ULTRA‐FINE TRACKING CONTROL ON PIEZOELECTRIC ACTUATED MOTION STAGE USING PIEZOELECTRIC HYSTERETIC MODEL

The tracking control accuracy of the piezoelectric actuator (PEA) is limited due to its inherent hysteresis nonlinearity. A new piezoelectric‐actuator model is synthesized based on two first‐order transfer systems in parallel with two tuned parameters determined from one experiment. Two open‐loop tracking controllers are implemented with the proposed model to compensate the hysteresis of linear positioning. Numerical simulations and experimental tests on the tracking of sinusoidal and triangular waveforms with signal frequencies ranging from 1Hz to 30 Hz are revisited and compared with the conventional Bouc‐Wen and Duhem models. Experimental results reveal that the RMS tracking error can be reduced to less than 2% of the maximum traveling distance without any feedback sensor. When a piezoelectric actuated on a two Degree‐Of‐Freedom (DOF) monolithic motion stage was employed, the RMS tracking error was 50 nm within the measured sensor accuracy.     

A Novel Human Neutralizing mAb Recognizes Delta,Gamma and Omicron Variants of SARS-CoV-2 and Can Be Used in Combination with Sotrovimab

The dramatic experience with SARS-CoV-2 has alerted the scientific community to be ready to face new epidemics/pandemics caused by new variants. Among the therapies against the pandemic SARS-CoV-2 virus, monoclonal Antibodies (mAbs) targeting the Spike glycoprotein have represented good drugs to interfere in the Spike/ Angiotensin Converting Enzyme-2 (ACE-2) interaction, preventing virus cell entry and subsequent infection, especially in patients with a defective immune system. We obtained, by an innovative phage display selection strategy, specific binders recognizing different epitopes of Spike. The novel human antibodies specifically bind to Spike-Receptor Binding Domain (RBD) in a nanomolar range and interfere in the interaction of Spike with the ACE-2 receptor. We report here that one of these mAbs, named D3, shows neutralizing activity for virus infection in cell cultures by different SARS-CoV-2 variants and retains the ability to recognize the Omicron-derived recombinant RBD differently from the antibodies Casirivimab or Imdevimab. Since anti-Spike mAbs, used individually, might be unable to block the virus cell entry especially in the case of resistant variants, we investigated the possibility to combine D3 with the antibody in clinical use Sotrovimab, and we found that they recognize distinct epitopes and show additive inhibitory effects on the interaction of Omicron-RBD with ACE-2 receptor. Thus, we propose to exploit these mAbs in combinatorial treatments to enhance their potential for both diagnostic and therapeutic applications in the current and future pandemic waves of coronavirus.     

Fascial Innervation: A Systematic Review of the Literature

Currently, myofascial pain has become one of the main problems in healthcare systems. Research into its causes and the structures related to it may help to improve its management. Until some years ago, all the studies were focused on muscle alterations, as trigger points, but recently, fasciae are starting to be considered a new, possible source of pain. This systematic review has been conducted for the purpose of analyze the current evidence of the muscular/deep fasciae innervation from a histological and/or immunohistochemical point of view. A literature search published between 2000 and 2021 was made in PubMed and Google Scholar. Search terms included a combination of fascia, innervation, immunohistochemical, and different immunohistochemical markers. Of the 23 total studies included in the review, five studies were performed in rats, four in mice, two in horses, ten in humans, and two in both humans and rats. There were a great variety of immunohistochemical markers used to detect the innervation of the fasciae; the most used were Protein Gene Marker 9.5 (used in twelve studies), Calcitonin Gene-Related Peptide (ten studies), S100 (ten studies), substance P (seven studies), and tyrosine hydroxylase (six studies). Various areas have been studied, with the thoracolumbar fascia being the most observed. Besides, the papers highlighted diversity in the density and type of innervation in the various fasciae, going from free nerve endings to Pacini and Ruffini corpuscles. Finally, it has been observed that the innervation is increased in the pathological fasciae. From this review, it is evident that fasciae are well innerved, their innervation have a particular distribution and precise localization and is composed especially by proprioceptors and nociceptors, the latter being more numerous in pathological situations. This could contribute to a better comprehension and management of pain.     

