中出的屈服强度σ0.5波动大的情况进行了分析，认为拉伸试样弯曲是主要原因。这一问题可通过反复压平试样，确保试样的平直度以及适当提高钢的强度的方法加以解决。     

An online technique for monitoring the insulation condition of AC machine stator windings

A novel online technique for monitoring the insulation condition of ac machine stator windings is proposed in this paper. The concept is to measure the differential leakage currents of each phase winding from the terminal box in a noninvasive manner to assess the insulation condition during motor operation. The conventional differential CTs used for phase fault protection can be replaced with high performance current sensors to measure the leakage current with higher accuracy. Indicators for insulation condition such as the capacitance and dissipation factor are calculated based on the measurements to provide a low cost solution for online insulation condition assessment. A simplified online insulation system model is derived for analysis and interpretation of the measured data. Experimental results on a 15-hp induction motor under simulated insulation degradation conditions show that the proposed technique is a very sensitive method capable of detecting incipient signs of insulation degradation.     

An overview of electric vehicle technology

An overview of the present status and future trends in electric vehicle technology is provided. The emphasis is on the impact of rapid development of electric motors, power electronics, microelectronics, and new materials. Comparisons are made among various electric drive systems and battery systems. The market size of electric vehicles in the coming years and the potential electric vehicle impacts are discussed     

Mechanism of iodine vapor sorption in polyacetylene

Simultaneous measurements of weight uptake and conductivity variation during iodine vapor sorption of polyacetylenes (PA) at 20–25°C show that the sorption is a two-stages process. For the first stage, iodine diffusion to the fibrilar surface of the cis-rich and trans-rich PA is of Knudsen type pore diffusion as supported by the sorption measurements of hexane for the cis-rich PA, and has a diffusion coefficient in the order of 10⁷ cm²/sec. Conductivity of the PA rises rapidly and reaches a maximum at end of the stage. For the second stage, the diffusion is more restrictive and has a diffusion coefficient lower than the first stage by a factor of about 10 due to multilayer sorption of iodine, which leads to a decrease in the pore diameter and therefor the diffusion rate. In addition to the restricted diffusion in the second stage, diffusion of the iodine molecules adsorped on the fibrilar surface into the interior of the fibrils is appreciable for cis-rich PA (leading to a conductivity drop) and is negliglible for tran-rich PA (leading to insignificant variation in conductivity).     

Advanced concepts in electric vehicle design

In 1994, the Eco-Vehicle Project was begun to develop an electric vehicle (EV) using a ground-up design approach that incorporates unique designs specific to an EV. The Eco-Vehicle will be a high-performance, but ultrasmall, battery-powered vehicle. New designs for the Eco-Vehicle include an in-wheel motor drive system, a hollow load floor which will house the batteries, and a new battery management system. The Eco-Vehicle may also utilize other advanced concepts suitable especially for EVs, including solar panels for battery charging and intelligent crash avoidance and guidance systems     

Ultrathin oxide-nitride dielectrics for rugged stacked DRAMcapacitors

Ultrathin dielectric materials that provide high capacitance values are needed for 64- and 256-Mb stacked DRAMs. It is shown that capacitance values as high as 12.3 fF/μm² can be obtained with ultrathin nitride-based layers deposited on rugged polysilicon storage electrodes. These films present the reliability and low leakage current levels required for 3.3-V applications. The nitride thickness, however, cannot be scaled much below 6 nm to avoid the oxidation-punchthrough mechanisms that appear when too-thin films are unable to withstand the reoxidation step