纳米NiO粉体的制备及其表征

采用溶胶转化－凝胶法制备了纳米级NiO粉体。Ni(OH)2粉体的TG－DSC分析表明：在升温速率为10℃/min的条件下，粉体在489K时开始显著分解，626K时分解完毕。X－射线衍射分析表明：分解产物为纯净的NiO2。NiO粉体的化学成分分析表明：其纯度高于国家标准。TEM电镜分析表明：NiO粉体呈单分散的球形或棒状颗粒。对NiO粉体的热敏性能有待进一步研究。     

壳聚糖和粉煤灰对间甲酚的吸附处理

用壳聚糖和粉煤灰对含间甲酚的废水进行吸附处理,考察了壳聚糖的用量、振荡时间、振荡速度以及粉煤灰与壳聚糖的混合比对处理效果的影响.结果表明:在常温下,对于初始质量浓度为56 mg/L的间甲酚,当壳聚糖用量为3 g/L,以170 r/min的转速吸附振荡0.5 h,去除率可达到88%以上;在上述条件下,加入质量比4:1的粉煤灰与壳聚糖混合物5g/L时,间甲酚的去除率可达到91%.     

Analysing inaccurate artifact usages in workflow specifications

Although many workflow models have been proposed, analyses on artifacts are seldom discussed. A workflow application with well structured and adequate resources may still fail or yield unexpected results in execution due to inaccurate artifact manipulation, for example, inconsistency between data flow and control flow, or contradictions between artifact operations. Thus, artifact analysis is very important since activities cannot be executed properly without accurate information. This paper presents a three-layer workflow model for designing a workflow and characterises the behaviour of an artifact by its state transition diagram. By abstracting common usages of artifacts, six types of inaccurate artifact usage affecting workflow execution are identified and a set of algorithms to detect these inaccurate usages in workflow specifications is presented. An example is demonstrated and then related works are compared.     

酚醛树脂复合板在热连轧机中的应用

重点分析了现有F7机架出口导卫装置的情况。原导卫材料是由铸钢制造 ,由于摩擦和高温常常引起热连轧带钢表面划伤 ,根据现场实际情况用酚醛树脂复合板替代铸钢导卫装置。实践表明 ,这种改造即可行又可靠 ,并取得了好的效果     

A 4.5-GHz 130-nm 32-KB L0 cache with a leakage-tolerant self reverse-bias bitline scheme

This paper describes a 32-KB two-read, one-write ported L0 cache for 4.5-GHz operation in 1.2-V 130-nm dual-V/sub TH/ CMOS technology. The local bitline uses a leakage-tolerant self reverse-bias (SRB) scheme with nMOS source-follower pullup access transistors, while preserving robust full-swing operation. Gate-source underdrive of -220 mV on the bitline read-select transistors is established without external bias voltages or gate-oxide overstress. Device-level measurements in the 130-nm technology show 72/spl times/ bitline active leakage reduction, enabling low-V/sub TH/ usage, 40% bitline keeper downsizing, and 16 bitcells/bitline. 11% faster read delay and 2/spl times/ higher dc noise robustness are achieved compared with high-performance dual-V/sub TH/ bitline scheme. Sustained performance and robustness benefits of the SRB technique against conventional dynamic bitline with scaling to 100- and 70-nm technology is also presented.     

乙烯-1-辛烯共聚物增韧应用研究

介绍了聚烯烃系弹性体（POE）的特点及其在PP增韧改性中的应用，同时还报道了马来酸酐接枝的POE在极性聚合物复合体系中的应用研究。     

Two schemes for detecting CMOS analog faults

A design-for-testability scheme for detecting CMOS analog faults was reported by Favalli et al. (see ibid., vol.25, no.5, p.1239-46, 1990). The authors propose two alternative designs, one for small circuits and another for large circuits, which require significantly less area overhead (about 1/4 to 1/3) than that of Favalli's design. With the proposed modification in the first design, the untestable problem, which occurred in Favalli's design, can be alleviated. Furthermore, the proposed schemes are also fit to be implemented in VLSI circuits     

Change of foot size with weightbearing. A study of 2829 children 3 to 18 years of age

The change of foot length and width with age has been reported in a few anthropometric studies in the literature. However, the relationship with body height rarely is reported, and the dynamic effect of weightbearing on foot size has not been documented. In this series, 2829 children 3 to 18 years of age of equal gender distribution were included in the study. The foot length and width on weightbearing and nonweightbearing were measured with a special precision electronic caliper. The foot length and width were found to increase linearly from the age of 3 years until 12 years in girls and 15 years in boys. This was followed by a phase during which the increase plateaued. The foot length and width increased significantly on weightbearing at all ages in both genders with a mean of 2.1 to 4.4 mm or 3.1% to 4.8%, respectively. The foot length and width also were found to correlate significantly with the body height in both genders, with a correlation coefficient of 0.96 to 0.98. No significant differences were found between the sizes of the dominant and nondominant foot in either gender.     

Configurable nonlinear filter generator

A configurable nonlinear filter generator is proposed. The nonlinear function employed is key controllable. By changing the key, a different sequence will be obtained. Simulated results show that an optimal linear complexity profile of the sequence can be generated