Studied on a novel human keratinocyte membrane delivery system in vitro

The culture of keratinocytes on flexible membranes has been proposed as a means to simplify, accelerate and improve the efficiency with which proliferating cells are delivered to full thickness or non-healing skin defects. The purpose of this article was to study the ability of chitosan-gelatin manbranes to facilitate the growth of human keratinocytes. The membranes with different chitosan contents were studied. The surface properties of chitosan-gelatin membranes were investigate by SEM, and water contact angle test. The mechanical property of the membranes was tested. Data implied that gelatin could make the membranes more flexible and hydrophilic than chitosan membranes, which may regulate the seeded cells behavior. Loading human keratinocytes on chitosan-gelatin membranes, cells attachment, spread, and growth were investigated by light microscopy, SEM, and MTT test. The results suggested that the adhesion and proliferation of keratinocytes seeded on chitosan-gelatin membranes were same as on tissue culture plate, in which gelatin could modify the interaction between keratinocytes and chitosan membranes. Therefore, chitosan-gelatin membrane is a good candidate for keratinocytes delivery system.     

矩形波冲击时瓦楞纸板衬垫破损边界曲线的研究

根据瓦楞纸板平压静态模型,建立了动力学方程.通过数值计算方法,研究瓦楞纸板在矩形波激励下的冲击响应,并讨论各参数对瓦楞纸板包装系统的冲击谱和破损边界的影响规律.     

Development and Characterization of a Factor V-Deficient CRISPR Cell Model for the Correction of Mutations

Factor V deficiency, an ultra-rare congenital coagulopathy, is characterized by bleeding episodes that may be more or less intense as a function of the levels of coagulation factor activity present in plasma. Fresh-frozen plasma, often used to treat patients with factor V deficiency, is a scarcely effective palliative therapy with no specificity to the disease. CRISPR/Cas9-mediated gene editing, following precise deletion by non-homologous end-joining, has proven to be highly effective for modeling on a HepG2 cell line a mutation similar to the one detected in the factor V-deficient patient analyzed in this study, thus simulating the pathological phenotype. Additional CRISPR/Cas9-driven non-homologous end-joining precision deletion steps allowed correction of 41% of the factor V gene mutated cells, giving rise to a newly developed functional protein. Taking into account the plasma concentrations corresponding to the different levels of severity of factor V deficiency, it may be argued that the correction achieved in this study could, in ideal conditions, be sufficient to turn a severe phenotype into a mild or asymptomatic one.     

Preparation of Trimethylsilyl Derivatives of Polysaccharides

Trimethylsilyl derivatives of starch, amylose, amylopectin, and glycogen have been prepared by using hexamethyldisilazane as the silylating reagent and formamide as solvent. The degree of silylation ranged from 0.9 to 2.2 and is believed to be dependent on the structure and solubility of the polysaccharide. An important property of these trimethylsilyl derivatives is their complete solubility in common organic solvents like benzene, toluene, chloroform, etc.     

Modeling Self-Rollable Elastomeric Films for Building Bioinspired Hierarchical 3D Structures

In this work, an innovative model is proposed as a design tool to predict both the inner and outer radii in rolled structures based on polydimethylsiloxane bilayers. The model represents an improvement of Timoshenko’s formula taking into account the friction arising from contacts between layers arising from rolling by more than one turn, hence broadening its application field towards materials based on elastomeric bilayers capable of large deformations. The fabricated structures were also provided with surface topographical features that would make them potentially usable in different application scenarios, including cell/tissue engineering ones. The bilayer design parameters were varied, such as the initial strain (from 20 to 60%) and the bilayer thickness (from 373 to 93 µm). The model matched experimental data on the inner and outer radii nicely, especially when a high friction condition was implemented in the model, particularly reducing the error below 2% for the outer diameter while varying the strain. The model outperformed the current literature, where self-penetration is not excluded, and a single value of the radius of spontaneous rolling is used to describe multiple rolls. A complex 3D bioinspired hierarchical elastomeric microstructure made of seven spirals arranged like a hexagon inscribed in a circumference, similar to typical biological architectures (e.g., myofibrils within a sarcolemma), was also developed. In this case also, the model effectively predicted the spirals’ features (error smaller than 18%), opening interesting application scenarios in the modeling and fabrication of bioinspired materials.