Tensor Q-rank: new data dependent definition of tensor rank

Machine Learning - Recently, the $${ Tensor}~{ Nuclear}~{ Norm}~{ (TNN)}$$ regularization based on t-SVD has been widely used in various low tubal-rank tensor recovery tasks. However, these models...     

一种基于Spark的不确定数据集频繁模式挖掘算法

如何在海量不确定数据集中提高频繁模式挖掘性能是目前研究的热点.传统算法大多是以期望、概率或者权重等单一指标为数据项集支持度，在大数据背景下，同时考虑概率和权重支持度的算法难以兼顾其执行效率.为此，本文提出一种基于Spark的不确定数据集频繁模式挖掘算法（UWEFP），首先，为了同时兼顾数据项的概率和权重，计算一项集的最大概率权重值并进行剪枝；然后，为了减少对数据集的多次扫描，结合Spark框架的优点，设计了一种具有FP-tree特征的新颖的UWEFP-tree结构进行模式树的构建及挖掘；最后在Spark环境下，以UCI数据集进行实验验证.实验结果表明本文的方法在保证挖掘结果的同时，提高了效率.     

Flame Front Deformation Instabilities of Filtration Combustion for Initial Thermal Perturbation

The flame front deformation instability of low-velocity filtration combustion within an inert packed bed is studied based on the initial preheating non-uniformity. Based on the experimental phenomena, an initial thermal perturbation model is numerically proposed so as to predict the deformation behaviors of the flame front instabilities. The numerical prediction indicates that the assumption of an initial thermal perturbation is a feasible explanation as the cause of the flame front inclination instability. As the initial thermal perturbation increases, the phenomena of the flame front break and shrinking instabilities could easily occur at high filtration velocity or low equivalence ratio. Moreover, the evolutions of the flame front break rate and the shrinking rate are quantitatively analyzed.     

Sol-Gel Preparation and Luminescence Properties of BaMgAl10O17∶Eu2+ Phosphors

The synthesis of BaMgAl10O17∶ Eu2 (BAM) phosphors using the sol-gel method and their luminescence properties were reported. The blue-light emitting BAM was synthesized using citric acid and ethylene glycol as chelating materials. Emission of blue-light was obtained from these phosphors. The luminescent intensity increases as the temperature of heat treatment is increased. This study investigated the effects of the molar ratio of ethylene glycol to citric acid (Φ value), with respect to the phase formation and luminescence properties of BAM. The variation of the Φ value resulted in the change of the sol-gel reaction mechanism and the microstructures of the resultant powders. An increase in Φ value leads to an increase in the rate of BAM phase formation. The photoluminescent intensity of the prepared phosphors increases with heating temperatures because of enhanced crystallization.     

基于AD9851的高频高压脉冲发生器设计

当前脉冲发生器里的脉冲形成器件,大部分是用火花气隙（spark gap）和高压电子开关（high voltageswitch）.采用火花气隙充当脉冲形成器件有很多弊病：（1）火花气隙在低于1kV时,在机械和电气上不稳定,所以对低于2kV的试验电压要通过分压器来得到.     

RF磁控溅射制备钛酸锶钡BST纳米薄膜

钛酸锶钡(BST)薄膜作为一种高K介质材料在微电子和微机电系统等领域具有广阔的应用前景,人们已对BST薄膜的制备工艺技术和介电性能进行了大量的研究。BST纳米薄膜的制备工艺直接影响和决定着薄膜的介电性能(介电常数、漏电流密度、介电强度等)。对RF磁控反应溅射制备BST纳米薄膜的工艺技术进行了综述。从溅射靶的制备、溅射工艺参数的优化、热处理、薄膜组分的控制,及制备工艺对介电性能的影响等方面,对现有研究成果进行了较全面的总结。     

Performance study of iSCSI-based storage subsystems

iISCSI is emerging as an end-to-end protocol for transporting storage I/O block data over IP networks. By exploiting the ubiquitous Internet infrastructure, iSCSI greatly facilitates remote storage, remote backup, and data mirroring. This article evaluates the performance of two typical iSCSI storage subsystems by measuring and analyzing block-level I/O access performance and file-level access performance. In the file-level performance study, we compare file access performance in an NAS scheme with that in an iSCSI-based SAN scheme. Our test results show that Gigabit Ethernet-based iSCSI can reach very high bandwidth, close to that of a direct FC disk access in block I/O access. However, when the iSCSI traverses through longer distance, throughput relies heavily on the available bandwidth between the initiator and the target. On the other hand, the file-level performance shows that iSCSI-based file access (SAN scheme) provides higher performance than using NFS protocol in Linux and SMB protocol in Windows (NAS scheme). However, the advantage of using iSCSI-based file accesses decreases as the file size increases. The obtained experimental results shed some light on the performance of applications based on iSCSI storage.     

铌和钨对γ-TiAl基合金热稳定性的影响

采用光学显微镜(OM)，扫描电镜(SEM)，X射线衍射研究了TiAl—5Nb，TiAl—14．3Nb，TiAl—8Nb—1W，TiAl—12．3Nb-2W四种合金片层组织在1000℃的热稳定性。结果表明，TiAl—12．3Nb-2W合金热稳定性最好，但合金元素对TiAl基合金热稳定性的影响机理还有待进一步的研究。     

有植被的河道水流紊动特性模型试验研究

通过物理模型试验,研究了有植被的河道水流紊动特性.试验结果表明,在复式断面河道滩地种植柔性植被后,滩地糙率增大,水流紊动更为剧烈,河道水流紊动强度峰值由原先的滩槽交界区转移到滩地区.滩地的水流紊动强度沿程递减;滩槽交界区的水流紊动强度沿程不断增大;主槽的水流紊动强度主要与床面糙率有关,滩地植被影响了滩地水流的归槽时间,使主槽水流流速沿程增大.     

片式多层陶瓷微波谐振器

介绍了片式陶瓷微波谐振器的工艺过程、谐振器的结构以及结构对谐振器参数的影响,谐振器与外电路的耦合采用耦合间隙的方法与谐振单元在同一层内实现,这种新结构既可给制备工艺带来方便,又可减少工艺所带来的误差。用多层陶瓷工艺技术,用高介电常数、低温烧结微波陶瓷实现了中心频率为1GHz,有载品质因数大于80的试验双端口多层微波谐振器。微波谐振器体积小,整个谐振器的尺寸为7mm×2mm×1mm,适用于表面贴装技术。