机载相控阵天线辐射方向图的分析

采用一致性几何绕射理论分析了某型预警机机体对其上安装的大型相控阵天线辐射方向图的影响，计算了天线经机体散射后的场，优化了大型相控阵天线安装的最佳位置，为天线装机后辐射性能预测与布局优化提供了理论依据。     

A critical heat flux model based on mass, energy, and momentum balance for upflow boiling at low qualities

A mechanistic modeling of critical heat flux (CHF) in upflow boiling at low qualities is performed. The developed model is based on a physical criterion of CHF occurrence and a mechanism limiting the thermal transport between a stagnant bubbly layer and bulk stream. The mechanism can be mathematically formulated by coupling the equation of limiting mixing mass flux, which is derived from momentum balance equations in two regions, with local mass and energy balance equations on the bubbly layer. The resulting form of the model is represented by a general and straightforward CHF formula involving two empirical constants related to the void fraction and the thickness of the bubbly layer. The predictions agree well with the extensive CHF data of water in uniformly heated tubes.     

8Li次级束的产生

在北京串列加速器次级束流线上通过2 H(7Li,8Li) 1H逆运动学反应产生了用于核天体物理研究的8Li次级束。准直后的次级束纯度达到 80 %以上 ,对于 44MeV的7Li强度约为 3 0s- 1·pnA- 1,可以用来进行逆几何转移反应的实验测量。     

Adaptive motion control using neural network approximations

In this paper, we present a new adaptive technique for tracking control of mechanical systems in the presence of friction and periodic disturbances. Radial Basis Functions (RBFs) are used to compensate for the effects of nonlinearly occurring parameters in the friction and periodic disturbance model. Theoretical analysis, such as stability and transient performance, is provided. Furthermore, the performance of the adaptive RBF controller and its non-adaptive counterpart are compared.     

Model-based channel estimation for OFDM signals in Rayleigh fading

This paper proposes a robust pilot-assisted channel estimation method for orthogonal frequency division multiplexing (OFDM) signals in Rayleigh fading. Our estimation method is based on nonlinear regression channel models. Unlike the linear minimum mean-squared error (LMMSE) channel estimate, the method proposed does not have to know or estimate channel statistics like the channel correlation matrix and the average signal-to-noise ratio (SNR) per bit. Numerical results indicate that the performance of the proposed channel estimator is very close to the theoretical bit error propagation lower bound that is obtained by a receiver with perfect channel response information     

宽带线性调频信号产主技术研究

本文介绍了采用数字基带产生结合倍频链扩展带宽的方法设计与实现了大带宽线性调频信号产生系统。详细分析研究了实现系统的三项关键技术，给出并分析了相应环节的输出信号。对系统进行了预失真补偿处理，成功实现了ＶＨＦ／ＵＨＦ波段、带宽达３００ＭＨｚ线性调频信号的产生。经脉冲压缩处理，主瓣旁瓣比（ＰＳ１Ｒ）在－３７ｄＢ以下。     

国内电子商务门户网站的现状研究

从电子商务在我国迅速发展的角度出发，系统地介绍了我国电子商务网站的典范：阿里巴巴、淘宝。从电子商务的模式出发分析了其经营理念，成功因素及其不足，对中国的电子商务目前状况作了分析，并提出展望。     

基于MATLAB语言的自动控制原理多媒体教学研究

结合我校自动化专业教学，从培养高素质，复合型人才的角度，在教学中引入目前世界上流行的MATLAB软件，并把MATLAB语言应用于经典控制系统设计和分析中，在自动控制原理多媒体辅助教学方面做了一些有益尝试和探索，取得了满意的教学效果。     

《砌体工程施工质量验收规范》GB50203-2002内容简介

简要介绍国家标准《砌体工程施工质量验收规范》GB5 0 2 0 3 2 0 0 2的主要特点及内容。其中 ,着重介绍强制性条文的内容及与原相关规范、标准变更修改部分的说明     

Phase equilibria of the ternary Al-Cu-Ni system and interfacial reactions of related systems at 800 °C

A series of Al-Cu-Ni alloys of various compositions were made and annealed at 800 °C. The equilibrium phases were studied by metallography, X-ray diffraction (XRD) analysis, and electron probe microanalysis. The isothermal section of the ternary Al-Cu-Ni system at 800 °C was then determined based on these experimental results and the available phase relationship knowledge of the three constituent binary systems. No ternary compound was found. All three phases, AlNi₃, AlNi, and Al₃Ni₂, have very high ternary solubility, especially the AlNi phase, which almost reaches the binary Al-Cu side. However, no continuous solid solution was formed between the AlNi phase and any of the binary Al-Cu phases. Interfacial reactions of Al/Ni, Al/Cu, Al-Cu/Ni, and Al-Ni/Cu at 800 °C were investigated by using reaction couple techniques. The results showed that Al₃Ni and Al₃Ni₂ phases were formed in the Al/Ni couples; β-AlCu₄, γ ₁-Al₄Cu₉, and ɛ ₂-Al₂Cu₃ phases were formed in the Al/Cu couples. As for the results in the Al-2 at. pct Ni/Cu, Al-5 at. pct Ni/Cu, and Al-2 at. pct Cu/Ni, Al-4.5 at. pct Cu/Ni, and Al-6 at. pct Cu/Ni were similar to those in the binary Al/Cu and Al/Ni couples, respectively. A different reaction path was found in the Al-7.5 at. pct Cu/Ni couples, and an AlNi solid solution layer was formed instead of the Al₃Ni and Al₃Ni₂ phases.