Household air pollution from wood burning in two reconstructed houses from the Danish Viking Age

During 13 winter weeks, an experimental archeology project was undertaken in two Danish reconstructed Viking Age houses with indoor open fireplaces. Volunteers inhabited the houses under living conditions similar to those of the Viking Age, including cooking and heating by wood fire. Carbon monoxide (CO) and particulate matter (PM_2.5) were measured at varying distances to the fireplace. Near the fireplaces CO (mean) was 16 ppm. PM_2.5 (mean) was 3.40 mg/m³, however, measured in one house only. The CO:PM mass ratio was found to increase from 6.4 to 22 when increasing the distance to the fire. Two persons carried CO sensors. Average personal exposure was 6.9 ppm, and from this, a personal PM_2.5 exposure of 0.41 mg/m³ was estimated. The levels found here were higher than reported from modern studies conducted in dwellings using biomass for cooking and heating. While this may be due to the Viking house design, the volunteer's lack of training in attending a fire maybe also played a role. Even so, when comparing to today's issues arising from the use of open fires, it must be assumed that also during the Viking Age, the exposure to woodsmoke was a contributing factor to health problems.     

Synthesis and biological properties of novel pyridinioalkanoyl thiolesters (PATE) as anti-HIV-1 agents that target the viral nucleocapsid protein zinc fingers

Nucleocapsid p7 protein (NCp7) zinc finger domains of the human immunodeficiency virus type 1 (HIV-1) are being developed as antiviral targets due to their key roles in viral replication and their mutationally nonpermissive nature. On the basis of our experience with symmetrical disulfide benzamides (DIBAs; Rice et al. Science 1995, 270, 1194-1197), we synthesized and evaluated variants of these dimers, including sets of 4,4'- and 3,3'-disubstituted diphenyl sulfones and their monomeric benzisothiazolone derivatives (BITA). BITAs generally exhibited diminished antiviral potency when compared to their disulfide precursors. Novel, monomeric structures were created by linking haloalkanoyl groups to the benzamide ring through -NH-C(=O)- (amide) or -S-C(=O)- (thiolester) bridges. Amide-linked compounds generally lacked antiviral activity, while haloalkanoyl thiolesters and non-halogen-bearing analogues frequently exhibited acceptable antiviral potency, thus establishing thiolester benzamides per se as a new anti-HIV chemotype. Pyridinioalkanoyl thiolesters (PATEs) exhibited superior anti-HIV-1 activity with minimal cellular toxicity and appreciable water solubility. PATEs were shown to preferentially target the NCp7 Zn finger when tested against other molecular targets, thus identifying thiolester benzamides, and PATEs in particular, as novel NCp7 Zn finger inhibitors for in vivo studies.     

Adsorption kinetics and mechanical properties of thiol-modified DNA-oligos on gold investigated by microcantilever sensors

Immobilised DNA-oligo layers are scientifically and technologically appealing for a wide range of sensor applications such as DNA chips. Using microcantilever-based sensors with integrated readout, we demonstrate in situ quantitative studies of surface-stress formation during self-assembly of a 25-mer thiol-modified DNA-oligo layer. The self-assembly induces a surface-stress change, which closely follows Langmuir adsorption model. The adsorption results in compressive surface-stress formation, which might be due to intermolecular repulsive forces in the oligo layer. The rate constant of the adsorption depends on the concentration of the oligo solution. Based on the calculated rate constants a surface free energy of the thiol-modified DNA-oligo adsorption on gold is found to be -32.4 kJ mol(-1). The adsorption experiments also indicate that first a single layer of DNA-oligos is assembled on the gold surface after which a significant unspecific adsorption takes place on top of the first DNA-oligo layer. The cantilever-based sensor principle has a wide range of applications in real-time local monitoring of chemical and biological interactions as well as in the detection of specific DNA sequences, proteins and particles.     

