Effect of Clean Air Core Geometry on Fine Particle Contamination And Calibration of a Virtual Impactor

ABSTRACT

The optimum diameter and position of the clean air core in a clean air core virtual impactor were experimentally determined. It was found that the clean air core diameter should be at least twice as large as the converging nozzle diameter and that the clean air core should be positioned so that the ratio of the clean air flow velocity to the aerosol flow velocity ranges from 1.5 to 5.0 at the outlet of the clean air tube. Use of a laminator in a virtual impactor was found to increase the particle loss while maintaining almost the same collection efficiency curve.     

EXTRACTION OF URANYL IONS BY SYNERGISTIC MIXTURES OF THENOYLTRIFLUOROACETONE AND MACROCYCLIC DONORS

A linear polyether, 1, 13-bis[8-qulnoly]-l,4,7,10,13-pentaoxa-trldecane (K-5) and an aza-crown ether, 4,13-didodecyl-1,7,10,16-tetraoxadiazacyclooctadecane (K22DD) when combined with thenoyltrlfluoroacetone (HTTA) have been shown to exhibit a synergistic effect on the extraction of uranyl ion. The effects of the addition to the organic phase of K-5, K22DD, and tert-butylcyclohexyl-15-crown-5 (15-C-5) on the extraction of UO₂ ⁺² by HTTA in chloroform from 0.5 M NaNO₃ at 25°C have been measured. The results indicate the extraction is enhanced by the formation of an adduct, UO₂(TTA)₂S for K-5 and K22DD. No enhancement of the extraction was seen with the crown ether. The organic phase stability constants for both K-5 and K22DD were evaluated and found to be similar in magnitude. These results suggest that the major factor in the formation of the synergistic adduct is the presence of the nitrogen atom in the synergist.     

Mechanisms of Solution Reactions of Cyclo-Penta[cd]Pyrene Oxide and Acenaphthylene Oxide

Rates and products of the acid-catalyzed and spontaneous reactions of cyclopenta[cd]pyrene oxide (2) and acenaphthalene oxide (3) in 1:3 dioxane-water and water, respectively, have been determined. Both 2 and 3 undergo acid-catalyzed hydrolyses to yield cis diol as the major product, and undergo spontaneous reactions to yield predominantly ketone products. The mechanisms of these reactions are discussed.     

Effect of the Interfacial Transition Zone on the Conductivity of Portland Cement Mortars

The electrical conductivity of portland cement mortars was determined experimentally as a function of the volume fraction of sand and the degree of hydration. The results were analyzed using theoretical models that represent the mortars as three-phase, interactive composites. The three phases are the matrix paste, the aggregate, and the thin interfacial transition zone between the two. The microstructure and properties of the conductive phases (the transition zone and the matrix paste) were determined by a micrometer-scale microstructural model, and were used in conjunction with random-walk algorithms and differential-effective medium theory to determine the overall mortar conductivities. The presence of the transition zone was not found to significantly affect the global electrical conductivity of the mortar. However, there were significant differences in conductivity between the transition zone and matrix pastes when examined on a local level. These differences were found to vary with hydration and were most significant when the degree of hydration was between 0.5 and 0.8.     

Piloting of anionic polymerization of styrene in tetrahydrofurant

Anionic polymerization of styrene in THF with n‐butyllithium/alpha‐methylstyrene initiator is described as a first step in preparation of a styrenic block copoly‐mer. In order to suppress rapid decay of living alpha‐methylstyrene unimers, which occurred at room temperature, the initiation reaction was carried out at ?20(+5)°C. The kinetic parameters of this decay reaction were determined and used for process optimization. By combining experiments with modelling of styrene propagation reaction all key process parameters were defined for l‐L, 38‐L, and 189‐L reactors. A good match was demonstrated between the model and experimental propagation exotherm for semibatch reaction conditions. Overall, it was demonstrated that technical grade THF and styrene could be used at pilot plant scale to prepare well‐defined polymers up to Mn 22 000 via the “living” polymerization mechanism. The resulting polymers had narrow molecular weight distributions (1.06 < Mw/Mn < 1.30).     

Water absorption in internally cured mortar made with water-filled lightweight aggregate

The increased propensity for shrinkage cracking in low water-to-cement ratio (w/c) concrete has inspired the development of new technologies that can reduce the risk of early-age cracking. One of these is internal curing. Internal curing uses saturated lightweight aggregate to supply ‘curing water’ to low w/c paste as it hydrates. Significant research has been performed to determine the effects of internal curing on shrinkage and stress development; however, relatively little detailed information exists about the effects of internal curing on fluid transport properties such as water absorption or diffusivity. This study examines the absorption of water into mortar specimens made with saturated lightweight aggregates (SLWA). These results indicate that the inclusion of SLWA can reduce the water absorption of mortar specimens. This observation was reinforced with electrical conductivity measurements that exhibited similar reductions.     

Changing perceptions of hunger on a high nutrient density diet

Background  

People overeat because their hunger directs them to consume more calories than they require. The purpose of this study was to analyze the changes in experience and perception of hunger before and after participants shifted from their previous usual diet to a high nutrient density diet.     

Polyphenol Supplementation Reverses Age-Related Changes in Microglial Signaling Cascades

Microglial activity in the aging neuroimmune system is a central player in aging-related dysfunction. Aging alters microglial function via shifts in protein signaling cascades. These shifts can propagate neurodegenerative pathology. Therapeutics require a multifaceted approach to understand and address the stochastic nature of this process. Polyphenols offer one such means of rectifying age-related decline. Our group used mass spectrometry (MS) analysis to explicate the complex nature of these aging microglial pathways. In our first experiment, we compared primary microglia isolated from young and aged rats and identified 197 significantly differentially expressed proteins between these groups. Then, we performed bioinformatic analysis to explore differences in canonical signaling cascades related to microglial homeostasis and function with age. In a second experiment, we investigated changes to these pathways in aged animals after 30-day dietary supplementation with NT-020, which is a blend of polyphenols. We identified 144 differentially expressed proteins between the NT-020 group and the control diet group via MS analysis. Bioinformatic analysis predicted an NT-020 driven reversal in the upregulation of age-related canonical pathways that control inflammation, cellular metabolism, and proteostasis. Our results highlight salient aspects of microglial aging at the level of protein interactions and demonstrate a potential role of polyphenols as therapeutics for age-associated dysfunction.     

Minimization of artifacts in sulfuric acid mist measurement using NIOSH Method 7903

NIOSH Method 7903 employs a silica gel tube for sulfuric acid mist measurement in workplaces. However, SO2 gas present in the sample volume can be transformed into sulfate in the sampling process causing an artifact that is reported as sulfuric acid. A sampling train incorporating a honeycomb denuder system was applied for field sampling at seven phosphate fertilizer plants to evaluate its use for reducing the artifact sulfate concentration while preserving the actual sulfuric acid mist concentration. The denuder system was designed to remove SO2 gas before the air entered the silica gel tube and to monitor SO2 concentration at the same time. A deactivation model was also applied to correct for the presence of the artifact. The denuder system had 95.7 +/- 6.8% collection efficiency for SO2 gas, and the impact of sulfate aerosol on SO2 collection was negligible. SO2 concentrations at the seven plants ranged from 34 ppb to 5.6 ppm. The honeycomb denuder system and the deactivation model were shown to reduce the artifact sulfate concentration by 70% and 39%, respectively. However, they were still higher than the sulfate aerosol concentration measured by a cascade impactor. One possible reason is the residual sulfate in the glass fiber filter and the silica gel.