Reactivity of steam in exhaust gas catalysis III. Steam and oxygen/steam conversions of propane on a Pd/Al2O3 catalyst

A 1% Pd catalyst (38% dispersion) was prepared by impregnating a γ-alumina with palladium acetylacetonate dissolved in acetone. The behaviour of this catalyst in oxidation and steam reforming (SR) of propane was investigated. Temperature-programmed reactions of C₃H₈ with O₂ or with O₂ + H₂O were carried out with different stoichiometric ratios S(S =[O₂]/5[C₃H₈]). The conversion profiles of C₃H₈ for the reaction carried out in substoichiometry of O₂ (S < 1) showed two discrete domains of conversion: oxidation at temperatures below 350°C and SR at temperatures above 350°C. The presence of steam in the inlet gases is not necessary for SR to occur: there is sufficient water produced in the oxidation to form H₂ and carbon oxides by this reaction. Contrary to what was observed with Pt, an apparent deactivation between 310 and 385°C could be observed with Pd in oxidation. This is due to a reduction of PdO_x into Pd⁰, which is much less active than the oxide in propane oxidation. Steam added to the reactants inhibits oxidation while it prevents the reduction of PdO_x into Pd⁰. Compared to Pt and to Rh, Pd has a higher thermal resistance: no deactivation occurred after treatment up to 700°C and limited deactivation after treatment up to 900°C, provided that the catalyst is maintained in an oxygen-rich atmosphere during the cooling.     

Effect of the pressure drop rate on cell nucleation in continuous processing of microcellular polymers

Microllular plastics are cellular polymers characterized by cell densities greater than 10⁹ cells/cm³ and cells smaller than 10 μm. One of the critical steps in the continuous production of microcellular plastics is the promotion of high cell nucleation rates in a flowing polymer matrix. These high nucleation rates can be achieved by first forming a polymer/gas solution followed by rapidly decreasing the solubility of gas in the polymer. Since, in the processing range of interest, the gas solubility in the polymer decreases as the pressure decreases, a rapid pressure drop element, consisting of a nozzle, has been employed as a continuous microcellular nucleation device. In this paper, the effects of the pressure drop rate on the nucleation of cells and the cell density are discussed. The experimental results indicate that both the magnitude and the cell density are discussed. The experimental results indicate that both the magnitude and the rate of pressure drop play a strong role in microcellular processing. The pressure phenomenon affects the thermodynamic instability induced in the polymer/gas solution and the competition between cell nucleation and growth.     

Wave propagation by the passage of two high-speed trains in a tunnel

A numerical simulation of unsteady compressible flow induced by two high-speed trains in oncoming traffic within a tunnel is presented. The computations were carried out by means of a second-order accurate Harten-Yee type upwind TVD scheme. In order to take the effect of friction into account, a source term is included in the governing flow equations. In the computation, moving boundary configurations were used to simulate the two trains passing through the tunnel. As geometrical configuration, the Einmalberg tunnel, where experimental data are available, was selected. The computational results agree reasonably well with their experimental counter-part. The waves interaction and the waves propagation process at the tunnel entrance and exit as well as within the tunnel are addressed. Finally, the influence on the transmitted waves at the tunnel exit portal and the variation of the negative pressure drop during the passage of the two trains are discussed.     

液相添加剂对PTCR陶瓷电性能的影响

液相添加剂ＡＳＴ（Ａｌ２Ｏ３＋ＳｉＯ２＋ＴｉＯ２）对ＢａＴｉＯ３陶瓷材料电性能的影响很大，随着Ａｌ２Ｏ３含量的增加，材料的电性能降低；ＳｉＯ２、ＴｉＯ２的物理特性对材料电性能影响较大；过量ＴｉＯ２对材料ＰＴＣ效应有重要影响，适当过量ＴｉＯ２含量，可得到性能优良的ＰＴＣＲ陶瓷。     

制革用水乳型聚氨酯涂饰剂行业标准的制定

本文概述了制定该标准的背景，对标准的主要内容加以科学的阐述。     

石材成型爆破开采方法简介

本文介绍了一些国内原有的及近年来发展的用于石材开采的成型爆破方法,简单扼要地阐明了这些方法的原理、装药结构及主要特点,对全面认识及合理选择这些方法有一定帮助。     

Multiple respiratory gas monitoring causes changes of inspired oxygen concentration in closed anesthesia system

This case report describes an accessory hepatic duct (AHD) identified by intraoperative cholangiography during excisional surgery of a choledochal cyst (CC). The accessory duct was divided and reconstructed successfully to the Roux-en-Y jejunal loop. The postoperative course was uneventful, and follow-up abdominal sonography revealed neither evidence of biliary tract obstruction nor atrophic changes of the liver. It is advocated that an AHD should be meticulously reconstructed if it is divided during excisional surgery of a CC.     

氧化还原功能纤维的研究 Ⅷ．含正丙胺基吸附剂与Au~（3＋）的氧化还原反应机理

通过元素分析、红外光谱分析、光电子能谱分析以及扫描电子显微镜分析等手段，证实含正丙胺基吸附剂与Ａｕ３＋的氧化还原反应过程中，氮原子邻近的羟基碳或Ｃ－Ｈ键被氧化，而氮原子并未参与氧化还原反应；吸附态Ａｕ（３＋）最终部分被还原成单质金；在非水介质中吸附在吸附剂上的金聚集成颗粒状。     

An improved method for magnetic identification and localization of cracks in conductors

A SQUID magnetometer can be used to measure the magnetic field produced by flaws in a two-dimensional, conducting plate carrying a current. Identification of the flaw-induced magnetic field is difficult because of the large magnetic field associated with the edges of the plate and the current in the leads that connect the plate to the power supply. We have developed a technique by which the wire and edge fields can be cancelled prior to mapping the magnetic field. In this technique, a similar unflawed conducting sheet is placed adjacent to the flawed plate, with a connection between the sheet and the plate at one edge, and with the opposite edges of the sheet and of the plate connected to the two conductors of a coaxial cable. Thus, an applied current will flow along one conductor of the cable, across the cancelling sheet, cross into the flawed plate, return along the plate, and then return to the power supply along the other conductor of the coaxial cable. As a result of this geometry, there is no magnetic field from the lead-in wires because they are coaxial, and the magnetic field due to the edges of the plate is cancelled by the opposing magnetic field of the edges in the adjacent sheet. The extent of cancellation is determined primarily by the separation between the plate and the cancelling sheet, by the thickness of the plate, and by macroscopic inhomogeneities in their electrical conductivities.