New dendrimer-peptide host-guest complexes: towards dendrimers as peptide carriers

Adamantyl urea and adamantyl thiourea modified poly(propylene imine) dendrimers act as hosts for N-terminal tert-butoxycarbonyl (Boc)-protected peptides and form chloroform-soluble complexes. Investigations with NMR spectroscopy show that the peptide is bound to the dendrimer by ionic interactions between the dendrimer outer shell tertiary amines and the C-terminal carboxylic acid of the peptide, and also through host-urea to peptide-amide hydrogen bonding. The hydrogen-bonding nature of the peptide-dendrimer interactions was further confirmed by using Fourier transform IR spectroscopy, for which the NH- and CO-stretch signals of the peptide amide moieties shift towards lower wavenumbers upon complexation with the dendrimer. Spatial analysis of the complexes with NOESY spectroscopy generally shows close proximity of the N-terminal Boc group of the peptide to the peripheral adamantyl groups on the dendrimer host. The influence of side-chain motif on interactions with the host is analyzed by using seven different N-Boc-protected tripeptides as guests for the dendrimer. Downfield shifts of up to 1.3 ppm were observed for the guest amide NH-proton signals. These shifts decreased with increasing 'bulkiness' of the amino acid side chains. Despite this, the dendrimer was capable of making multiple peptide-dendrimer complexes when presented with a library of seven peptides. The different peptides were all present in the host, which did not show specific preferences, and could be released under mild acidic conditions. These results show the general nature of the peptide-dendrimer interactions in the formation of either single- or multiple-peptide-dendrimer complexes.     

Efficient parametric coding of transients

In this paper, methods for improved parametric coding of transients are presented. We propose a signal model for coding of transients consisting of a sum of sinusoids each being amplitude-modulated by a different gamma envelope. These envelopes are characterized by an onset time, an attack and a decay parameter. An efficient method for estimating these parameters is presented. Further, methods are proposed that combine this transient model with a constant-amplitude sinusoidal model in order to achieve efficient coding of both stationary and transient signal parts. By rate-distortion optimization using a perceptual distortion measure, we combine variable rate bit allocation and segmentation in an optimal way. Formal, as well as informal, listening tests show that significant improvements can be achieved with the proposed model as compared to a state-of-the-art sinusoidal coder by the combination of optimal segmentation and amplitude modulated sinusoidal audio coding.     

The effect of changing excitation frequency on parallel conductance in different sized hearts

OBJECTIVE: An important component of the ventricular volume measured using the conductance catheter technique is due to parallel conductance (Vc), which results from the extension of the electric field beyond the ventricular blood pool. Parallel conductance volume is normally estimated using the saline dilution method (Vc(saline dilution)), in which the conductivity of blood in the ventricle is transiently increased by injection of hypertonic saline. A simpler alternative has been reported by Gawne et al. [12]. Vc(dual frequency) is estimated from the difference in total conductance measured at two exciting frequencies and the method is based on the assumption that parallel conductance is mainly capacitive and hence is negligible at low frequency. The objective of this study was to determine whether the dual frequency technique could be used to substitute the saline dilution method to estimate Vc in different sized hearts. METHODS: The accuracy and linearity of a custom-built conductance catheter (CC) system was initially assessed in vitro. Subsequently, a CC and micromanometer were inserted into the left ventricle of seven 5 kg pigs (group 1) and six 50 kg pigs (group 2). Cardiac output was determined using thermodilution (group 1) and an ultrasonic flow probe (group 2) from which the slope coefficient (alpha) was determined. Steady state measurements and Vc estimated using saline dilution were performed at frequencies in the range of 5-40 kHz. All measurements were made at end-expiration. Finally, Vc was estimated from the change in end-systolic conductance between 5 kHz and 40 kHz using the dual frequency technique of Gawne et al. [12]. RESULTS: There was no change in measured volume of a simple insulated cylindrical model when the stimulating frequency was varied from 5-40 kHz. Vc(saline dilution) varied significantly with frequency in group 1 (8.63 +/- 2.74 ml at 5 kHz; 11.51 +/- 2.65 ml at 40 kHz) (p = 0.01). Similar results were obtained in group 2 (69.43 +/- 27.76 ml at 5 kHz; 101.24 +/- 15.21 ml at 40 kHz) (p < 0.001). However, the data indicate that the resistive component of the parallel conductance is substantial (Vc at 0 Hz estimated as 8.01 ml in group 1 and 62.3 ml in group 2). There was an increase in alpha with frequency in both groups but this did not reach significance. The correspondence between Vc(dual frequency) and Vc(saline dilution) methods was poor (group 1 R2 = 0.69; group 2 R2 = 0.22). CONCLUSION: At a lower excitation frequency of 5 kHz a smaller percentage of the electric current extends beyond the blood pool so parallel conductance is reduced. While parallel conductance is frequency dependent, it has a substantial resistive component. The dual frequency method is based on the assumption that parallel conductance is negligible at low frequencies and this is clearly not the case. The results of this study confirm that the dual frequency technique cannot be used to substitute the saline dilution technique.