Use of weibull statistics to quantify property variability in TiAl alloys

Tensile experiments have been performed on specimens of four different investment-cast TiAl-based alloys with variations in casting conditions. The average ductilities obtained in these experiments vary between approximately 0.8 to 2.0 pct plastic strain to failure in tension. By using the three-parameter form of the Weibull relation, with the 0.2 pct offset yield strength as the minimum failure strength, the resulting variability in the data can be quantified and is found to be similar for those alloys with similar microstructural scale (grain size). Large variations in lamellar volume fraction, segregation, and phase distribution have a minor influence on property variability, compared to changes in the scale of the grain structure caused by either variations in cooling rate during casting or the addition of grain refiners.     

用化学腐蚀制备多孔硅太阳电池减反射膜的研究

采用HF HNO3溶液化学腐蚀 ,在硅片上制备减反射效果优良的多孔硅太阳电池减反射膜 ,借助原子力显微镜 (AFM)和X光电子谱 (XPS)对其表面形貌和成分进行观察 ,发现该膜与电化学阳极腐蚀得到的多孔硅具有相似性 ,其主要成分为非化学配比的硅的氧化物SiOx(X <2 )。采用带积分球的光度分光计 ,测得形成多孔硅减反射膜后 ,硅片表面反射率大大下降 ,,在波长 330～ 80 0nm范围反射率只有 1 5～ 2 9%。研究指出这种强减反射作用 ,与多孔硅具有合适的折射率及其多孔特性的光陷阱作用有关     

水蒸汽喷射泵系统实用设计软件的开发

本文在Turboc环境下开发了多级蒸汽喷射泵系统的设计软件，该软件包括了压缩比优化分配、单级喷射泵结构尺寸设计和冷凝器的结构尺寸设计等内容，使设计人员能够根据具体的工艺条件，快速地完成多级喷射泵系统的设计，对于提高多级喷射泵系统的工作稳定性、节省能源具有实际意义。     

Fuzzy versus quantitative association rules: a fair data-driven comparison.

As opposed to quantitative association rule mining, fuzzy association rule mining is said to prevent the overestimation of boundary cases, as can be shown by small examples. Rule mining, however, becomes interesting in large databases, where the problem of boundary cases is less apparent and can be further suppressed by using sensible partitioning methods. A data-driven approach is used to investigate if there is a significant difference between quantitative and fuzzy association rules in large databases. The influence of the choice of a particular triangular norm in this respect is also examined.     

用迭代法消除数字图像放大后的模糊

用迭代法对数字图像经过插值放大后产生的模糊问题进行了研究，把数字图像插值放大造成的模糊看成是点扩散函数与清晰图像卷积的结果，根据插值算法可以得到点扩散函数，由于数字图像解卷积是典型的解线性方程组的问题，用雅可比（Jacobi）迭代法得到了很好的结果。与频谱空间变换的方法相比，迭代法没有分母为0的问题和空间变换过程造成的舍入误差。     

Macroscopic and crystallographic density of solid-state extruded polyethylene

Summary The influence of draw ratio on macroscopic and crystallographic density of polyethylene with different initial morphologies, has been investigated by solid-state extrusion. An initial drop followed by an increase in macroscopic density as a function of draw ratio has been observed. Since precision X-ray measurements of unit cell parameters showed no variation of crystallographic density, it was concluded that plastic deformation of polyethylene upon drawing proceeds with a decrease of the degree of crystallinity. This was confirmed by differential scanning calorimetry.     

Efficient data processing and quantum phenomena: Single-particle systems

We study the relation between the acquisition and analysis of data and quantum theory using a probabilistic and deterministic model for photon polarizers. We introduce criteria for efficient processing of data and then use these criteria to demonstrate that efficient processing of the data contained in single events is equivalent to the observation that Malus' law holds. A strictly deterministic process that also yields Malus' law is analyzed in detail. We present a performance analysis of the probabilistic and deterministic model of the photon polarizer. The latter is an adaptive dynamical system that has primitive learning capabilities. This additional feature has recently been shown to be sufficient to perform event-by-event simulations of interference phenomena, without using concepts of wave mechanics. We illustrate this by presenting results for a system of two chained Mach-Zehnder interferometers, suggesting that systems that perform efficient data processing and have learning capability are able to exhibit behavior that is usually attributed to quantum systems only.     

Avalanche multiplication in a compact bipolar transistor model forcircuit simulation

A simple weak avalanche model valid in a wide range of voltages and currents, is presented. The proposed model is derived by using the base-collector depletion capacitance for predicting the avalanche current. The model needs only one additional transistor parameter; the extraction method and temperature dependence of this parameter are discussed. The decrease in avalanche current for high collector current densities may originate from internal device heating, a voltage drop in the epilayer, or mobile carriers in the depleted part. From experimental results it is concluded that, below a critical hot-carrier current, the decrease in avalanche current due to mobile carriers is negligible     

Preparation and photochromism of nanocomposite thin film based on polyoxometalate and polyethyleneglycol

A photochromic nanocomposite based on Keggin structure phosphomolybdic acid (PMoA) well dispersed in polyethyleneglycol (PEG) was fabricated. TEM image showed that PMoA nanoparticles with narrow size distribution were finely dispersed in polymer matrix. FT-IR results showed that the Keggin geometry of polyoxometalates was still preserved inside the composites and strong coulombic interaction was built between PMoA and polymer matrix. Under UV irradiation, the film was reduced photochemically to yield a blue species, which was in accordance with a charge-transfer mechanism.     

An integrated system to remote monitor and control anaerobic wastewater treatment plants through the internet.

The TELEMAC project brings new methodologies from the Information and Science Technologies field to the world of water treatment. TELEMAC offers an advanced remote management system which adapts to most of the anaerobic wastewater treatment plants that do not benefit from a local expert in wastewater treatment. The TELEMAC system takes advantage of new sensors to better monitor the process dynamics and to run automatic controllers that stabilise the treatment plant, meet the depollution requirements and provide a biogas quality suitable for cogeneration. If the automatic system detects a failure which cannot be solved automatically or locally by a technician, then an expert from the TELEMAC Control Centre is contacted via the internet and manages the problem.